Yamaha AX-9 - User Manual

6 CONNECTIONS Never plug in this unit and other components until all connections are completed. ● When making connections between this unit and other components, be sure all connections are made correctly, that is to say L(left) to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the own...

7 English Connect the SPEAKERS terminals to your speakers with wireof the proper gauge, cut as short as possible. If theconnections are faulty, no sound will be heard from thespeakers. Make sure that the polarity of the speaker wires iscorrect, that is, + and – markings are observed. If these wiresa...

8 CONTROLS AND THEIR FUNCTIONS FRONT PANEL 1 Power indicator Lights up while the power to this unit is on. 2 STANDBY/ON switch Press this switch to turn the power to this unit on. Press itagain to turn this unit into the standby mode. Standby modeIn this state, this unit consumes a very small quanti...

9 English For Control of This Unit 1 SLEEP timer key This unit is automatically turned into the standby mode onehour after this key is pressed (so that SLEEP indicator lightsup). 2 POWER key Turns the power to this unit on and turns this unit into thestandby mode alternately. 3 Input selector keys S...

10 1 Set to the “0” position. 2 Turn the power on. 3 Select a desired input source. The indicator of the selected source lights up. 4 Select the speakers to be used. * If you use two speaker systems, press both the A and B switches. 5 Play the source. 6 Adjust to the desired output level. 7 If desir...

11 English TO RECORD A SOURCE TO TAPE (OR MD) When you listen with headphones Connect the headphones to the PHONES jack. When listeningwith headphones privately, set both the SPEAKERS A and Bswitches to the OFF position. P H O N E S STANDBY/ON SLEEP TAPE MONITOR PURE DIRECT PHONES SPEAKERS ON OFF A ...

12 Adjusting the BASS and TREBLEcontrols Adjusting the BALANCE control Selecting the SPEAKER system Adjust the balance of the output volume to the left and rightspeakers to compensate for sound imbalance caused fromspeaker location or listening room conditions. Because one or two speaker systems can...

13 English If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simplemeasures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord andcontact your authorized YAMAHA de...

14 SPECIFICATIONS Minimum RMS Output Power per Channel8 ohms, 20 Hz to 20 kHz, 0.03% THD .......................50W+50W Dynamic Power per Channel(by IHF Dynamic Headroom measuring method) 8/6/4/2 ohms.................................................78/88/100/112W DIN Standard Output Power per Channe...