3M TM - Manual
3M TM – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – EVM and User Interface; Turning On/Off and Navigating; Navigating to menu options - press keys.; Start Screen and Measurement Views; and file system screens.
- Page 3 – Overview of running measurements; have sufficient memory space.; DMS; Place the EVM in a specific location for area monitoring.; Particulate Measurements; Particulate setup; Particulate; fields (displays accumulated mass; Adjusting the Impactor
- Page 4 – Particulate Zero Calibration; filter and tubing into the turret. Rotate the turret to PM.; Particulate Advanced Calibration (Gravimetric); Gravimetric Calibration Overview; Logging Particulates; Zero/HEPA filter example
- Page 5 – NOTE: in order to measure; Logging VOCs
- Page 6 – Toxic and Carbon Dioxide Zero Calibration
- Page 7 – Toxic and Carbon Dioxide Span Calibration; selected full scale range of the gas.; Span; softkey in; Logging Toxic Gases or Carbon Dioxide; From the Start screen or any Measurement screen, press key.; Particulate advanced calibration (Gravimetric filtering); Measuring particulates
- Page 8 – Temperature and Relative Humidity; Logging/Viewing Temperature and/or Relative Humidity; measurement screen or in the Composite screen.; Particulate Air Flow; Calibration; Cal; softkey and then press; Start; calibrator is 1.67 LPM and then confirm by pressing the; Save
- Page 9 – Air Velocity; field and press the
- Page 10 – Sensors Locations; the sensors which will require removing and inserting.; Impactor Care and Particulates; very thin film; of silicone grease onto the metal plates using a Q-tip/cotton.; silicone; is applied to a
- Page 11 – Working with 3M; Detection Management Software DMS; Communicating; On; , plug the USB cable into the EVM and plug the opposite end; Viewing your data; In DMS once your files are downloaded via
3M Personal Safety Division
3M
TM
EVM Series Environmental Monitor
EVM Series
Quick Start Guide
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
EVM and User Interface Display Backlight Particulate pump Left arrow key Run/Stop key Indicators Softkey menus Up arrow key Altf key Enter key Right arrow keyDown arrow key On/Off and Esc key Turning On/Off and Navigating 1. Press key power on. (Following a splash/welcome screen, the Start screen wi...
Overview of running measurements Quick Help List: typical gas, particulates,or air quality measuring overview 1. Turn the EVM on and check the battery power. 2. Reset/Clear memory, if necessary ( Start\File System menu). • This will clear out data history before your logging begins to ensure you hav...
Particulate Zero Calibration Prior to calibrating, ensure the impactors are well-greased with an applied thin-film of silicone grease. (Please see “Impactor Care” on page 10 or EVM series user manual.)1. Attach the Zero/HEPA filter and tubing into the turret. Rotate the turret to PM. 2. Select Calib...
