Xerox 8855/721P - Manual - manualsarea.com

Page 3 - Table of Contents

1 Table of Contents It’s Illegal ..................................................................... 2FCC Compliance ......................................................... 2Introduction to your Stacker ...................................... 3Safety Notes ...........................................

Page 4 - It’s Illegal; FCC Compliance; In the USA; Class A; How to Identify and resolve Radio-TV Interference Problems

2 It’s Illegal In the USA It is against U.S. law to copy copyrighted material without permissionof the copyright owner unless the copying falls within the “Fair Use”library reproduction rights of the copyright law. Further information on these U.S. provisions may be obtained fromthe Copyright Office...

Page 5 - Introduction to Your Stacker; Congratulations on acquiring your new Stacker.; PURCHASE OF OTHER EQUIPMENT:; Local Marketing Representative phone number:

3 Introduction to Your Stacker Congratulations on acquiring your new Stacker. This User Guide provides information that is needed to operate theStacker. The information below is needed when you call your Xerox supportexperts. 1. Customer Account Number: __________________ 2. Stacker Serial Number: _...

Page 6 - Safety Notes

4 Safety Notes Your stacker has been designed and tested to meet strict safety requirements. These include safety agency examination and approval, andcompliance to established environmental standards. Please read the following instructions carefully before operating the Stacker. NOTE: Refer to Instr...

Page 7 - UNPLUG

5 Safety Notes (continued) UNPLUG this stacker from the wall outlet and refer servicing to qualified service personnel under the following conditions: - W hen the power cord is damaged or frayed. - If liquid has been spilled into the product. - If the stacker has been exposed to rain or water. - If ...

Page 8 - Identifying the Parts on the Stacker

6 Identifying the Parts on the Stacker Upper Panel Assembly Stacker Unit Media Supports Frame Assembly Release Handle Thumb Screws Inlet Power IndicatorLight Power Switch Printed Wiring Board(Transmission) Printed Wiring Board(Reception) Release Handle

Page 9 - If; Stacker Jam Clearance; The paper fed from the printer will be either cut or uncut.; Caution; Cut; Figure 1. Sliding the Stacker away from the Printer.

7 Location of the Stacker Serial Number In order to locate the serial number of your stacker, you must firstpush down the release lever and slide the stacker away from theprinter. The serial number plate is located on the left of the front cover facingthe printer. Stacker Operation If you are runnin...

Page 10 - Stacker Relocation

8 Stacker Relocation The stacker cannot be moved except by a DRC rigger. To ensure that the stacker operates reliably after moving it to a newlocation, consider the following guidelines: · The new location must provide minimum clearances around the stacker. These clearances are shown in the diagram ...

Page 11 - Technical Data; 00 sheets of plain paper with minimal scatter

9 Technical Data Dimensions: W idth: 34” (864mm) 57.5” (1461mm) w/paper supports extended. Depth: 41” (1041mm)Height: 28.5” (724mm) Weight: 108 lbs. (49kg) Paper Size: 36 x 48” (914mm x 1219mm) Max. Stacker Capacity: 200 sheets of plain paper with minimal scatter 500 plain paper sheets Max. Electric...

Xerox 8855/721P - Manual

Table of Contents:

Summary

Other Xerox Models