Zephyr ASU - E42ASX - Manual

Page 4 - READ AND SAVE THESE INSTRUCTIONS; fe

www.zephyronline.com IMPORTANT SAFETY INSTRUCTIONS FOR RESIDENTIAL USE ONLY READ AND SAVE THESE INSTRUCTIONS PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. IMPORTANT : Save these Instructions for the Local Electrical Inspectors use. INSTALLER : Please leave these Instructions with this unit for ...

Page 7 - TYPE

Models: ALA-M90ABX / ALA-M90AWX / ALA-E42ABX / ALA-E42AWX Duct Covers Electrical Junction Box Duct Cover Bracket Glass Light Bulbs Decorative Mesh Filters Range Hood Body List of Ma terials TYPE DESCRIPTION N° A M4 1 + 1 B 1/8" x 1/4" 12 C 1/8" x 2/4" 4 D 1/4" x 2-3/4" 6 Blow...

Page 12 - Hood Specifi

www.zephyronline.com front of hood side of hood top of hood Models: ALA-M90ABX / ALA-M90AWX / ALA-E42ABX / ALA-E42AWX Hood Specifi ca tions - 12 -

Page 14 - front of hood

www.zephyronline.com Models: AED-M90ASX 35-3/8" 11-1/4" 12-1/16" 10-1/16" 19-11/16" Wood Trim Dimensions 5/8" Thickness Hood Specifi ca tions front of hood side of hood top of hood - 14 -

Page 16 - Remove the 6” round metal knockout

www.zephyronline.com Installa tion - In ternal Blo w e r The following instructions are for installing the internal blower. CAUTION: To reduce the risk of fi re and electric shock, install this range-hood only with internal blower models MT-020 provided with the kit cod CBI-600A. For external and in...

Page 17 - The hood is now ready to be installed on the wall.; Installa

6. Attach the 6 pin male molex connector from blower wire to the 6 pin female molex connector located inside the blower housing. See Fig.6 7. Install blower and blower plate into blower housing by following the reverse instructions from step 2 then use the screws provided to complete installa-tion. ...

Page 19 - Note; Attach 6 pin male molex connectors to 6 pin fe-

6. Insert the 6 pin female molex connector into the junction box. See Fig. 6A. Secure remote blower junction box to top of blower housing using (2) screws. See Fig. 6B 7. Feed remote blower wire harness through remote blower junction box cover and Connect the wires with those inside the junction box...

Page 20 - WARNING FIRE HAZARD; Use single wall rigid Metal ductwork only.

www.zephyronline.com WARNING FIRE HAZARD NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside, unless using the recirculating op-tion. Use single wall rigid Metal ductwork only. Fasten all connections ...

Page 21 - MOUNTING HEIGHTS; Place the paper template included with your

Installa tion - Moun ting the R ange Hood MOUNTING HEIGHTS The range hood must be installed at a minimum height of 24 inches (61cm) from the cooking surface. If a connecting duct work composed of two parts is used, the upper part must be placed outside the lower part. Do not connect the range hood d...

Page 23 - MOUNTING THE DUCT COVER

MOUNTING THE DUCT COVER Models: ALA-M90ABX / ALA-M90AWX / ALA-E42ABX / ALA-E42AWX / AED-M90ASX / ADU-M90ASX 1. Install the electrical wiring and test hood for functions prior to installing the duct covers. 2. If using hood in air recirculating mode make sure to install the air diverter plate prior t...

Page 25 - MAINTENANCE

Main tencanc e MAINTENANCE • It is recommended to operate the appliance prior to cooking. It is recommended to leave the appliance in operation for 5 minutes after cooking is completed in order to completely eliminate cooking vapors and odors. The proper function of the range hood is conditioned by ...

Page 26 - DESCRIPTION

www.zephyronline.com List of P a rts and A cc essories DESCRIPTION HOOD PART# REPLACEMENT PARTS Light Bulb GU4, 20W (each) ALA, ASU Z0B0030 Light Bulb G4, 20W (each) ADU, AED Z0B0013 OPTIONAL ACCESSORIES Recirculating Kit ALA, ADU, AED ZRC-00LA Recirculating Kit ASU ZRC-00SU Replacement Charcoal Fil...

Zephyr ASU - E42ASX - Manual

Table of Contents:

Summary

Other Zephyr Models