Yamaha TX-10 - User Manual - manualsarea.com

Page 3 - FEATURES; 0 Station Random Access Preset Tuning; CONTENTS; English; Thank you for selecting this YAMAHA stereo tuner; CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.

FEATURES • 40 Station Random Access Preset Tuning • Automatic Preset Tuning • Multi-Status Station Memory • Direct PLL Synthesizer Tuning • Preset Station Shifting Capability • Multi-Functions for RDS Broadcast Reception(U.K. and Europe models only) CONTENTS Supplied Accessories........................

Page 4 - ANTENNA CONNECTIONS; CONNECTIONS

ANTENNA CONNECTIONS ● Each antenna should be connected to the designated terminals correctly, referring to the following figure. ● Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signalstrength. Nevertheless, a properly installe...

Page 5 - Optional outdoor FM antenna; Notes for FM antenna installation; Connecting the indoor FM antenna

m Optional outdoor FM antenna Consult with your dealer or authorized service center about thebest method of selecting and erecting an outdoor FM antenna.The choice of the feeder cable is also important. Flat ribbon-shaped twin-lead cable performs well electrically, and ischeaper and somewhat easier ...

Page 6 - Optional outdoor AM antenna; CONNECTIONS TO THE AMPLIFIER

m Optional outdoor AM antenna In steel buildings or at a great distance from the transmitter, itmay be necessary to install an outside long wire antenna. GND terminalFor maximum safety and minimum interference, connectthe GND terminal to a good earth ground. A good earthground is a metal stake drive...

Page 7 - To turn off the power; Press the POWER switch again.; AUTOMATIC TUNING; TUNING OPERATIONS; General model

1 2 Select the reception band while watching the display. 3 4 If “PRESET” is being illuminated on the display, pressthe KEY MODE button to turn it off. 5 Tune to a desired station. To tune to a higher frequency, press the UP buttononce. To tune to a lower frequency, press the DOWNbutton once. 6 If t...

Page 8 - MANUAL TUNING; Display information

1 Follow steps 1 and 2 on the previous page. 2 3 If “PRESET” is being illuminated on the display, pressthe KEY MODE button to turn it off. 4 Tune to a desired station manually. * To continue tuning search, press and hold the button. NoteIf you tune to an FM station manually, it is received inmonaura...

Page 9 - MANUAL PRESET TUNING; To store stations; PRESET TUNING; Notes

9 English 1 1 Select the page where the preset station is stored. 2 2 If “PRESET” is not being illuminated on the display,any preset station cannot be recalled. If so, press theKEY MODE button to turn it on. 3 3 Select the preset station number. 1 Tune to a desired station. (Refer to the previous pa...

Page 10 - AUTOMATIC PRESET TUNING; models

1 2 3 The automatic preset tuning begins from the frequencycurrently displayed. Received stations are programmed toA1, A2 ... A8 sequentially.* If more than 8 stations are received, they are also programmed to the preset station numbers on other pages (B, C, D and E) in that order. If you want to st...

Page 11 - EXCHANGING PRESET STATIONS; General model only

11 English 1 Recall the preset station on E1 (by following the methodof “To recall a preset station” on page 9). 2 3 Next, recall the preset station on A5 by following thesame method with step 1. 4 Shows the exchange of stations is completed. EXCHANGING PRESET STATIONS You can exchange the places of...

Page 12 - RECEIVING RDS STATIONS

12 RECEIVING RDS STATIONS ( U.K. and Europe models only ) RDS (Radio Data System) is a data transmission system gradually being introduced by FM stations in many countries. Stationsusing this system transmit an inaudible stream of data in addition to the normal radio signal.RDS data contains various...

Page 13 - To turn the unit into the PS mode or PTY mode

13 English To turn the unit into the PS mode or PTY mode Press the FREQ/PS/PTY button. Whenever pressed, the mode changes into the PS mode, PTY mode and returns to usual mode inturn.* When an RDS station is received, the display is automatically turned into the PS mode. Do not press the FREQ/PS/PTY ...

Page 14 - * By pressing the TUNING UP or DOWN button repeatedly or; To cancel this function; Calling a preset RDS station by the station name (PS SEEK)

14 1 2 Turn the unit into the PS mode. * If “NO PS” flashes, proceed to the next step while flashing. If “NO PS” disappears before you proceed to the next step,press the FREQ/PS/PTY button again. 3 4 Select the first letter or numeral of the station name. * By pressing the TUNING UP or DOWN button r...

Page 15 - Calling a preset RDS station by the program type (PTY SEEK)

15 English Calling a preset RDS station by the program type (PTY SEEK) By designating a program type, the unit automatically searches all preset stations for RDS stations of that program type.* There are 15 program types to classify RDS stations. For details, refer to page 12. 1 Turn the unit into t...

Page 16 - Calling the best quality RDS station which broadcasts the

1 Tune to a desired RDS station. * Wait for about 10 seconds before proceeding to the next step. This allows the unit to search for morestations. 2 The unit searches for other stations with the same program. * If the station is not an RDS station, or there is no other station with the same program, ...

Page 18 - SPECIFICATIONS; FM SECTION

18 SPECIFICATIONS FM SECTION Tuning Range ...................................................87.5 to 108 MHz 50 dB Quieting Sensitivity (IHF) [Except Europe model] 75 ohms Mono ........................................1.55 µV (15.1 dBf)75 ohms Stereo ..........................................21 µV (3...

Yamaha TX-10 - User Manual

Table of Contents:

Other Manuals for Yamaha TX-10

Summary

Other Yamaha Models