AEG 10057 - Installation Manual

Bushwacker only approves installing the fl ares according to these
written instructions with the hardware provided. WARNING: Failure to
install according to these instructions will invalidate the warranty. This
includes, but is not limited to using alternative installation methods,
hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar
products on the hardware or the fl ares.

Fit:

Verify the fi t of the fl ares to vehicle. (Some fi ling, sanding, or

cutting may be necessary to ensure proper fi t).

Painting:

(Optional) if paint is desired it must be done prior to installing

fl ares on vehicle. Clean outer surface with a good grade degreaser.
DO NOT USE LACQUER THINNER OR ENAMEL REDUCER AS A
DEGREASER. Wipe outer surface thoroughly with a tack rag prior to
paint. Application of plastic adhesion promoter for ABS plastic as per
your paint system manufacturer’s recommendations is required. Paint
fl ares using a high quality enamel, or polyurethane automotive paint. If
painting edge trim (not recommended), use a fl ex additive.

Performance:

Using larger Tires may increase the area required to

turn the vehicle. Some Tire/Rim combinations may require lowering
bump stops and or installing steering stops to prevent tire from
contacting fl are.

Exhaust System:

Modifi cations may be necessary to maintain a

minimum 4” clearance between fl ares and exhaust pipes. (Exhaust
gases should not vent directly onto fl ares)

Metal Protection:

All exposed fasteners and bare metal should be

treated with rust resistant paint BEFORE installing fl ares. Spray inner
fender wells with undercoating AFTER fl are attachments have been
completed.

Decals:

Flares may interfere with existing decals on vehicle. If you

wish, remove decals prior to installation of fl ares.

Care & Cleaning:

Bushwacker fender fl ares are built to last; any

detergent you use to wash your vehicle is suffi cient to clean the fl are.
Do not use any harsh abrasive detergents.

STEP 1 – PRIOR TO INSTALLATION

A)

B)

C)

D)

E)

F)

G)

H)

112 inches

Jeep

®

Cut-Out

™

Front Part #10057-07
Rev-3 1/26/2016

• Drill
• 3/16” Drill Bit
• #2 Phillips Bit
• 5/16” Wrench
• 5/16” Socket
• 7/16” Wrench
• 7/16’ Socket
• Socket Driver
• Scissors
• T45 Torx Bit
• Air Nibbler or Reciprocating Saw

• To claim a warranty, you must provide
Proof of Purchase.

LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS

TOOLS FOR EASY INSTALLATION:

Included in Hardware Kit:

2.

24 pcs

4 pcs

12 pcs

1 pc

1.

3.

4.

5.

Front Pair

For complete fi tment info visit : www.bushwacker.com

Fender Flares

PLEASE READ:

Dirt and debris can become lodged

between the fender fl ares and the vehicle’s fenders,
causing scratching and paint wear from vibration.
Lund International is not responsible for any damage,
and the installation of our fender fl ares is done with
the buyer’s understanding that this scratching and
paint wear may occur.

4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX 800-438-37881

1