Zephyr ATI-M90ABX - Manual

www.zephyronline.com NOTE! The device in this version (with internal suction motor) is equipped for rear discharge of exhaust air. However, if required, it is possible to have the exhaust air discharged from the top. This can be accomplished by following the steps indicated in the following paragrap...

Installa tion - In ternal Blo w e r 6. Remove the 6” round metal knockout pla- te from the blower plate by using a fl at head screwdriver. See. Fig.4 7. Remove the (10 ) screws securing the blo- wer plate to the blower housing and remo-ve blower plate. See. Fig.5 (Note! If air is discharged from the...

www.zephyronline.com Installa tion - In ternal Blo w e r 13. Secure Green/Yellow ground wire connected to the cable to the provided capacitor to blower plate. (type A) Fig. 11 14. Attach the 6 pin male molex connector from blower wire to the 6 pin female molex connector located inside the blower hou...

Installa tion - Ex ternal & In-Line Blo w er P repar a tion NOTE! The device in this version (with external motor) is equipped for rear discharge of exhaust air. However, if required, it is possible to have the exhaust air discharged from the top. This can be accomplished by carrying out the ste...

Note : Carry out the power supplly con- nection in accordance with the national electric code, ANSI/NFPA 70-1999. Note1 : A cable lock (not included) may be required by local codes. Please review lo-cal codes for more information. 12. Attach 6 pin male molex connectors to 6 pin female molex connecto...

www.zephyronline.com WARNING FIRE HAZARD NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside, unless using the recirculating op-tion. Use single wall rigid Metal ductwork only. Fasten all connections ...

Installa tion - Moun ting the R ange Hood MOUNTING HEIGHTS The range hood must be installed at a minimum height of 22 inches (56 cm) from the cooking surface. If a connecting duct work composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the range hood ...

Installa tion - P o w er Supply C onnec tion GENERAL • Carefully read the following important information regarding installationsafety and maintenance. Keep this information booklet accessible for furtherconsultations. POWER SUPPLY CONNECTION For connection to the power supply refer to the following...

www.zephyronline.com Main tencanc e MAINTENANCE • It is recommended to operate the appliance prior to cooking. It is recommended to leave the appliance in operation for 5 minutes after cooking is completed in order to completely eliminate cooking vapors and odors. The proper function of the range ho...

List of P a rts and A cc essories DESCRIPTION HOOD PART# REPLACEMENT PARTS Light Bulb GU5, 20W (each) ATI Z0B0031 OPTIONAL ACCESSORIES Recirculating Kit ATI ZRC-00HZ Replacement Charcoal Filters ATI Z0F-00AC Short Duct Cover (8”-9” ceiling) ATI Z1C-00TI Long Duct Cover (9”-10” ceiling) ATI Z1C-01TI ...