Yamaha HS8S - Manual

HS8/HS7/HS5/HS8S Owner’s Manual 5 En gl is h CAUTION Always follow the basic precautions listed below to avoid the possibility of physical injury to you or others, or damage to the device or other property. These precautions include, but are not limited to, the following: • When removing the electri...

HS8/HS7/HS5/HS8S Owner’s Manual 6 NOTICE To avoid the possibility of malfunction/ damage to the product, damage to data, or damage to other property, follow the notices below.  Handling and Maintenance • Do not expose the device to excessive dust or vibration, or extreme cold or heat (such as in di...

HS8/HS7/HS5/HS8S Owner’s Manual 7 En gl is h Rear Panel The HS8/HS7/HS5/HS8S switches and connectors are located on the rear panel, as described below. HS8/HS7/HS5 Speaker Input and Response Control 5 Power switch Turns power to the speaker ON or OFF.Rock the switch to the right [ ] to turn the powe...

HS8/HS7/HS5/HS8S Owner’s Manual 9 En gl is h Setup In this section we’ll look at the general procedure for connecting and setting up a monitor speaker system. This is just an example though, so feel free to set up your own system in the way that best serves your personal listening needs. Cables You’...

HS8/HS7/HS5/HS8S Owner’s Manual 10  Recommended cables  For connection to a balanced XLR input.  For connection to an unbalanced phone jack input. NOTE Refer to “Connection and Cable Types” on page 14 for more connector details. The configurations of the balanced and unbalanced phone jack connect...

HS8/HS7/HS5/HS8S Owner’s Manual 11 En gl is h  Point 2 Position the left and right speakers symmetrically. The left and right speakers should be positioned as symmetrically as possible in relation to the room. In other words, the left and right speakers should be the same distance from the rear wal...

HS8/HS7/HS5/HS8S Owner’s Manual 12  Recommended cables Cables for connecting the audio source (audio interface, etc.) to the HS8S  For connection to a balanced phone jack input.  For connection to a balanced XLR input.  For connection to an unbalanced phone jack input. Cables for connection betw...

HS8/HS7/HS5/HS8S Owner’s Manual 13 En gl is h Troubleshooting Symptom Possible Cause Solution Power won’t turn on / front panel logo doesn’t light. The power cord might not be connected properly. Check and connect the power cord. The power switch might not be turned on. Turn the power switch ON. If ...

HS8/HS7/HS5/HS8S Owner’s Manual 14 Connection and Cable Types To allow direct connection to equipment in a wide variety of working environments, the HS speakers are equipped with one XLR and one phone connector that both support balanced as well as unbalanced connections. Balanced or Unbalanced Bala...

119 En gl is h Deu tsch Fran çai s E s pa ño l P o rt u guê s It al ia no Русск ий 中 文 日本 語 HS5 HS8S Performance Graph Block Diagram 170 (6-11/16") 285 (1 1-1/4") 222 (8-3/4") Unit: mm (inch) 300 (11-13/16") 389 (15-5/16") 350 (1 3-3/4") Unit: mm (inch) HS 8 HS7 HS5 HS 8 S IN...