Yamaha yfm 350 - Manual
Yamaha yfm 350 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
INSTRUCTION SUPPLEMENT FOR 1987-
LATER YAMAHA YFM350 WARRIOR
Removing stock c arburetor and c able s.
1.
Remove se at a n d g as ta nk.
Ma k e sure fuel
petcoc k is in “off” position.
2. Remove throttle ca ble p aying close a tte n tio n
to rou tin g , as th e n ew ca ble(s) will ne e d to o
b e ro ute d th e same .
3. Remove stock carb uretor a n d stock throttle
h o using .
Pr eparing motor for c arburetor install
1. Remove stock ma nifold from cylind er h e a d .
2. Place su p plied o’ring into alumin um fla n g e
as pictured in fig ure 1.
Figure 1.
3. Install aluminum a n d ru b b er fla n g e to mo tor
using su p plied b olts. Se e Fig ure 2. Th e
shorter 2 5mm b olt will n e e d to b e place d in
th e b ottom h ole .
IMPORTANT NOT E:
Install
th e aluminum fla n g e with th e o’ring towards
th e mo tor a n d th e thick side u p.
Figure 2.
Twist Throttle Instructions
1. Install th e throttle ca bles into th e su p plied
throttle h o using a n d place o nto cle a n
h a n dle b ar e n d .
2. Rou te throttle ca bles throu g h frame as stock
cable was route d .
3. Install th e p ull ca ble (lon g sh o uld er o n ca ble)
into th e 4 :0 0 p osition a n d th e return ca ble
e n d into th e 1:0 0 p ositio n o f th e ca ble
whe el. Secure ca bles to ca ble bracke t by
replacing e n d piece a n d Phillips screw. Se e
fig ure 3.
Figure 3.
Thumb Throttle Instructions
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
