Yamaha XJ750- User Manual
Yamaha XJ750– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INCLUDED IN YOUR KIT:; and; TOOLS NEEDED
- Page 3 – DISCONNECT THE POSITIVE CABLE FROM YOUR BATTERY!!; ONLY; white wire with a red tracer stripe in your; PLEASE NOTE; : if the original bullet end terminal has been
- Page 4 – AFTER YOU’RE DONE; and Schmuckatelli Heavy Industries
1
HCP9982 Battery Sensor Bypass Device
INSTALLATION INSTRUCTION SHEET
Thank you for your purchase of this product.
It is designed to eliminate or replace your original battery fluid-level sensor device on the following models:
XJ650 Police models
XJ650 Turbo
XJ750-D models
1982 XJ750 Maxim
1981-83 XJ750 Seca
XJ750 11M models
XJ750 Police models
XJ1100 models
and other models from this era using an LCD display panel for various
sensors.
Your original sensor is a
low-fluid level
sensor, which screws into a
specific battery cell "filler cap" port, typically the third over from the
positive
terminal, and will trigger the warning icon (and the red
warning light) on your dash when the fluid level falls below a certain
level. In short, the original sensor serves as a reminder to the operator
to check the fluid level when it gets too low.
On the other hand, if you buy a replacement "sealed", maintenance-
free type of battery, an aftermarket battery which does not use
threaded fill caps (thank you, WalMart!), or the caps provided use a
different size threaded port, then one can’t use the original sensor.
That’s where this bypass device comes in.
This
replacement sensor bypass device
solves all of the above
problems, as well as providing a more meaningful measurement of
battery condition (its voltage). Although it no longer will notify you
directly of a low-fluid level condition (since it is not immersed into the
battery fluid), it will notify you of a low battery
voltage level
, no matter
what the cause -- including, of course, one caused by low fluid.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 INCLUDED IN YOUR KIT: A) Sensor Bypass Device B) Male bullet terminal to replace a missing terminal on the main harness, if needed C) Small section of heatshrink tubing (if you need to use the bullet terminal) D) Quick splice connector E) Female spade lug F) 2 zip ties Items D) and E) allow you to...
3 Clean all connection surfaces with fine sandpaper. If you find your battery terminals are covered with some kind of protective grease, you must clean and remove all of this material before re-attaching any wires. Then re-apply a protective grease or similar product, if desired, when you're finishe...
4 Positive terminal… …or starter solenoid. You decide. Either way, you can use the included zip ties to bundle the wiring together and tuck it up underneath the frame so it sits behind/on top of the airbox, out of the way. AFTER YOU’RE DONE : The original sensor and this sensor bypass device is not ...
