Page 2 - The above warning is located on the bottom or rear of the unit.; Explanation of Graphical Symbols; IMPORTANT SAFETY INSTRUCTIONS; C A U T I O N; WARNING
2 En The above warning is located on the bottom or rear of the unit. Explanation of Graphical Symbols The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be o...
Page 4 - PRECAUTIONS; Power supply/power cord; • Be sure to request inspections or repairs from the
4 En PRECAUTIONS PLEASE READ CAREFULLY BEFORE USE. BE SURE TO FOLLOW THESE INSTRUCTIONS. The precautions listed below are to prevent risk of harm to the user and others, as well as to prevent property damage, and to help the user use this unit properly and safely. Be sure to follow these instruction...
Page 6 - If you notice any abnormality; CAUTION; This content indicates “risk of injury.”
6 En If you notice any abnormality • If any of the following abnormalities occur, immediately turn off the power and disconnect the power plug. - The power cord/plug is damaged.- An unusual smell or smoke is emitted from the unit.- Foreign material gets into the interior of the unit.- There is a los...
Page 7 - Handling caution; Battery use
En 7 • Before moving this unit, be sure to turn off the power switch and disconnect all connection cables. Failure to observe this may damage the cables or cause you or someone else to trip and fall. • Be sure to request that the dealer where you purchased the unit or qualified service personnel mou...
Page 8 - Notice; Installation; Maintenance
8 En Notice Indicates points that you must observe in order to prevent product failure, damage or malfunction and data loss, as well as to protect the environment. Power / power cord • If not using the unit for a long period of time, be sure to pull the power plug from the outlet. Even if the z (Pow...
Page 9 - About disposal; Information; Functions included in the unit; About the name plate of the unit
En 9 About disposal • Be sure to discard used batteries in accordance with local regulations. Information Indicates information of note regarding this product. Functions included in the unit • Air may be blown out from the bass reflex port. This is not a malfunction. This occurs particularly often w...
Page 10 - NOTICE
10 En Trademarks The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Yamaha Corporation is under license. Manufactured under license from Dolby Laboratories.Dolby, Dolby Audio, Pro Logic, and the double-D symbol are trademarks of Do...
Page 11 - Contents; Operating the unit by TV’s remote control
En 11 Contents IMPORTANT SAFETY INSTRUCTIONS ........... 2 PRECAUTIONS ................................................ 4 Supplied items ............................................. 12 Features ........................................................ 15 Frequently asked questions......................
Page 12 - Supplied items
12 En Supplied items Make sure you have received all of the following items. Center unit (YAS-CU207) Remote control A CR2025 Lithium battery has already been inserted into the remote control. Optical digital audio cable Power cable × 2 HDMI Mounting template Use when mounting the center unit on a wa...
Page 14 - Replacing the battery in the remote control
14 En Replacing the battery in the remote control Press and hold the release tab in the direction indicated by , and slide the battery holder out in the direction indicated by . A B Battery holder Release tab CR2025 Lithium battery
Page 15 - Features
En 15 Features This front surround system, comprised of the center unit and wireless subwoofer, allows you to enjoy dynamic sound with video played on your home TV. • 3D surround playback Surround sound can be heard not only from horizontal directions, but also from varying heights when DTS Virtual:...
Page 16 - Frequently asked questions; Can I use the TV’s remote control to operate the unit?
16 En Frequently asked questions The following section covers popular functions and frequently asked questions about the unit. Q1 Can I use the TV’s remote control to operate the unit? A1 Yes. When the unit is connected to a TV via HDMI cable, the TV’s remote control can be used to operate both the ...
Page 17 - Part names and functions; NOTE; Speakers
En 17 Part names and functions Center unit (front panel) 3 1 2 1 6 4 5 7 4 (input) Select an input source to be played back (p. 26). 5 (mute) Mute the audio output. Touch again to unmute (p. 28). 6 / (volume +/-) Adjust the volume (p. 28). 7 (power) Turn on or off the unit (p. 25). NOTE • The unit m...
Page 19 - Subwoofer
En 19 1 Bass reflex port 2 PAIRING button Used to pair the center unit with the subwoofer manually (p. 42). 3 STANDBY indicator Shows subwoofer’s status (p. 25). 4 indicator Glows when the center unit and subwoofer are connected wirelessly. 5 AC IN jack Connect the power cord of the subwoofer (p. 24...
Page 20 - Position the unit with the touch panel facing forward.; Mounting the unit on a wall
20 En Installation The center unit can be installed on a TV stand or mounted on a wall.Position the subwoofer to the left or right of the center unit. Angle the subwoofer slightly toward the center of the room to prevent sound from reflecting off of walls. Position the unit with the touch panel faci...
Page 21 - Mount the unit on a wall; Hang the unit on the screws.
En 21 Mount the unit on a wall 1 Attach the mounting template on a wall and mark for the screw holes. 2 Remove the mounting template from the wall, then install commercially available screws (as illustrated below) at the points marked on the wall. 3 Hang the unit on the screws. CAUTION • When mounti...
Page 22 - Connections; Connecting a TV and set-top box
22 En Connections a Connecting a TV and set-top box For the cable connection, follow the procedure below. OPTICAL OUTPUT 1 2 3 HDMI INPUT HDMI OUTPUT 1 2 1 HDMI cable (optional) The digital audio/video signals from the set-top box or BD/DVD player are input to this unit. 2 HDMI cable (optional) Digi...
Page 23 - • If volume can be adjusted on the device connected to the
En 23 NOTE Audio Return Channel (ARC) supported TV • Connect an HDMI cable to the audio return channel supported jack (the jack with “ARC” indicated) on TV. • Once the HDMI control function has been activated, video and audio content from playback devices can be output from the TV even when this uni...
Page 24 - Center unit
24 En c Connecting the power cable After all connections are complete, connect the supplied power cables to the AC IN jack on the center unit and subwoofer respectively, and plug the power cables into an AC wall outlet. d Turning on the unit Press the (power) key on the remote control or touch on th...
Page 25 - Operations; Remote control signal transmitter; Turned off
En 25 Operations Remote control signal transmitter Transmits infrared signals. (power) key Turns on or off the unit. Center unit Turned on Turned off (Bluetooth standby function enabled, p. 33) Subwoofer Turned on Off Glows Turned off Glows The indicator for the last input source selected glows. STA...
Page 26 - Input keys; TV; BLUETOOTH
26 En Input keys Select an input source to be played back. HDMI .................Sound from a device connected to the HDMI IN jack TV ......................TV audio or sound from a device connected to the unit’s TV input jack ANALOG ...........Sound from a device connected to the ANALOG input jack B...
Page 27 - SURROUND and STEREO keys; SURROUND key; CLEAR VOICE key
En 27 SURROUND and STEREO keys Switch between surround and stereo (2-channel) playback. SURROUND key The unit switches between 3D surround playback and surround playback each time the SURROUND key is pressed. When 3D surround is selected, DTS Virtual:X makes it possible to hear sound not only from h...
Page 28 - MUTE key
28 En SUBWOOFER (+/–) keys Adjust the volume of the subwoofer. NOTE • The SUBWOOFER (–) key is also used when pairing the center unit and subwoofer manually. MUTE key Mute the audio output. Press the key again to unmute. VOLUME (+/–) keys Adjust the volume of the unit. Volume down (–) Volume up (+) ...
Page 30 - Operating the unit by TV’s remote control (HDMI control)
30 En The HDMI control function (link function) coordinates operation of a TV and the unit so that the unit can be operated using the TV’s remote control.When a TV is connected to the center unit with an HDMI cable (p. 22), the TV’s remote control can be used to perform the following operations. Coo...
Page 32 - Play back a song on the Bluetooth device.; Terminating Bluetooth connection
32 En 3 Select “YAS-207 Yamaha” in the Bluetooth device list on the device. If a passkey (PIN) is required, enter the number “0000”. When the connection is established, the indicator or a completion message is displayed on the Bluetooth device, and the BLUETOOTH indicator on the unit glows. 4 Play b...
Page 33 - Using the Bluetooth standby function
En 33 Using the Bluetooth standby function The Bluetooth standby function allows you to turn on or off the unit automatically, linked with the operation of the Bluetooth device. 1 With the unit turned on, hold down the BLUETOOTH STANDBY key on the unit’s remote control for more than 3 seconds. Holdi...
Page 34 - Settings; Configuring the HDMI control function; Configuring HDMI audio output
34 En Settings Follow the procedure below to enable or disable the unit’s HDMI control function. This function is enabled by default. 1 Turn off the unit. 2 Hold down the HDMI key on the unit’s remote control for more than 3 seconds. The HDMI control function is enabled or disabled, and the unit tur...
Page 35 - Touch and hold; Initializing the unit
En 35 Enabling the auto power standby function prevents the unit from remaining on when not in use. When the auto power standby function is enabled, the unit automatically turns off in any of the following situations.• No operations for 8 hours• No audio input and no operations for 20 minutes when B...
Page 36 - Troubleshooting; Power and system; Problem
36 En Troubleshooting Refer to the table below when the unit does not function properly. If the problem you are experiencing is not listed below or if the instructions below do not help, turn off the unit, disconnect the power cables of the center unit and subwoofer, and contact the nearest authoriz...
Page 37 - The unit turns on by itself.
En 37 All indicators go out although the unit is turned on (it may seem that the unit is turned off). The unit is configured so that indicators do not glow or flash unless the unit is being operated. Use the DIMMER key to select the desired brightness (p. 29). The unit does not function correctly. T...
Page 38 - Audio
38 En Audio Problem Cause Remedy No sound. Another input source is selected. Select an appropriate input source (p. 26). The mute function is activated. Cancel the mute function (p. 28). The volume is too low. Turn up the volume (p. 28). The power cable of the center unit is not connected properly. ...
Page 39 - Though the
En 39 No sound is coming from the subwoofer. (The indicator on the subwoofer flashes or the STANDBY indicator on the subwoofer glows.) The center unit and subwoofer are not connected due to a bad wireless communication status. Move the subwoofer closer to the center unit. If the issue is not resolve...
Page 40 - Remote control
40 En Remote control No surround effect. Stereo playback is selected. Select surround playback or 3D surround playback (p. 27). The volume is too low. Turn up the volume (p. 28). The TV or playback device is set to output 2 channel audio (such as PCM) only. Change the digital audio output setting on...
Page 41 - Bluetooth
En 41 Bluetooth Problem Cause Remedy The unit cannot be connected to a Bluetooth device. Bluetooth is not selected as the input source. Select Bluetooth as the input source (p. 31). The unit is connected to a different Bluetooth device. Unpair the Bluetooth device that is currently connected, and pa...
Page 42 - Pairing the center unit and subwoofer manually
42 En Pairing the center unit and subwoofer manually 1 Turn off the unit. 2 Press and hold the SUBWOOFER (–) key on the remote control for more than 3 seconds. The DPL indicator on the center unit flashes. 3 Within 30 seconds, press and hold the PAIRING button on the rear panel of the subwoofer for ...
Page 43 - Specifications
En 43 Specifications Item Center unit (YAS-CU207) Subwoofer (NS-WSW42) Amplifier Section Maximum Rated Output Power Front L/R 50 W x 2 ch 100 W Speaker Section Type Front L/R: Acoustic suspension type Bass reflex type Driver Front L/R: 46 mm (1-3/4") cone magnetic shielding type x 4Tweeter: 25 m...
Page 45 - HDMI signal; • Audio signals; Digital audio signal; • Optical
En 45 HDMI signal • Audio signals NOTE • Refer to documentation supplied with the playback device, and set the device appropriately. • When CPPM copy-protected DVD-Audio is played back, video and audio signals may not be output depending on the type of the DVD player. • This unit is not compatible w...
