Zebra ZT400 - Manual
Zebra ZT400 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Control Panel; Figure 2; Figure 2 • Control Panel; User Guide
- Page 3 – Preparing the Printer for Use; To set up the printer, complete these steps:; Select a location for the printer that meets these conditions:; Caution •; Caution •
- Page 4 – Internal wired Ethernet print server
- Page 5 – Raise the media door.
- Page 6 – CANCEL
- Page 7 – and operate it in
- Page 8 – Load Media and Ribbon; not load ribbon in the; To load ribbon and roll media in Tear-Off mode, complete these steps:; Load Media; Note •; give you a better view of the components involved in media loading.; The printhead may be hot and could cause severe burns. Allow the; Open the printhead assembly by rotating the printhead-open lever.
- Page 9 – Pull out the media supply guide as far as it goes.
- Page 10 – Slide the media guide all the way out.
- Page 11 – From the media hanger (
- Page 12 – PAUSE; Load Ribbon
- Page 14 – Push down the printhead assembly (; to clear any errors and enable printing.
- Page 15 – Remove Used Ribbon; To remove used ribbon, complete these steps:; Then; Do not cut the ribbon directly on the ribbon
© 2014 ZIH Corp. All product names and numbers are Zebra
trademarks, and Zebra and the Zebra logo are registered
trademarks of ZIH Corp. All rights reserved.
P1060608-003
4/8/14
ZT400™ Series Quick Reference Guide
Use this guide to operate your printer on a daily basis. For more detailed information, refer to
the
User Guide
.
Printer Components
shows the components inside the media compartment of your printer. Depending on
printer model and the installed options, your printer may look slightly different. Familiarize
yourself with these components before continuing with the printer setup procedure.
Figure 1 • Printer Components
1
Media door
6
Printhead-open lever
2
Printhead pressure adjustment toggles
7
Ribbon take-up spindle
3
Control panel
8
Ribbon supply spindle
4
USB host port
9
Media supply hanger
5
Printhead assembly
10
Media supply guide
1
3
4
2
10
9
8
7
6
5
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Control Panel 2 P1060608-003 ZT400™ Series Quick Reference Guide 4/8/14 Control Panel The control panel ( Figure 2 ) indicates the printer’s current status and allows the user to control basic printer operation. 6 13 12 9 8 11 10 1 2 3 4 5 14 15 16 Figure 2 • Control Panel 7 1 STATUS light These ind...
3 Preparing the Printer for Use 4/8/14 ZT400™ Series Quick Reference Guide P1060608-003 Preparing the Printer for Use After you have familiarized yourself with the printer components, prepare the printer for use. To set up the printer, complete these steps: 1. Select a location for the printer that ...
Preparing the Printer for Use 4 P1060608-003 ZT400™ Series Quick Reference Guide 4/8/14 5. Plug the male end of the A/C power cord into an appropriate power outlet. 6. Connect the printer to a computer using one or more of the available connections. The standard connections are shown here. A paralle...
