Yamaha HTR 3071 - Manual
Yamaha HTR 3071 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Insert the USB thumb drive; STRAIGHT; ADVANCED SETUP; Select firmware update from the menu; PROGRAM
- Page 3 – Start firmware update; INFO; Firmware update in progress; Caution; Troubleshooting CASE 2; UPDATE SUCCESS
- Page 4 – Receiver doesn’t power up after the update.; USB UPDATE; Troubleshooting
RX-V383/HTR-3071
1
IMPORTANT NOTICE
Do not attempt to update your Yamaha receiver using any other data file except which provided directly from the
Yamaha website.
Follow the instructions carefully and do not attempt any other procedures no t specified in the instructions provided by
Yamaha.
Improperly updated products may cause improper operation, and any parts or service required to restore proper
operation will not be covered under the Yamaha Limited Warranty.
FIRMWARE UPDATING PROCEDURE
(A USB thumb drive is required)
In case of error, see the
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Yamaha HTR 3071
Summary
RX-V383/HTR-3071 2 Firmware Update by USB Requirement: USB thumb drive, with enough free space to store over 25MB. (File system with FAT16 or FAT32 format) Firmware file provided by YAMAHA, “R0xxx-xxxx.bin”. 1 Prepare USB thumb drive for the update Download the firmware, unzip and copy “R0xxx-xxxx.b...
RX-V383/HTR-3071 3 6 Start firmware update a. Press INFO key to start the update. (Update process may take up to 10 minutes) * If “ UPDATE SUCCESS ” appears, this means your receiver is already up-to-date. In this case, power off to exit from Advanced Setup. Your AV receiver is ready for normal use....
RX-V383/HTR-3071 4 CASE 1 Error message appeared during the update Cause: For some reason, the receiver can’t read the firmware data. Method: For your solution, check the following [Update by USB thumb drive] ❏ USB thumb drive is connected properly to the receiver. ❏ USB thumb drive is not password ...
