Page 4 - TABLE OF CONTENTS
TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS 1 PRODUCT DIMENSIONS AND SPECIFICATIONS 3 GAS SUPPLY 5 POWER RATING & ELECTRICAL CONNECTION 10 GAS CONNECTION 11 GAS CONVERSION PROCEDURE 13 INSTALLATION CHECKLIST 18 DROPIN COOKING 19 MAINTAINING THE DROPIN 22 TROUBLESHOOTING 23 WARRANTY 24
Page 5 - IMPORTANT SAFETY INSTRUCTIONS
1 Gener al Safet y IMPORTANT SAFETY INSTRUCTIONS WARNING If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or death. • Before beginning installation, please read and follow these important instructions for the safety o...
Page 6 - Gas Safet
2 Gas Safet y IMPORTANT SAFETY INSTRUCTIONS WARNING An air curtain or other overhead range/range top hood, which operates by blowing downward airflow onto the dropin, shall not be used/installed in conjunction with this gas dropin. • Please ensure that the altitude of your home is conducive for the ...
Page 7 - Installation R; BEFORE INSTALLATION
3 3 7/16” 30“ 21“ 3 7/16” 36“ 21“ Figure 1 Figure 3 Figure 2 Figure 1 Refer to Figure 1 Clearances A B D E F 30” 6” min 6” min 3 1/2” min 30” 3 1/2” min 36” 6 min” 6” min 3 1/2” min 36” 3 1/2” min Refer to Figure 2 Product size A B C D H1 H2 30” 30” 21” 28 3/8” 18 7/8” 2 13/16” 5/8” 36” 36” 21” 34 3...
Page 8 - Scan to follow along with a video.; Installing th; INSTALLATION
4 ATTACHING THE DROPIN Be sure to carefully consider the critical dimensions of the appliance before making an opening in the top surface of your countertop. To prevent liquids from accidentally leaking into the underlying storage space, the appliance is equipped with special adhesive sealing strips...
Page 9 - Gas Supply; Pressure Regulator
5 Gas Supply INSTALLATION • This appliance shall only be installed by an authorized professional.• If local codes permit, a flexible metal appliance connection with the new AGA or CGA certified design, 3/4˝, is recommended for connecting this appliance to the gas supply line. DO NOT bend or damage t...
Page 11 - Gas Connection
7 Gas Connection INSTALLATION GAS CONNECTION • All gas connections must comply with national and local codes. The gas supply line (service) must be the same size or greater than the inlet line of the appliance. This dropin uses a 1/2˝ NPT inlet. Use appropriate sealant on all pipe joints that are re...
Page 12 - Figure 2; Figure 1
8 Gas Connection For gas inlet position of the appliance refer to Figures 1 and 2. After installing the gas supply and making all connections check thoroughly for possible leaks. Turn all control knobs on the unit to ‘OFF’ position. Open the valve on the gas supply. Using a soap and water solution c...
Page 13 - • Disconnect electric power before checking pressure.
9 Gas Connection INSTALLATION • To check inlet pressure of the appliance: • Disconnect electric power before checking pressure. • Take off one of the gas burner caps and the relative flame spreader in order to get access to the burner injector. • Place the pressure detector directly on the burner in...
Page 14 - Electrical Connection; ELECTRIC POWER RATING
10 INSTALLATION Electrical Connection The appliance shall be connected to a single phase electric line rated at 110-120VAC and 60HZ frequency. The true voltage in most homes is usually within this rating. ELECTRIC POWER RATING 120V / 60HZ / 15A ELECTRICAL GROUNDING Our gas dropin is equipped with a ...
Page 16 - PRESSURE REGULATOR
12 Gas Connection INSTALLATION PRESSURE REGULATOR Since service pressure may fluctuate with local demand, every gas cooking appliance must be equipped with a pressure regulator on the incoming service line for safe and efficient operation. • Pressure Regulator The pressure regulator shipped with the...
Page 19 - Gas Conversion Procedure
15 Gas Conver sion Pr ocedur e INSTALLATION STEP 1: PRESSURE REGULATOR The pressure regulator supplied with the appliance is a convertible type pressure regulator for use with natural gas at a nominal outlet pressure of 4˝ W.C. or liquid propane gas at a nominal outlet pressure of 10” W.C. and it is...
Page 20 - STEP 2: SURFACE BURNERS
16 Gas Conver sion Pr ocedur e INSTALLATION STEP 2: SURFACE BURNERS 1. To replace the orifices of the surface burners, lift up the burners and unscrew the orifices shipped with the dropin using a 7 mm socket wrench. 2. Replace orifices using the conversion set supplied with the dropin. Each orifice ...
Page 23 - Room V
19 INSTALLATION Room V entilation ROOM VENTILATION The use of a gas cooking appliance generates heat and humidity in the room where it is installed. Proper ventilation in the room is needed. Make sure the kitchen is equipped with a range hood of appropriate power (400 CFM minimum) installed appropri...
Page 24 - OPERATION; Dr
20 OPERATION Dr opin Cooking SURFACE BURNER OPERATION - ELECTRIC IGNITION To activate the electric ignition, simply push the knob in to activate the spark. While still pushing the knob in, turn the control knob counter-clockwise to release the gas. The spark will be released at the metal electrode o...
Page 25 - Maximum Flame Height; Ensure good ventilation of the room, keep adequate natural; Control knobs on the gas burners; The knobs for the gas burners of the cooker are found on the control; NOTE -When first used, the gas burner will not ignite immediately.; USE GUIDE; NOTE; Minimum Flame Height
21 OPERATION Dr opin Cooking Be sure to set all dropin burner controls to the OFF position after each use of the appliance. Maximum Flame Height USE GUIDE • Ensure good ventilation of the room, keep adequate natural ventilation or install an extractor hood with a discharge tube. • In case of doubt a...
Page 26 - MAINTENANCE AND CLEANING; Maintaining th
22 MAINTENANCE AND CLEANING Maintaining th e Dropin CLEANING YOUR DROPIN During cleaning, never move the appliance from its original installation position. Never use abrasive cleaners. Scratches on the stainless steel surfaces are permanent. Do NOT clean the dropin when hot. Do not use Clorox bleach...
Page 27 - TROUBLESHOOTING; DROPIN PROBLEM
23 Tr oublesh ooting TROUBLESHOOTING DROPIN PROBLEM POSSIBLE CAUSE AND/OR REMEDY Dropin does not function Dropin is not connected to electrical power. Check power circuit breaker, wiring, and fuses. If all electrical components are properly installed, call 1-614-777-5004 for help. Burner does not ig...
Page 28 - WARRANTY
COVERAGE ZLINE Kitchen and Bath dropin products will be warrantied for one year from the original purchase date for the original purchaser of the product. This warranty covers all parts and labor for necessary repairs if any part of the product proves to be defective in materials or workmanship. The...
