Zephyr 700 - Manuals - manualsarea.com

Page 2 - Thank you for using our equipment.; Please pack a note in with the; Our Limited Warranty

Thank you for using our equipment. We will do our best to earn your continuing confidence in Zephyrus and our products. Any time you need information or help, give us acall at 918-437-3333 (US). thankyou.sam We make quality affordable It's a good idea to look the equipment over forany shipping damag...

Page 3 - Table of Contents; ZEPHYRUS ELECTRONICS, LTD

OPERATING THE ZEPHYRUS 700 SERIES SCPC SATELLITE RECEIVER Table of Contents SECTION 1 General Information -An overview and summary description of the system describing features and design philosophy.-System specifications and typical operating criteria. SECTION 2 Front Panel Layout and Operation -Me...

Page 4 - Operating the Zephyrus 700 Series; General information

The 700 receiver system is contained in a 3½" frameand features microcomputer electronics that controland monitor operation of either one or two receivermodules and the LNB. Primary power is normally117 vac with 240 volt units available. Rack mountingis optional. v Input signal to the receiver i...

Page 5 - Zephyrus 700 SCPC Satellite Receiver

Zephyrus 700 SCPC Satellite Receiver Specifications and Typical Operating Criteria PHYSICAL: General: Front panel is sloped back for easy viewing and data entry.Analog meters for signal values. Keypad entry tuning. IlluminatedLCD readout of frequencies and operating status. Audio levelcontrols on fr...

Page 6 - 00 Front Panel Operation; must be entered

700 Front Panel Operation Refer to illustration in Section 1 The 700 is flexible, easy to operate, and provides you with the information neededto tell what's "going on." The RELATIVE RF meter actually indicates the amount of limiting taking place in the CARRIER 1 IF/Demod section. The adjust...

Page 8 - Installation of the 700 Receiver system; INPUT SIGNAL

Installation of the 700 Receiver system We assume your dish has been mounted and installed correctly and that you know how to make polarization and position adjustments. INPUT SIGNAL to the 700 is via the F connector labeled LNB 950-1450 MHZ. This signal must be supplied from an LNB or block-convert...

Page 9 - : RG-59 cable is usually OK for runs up to 125 to 150 feet. Longer

audio. Program audio that has no popping or static noise, but which is distorted (or isthe wrong level) does not come from the above areas. Distortion problems come fromaudio processing circuits. This can be in the transmission processing, or the receiverdemod and audio circuits. BACK INDOORS When y...

Page 10 - System Operation and Customization

System Operation and Customization The 700 Series SCPC system can be assembled in a large variety of configurations to meet specific requirements. COMPONENTS to make up a 700 system consist of the following: 1: Basic chassis/case which contains power supply, microcomputer control, and a complete fro...

Page 12 - Figure 1; Channel 1 Receiver Board

System Operation MA700SYS.SAM SECTION 43 Figure 1 Channel 1 Receiver Board (Channel 2 is similar but less tuner)

Page 13 - Figure 2; 00 Receiver Back Panel

MA700SYX.SAM Figure 2 700 Receiver Back Panel SECTION 4, PAGE 4