Xantech 780-95 - Manual
Xantech 780-95 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – PLASMA DISPLAY
- Page 3 – Page 3; APPLICATION WIRING; IN terminals on the 789-44 Connecting Block; REMOTE ROOM; ADVANCED WIRING CONFIGURATION
- Page 4 – USING THE STATUS LED INDICATOR; Plasma Friendly; Figure 5; MAIN ROOM; switched; XANTECH CORPORATION
INSTALLATION INSTRUCTIONS
MODEL 780-95
“PLASMA FRIENDLY” J-BOX INFRARED RECEIVER
TABLE OF CONTENTS
Introduction ...................................................................................................................................................................... 1
Features ...................................................................................................................................................................... 1
Specifications .............................................................................................................................................................. 2
Installation ....................................................................................................................................................................... 2
Placement ................................................................................................................................................................... 2
Mounting...................................................................................................................................................................... 2
Application wiring ......................................................................................................................................................... 3
Adv anced wiring configuration...................................................................................................................................... 3
Using the Status LED Indicator .................................................................................................................................... 4
INTRODUCTION
The
780-95
is designed to reject interference from
Plasma
Displays from entering the IR signal line. This IR Receiver mounts easily
into a single gang, electrical J-Box and is supplied with mounting screws and comes with a Decorator-style insert, allowing the installer
to use a Decorator-style wall cover plate. This provides an integrated look for control of A/V equipment behind closed doors or any IR
Repeater System that is in close proximity to a
Plasma
Display.
FEATURES
•
J-Box Mounting with Decorator-style insert (available in white(included), ivory, almond, & black)
•
4-screw terminal block for interface to
Xantech
Connecting Blocks
•
W orks in normal 3-wire mode
•
Improved Fluorescent Light rejection
•
May be used in Direct Sunlight
•
RF Grid included for EMI reduction
•
Talk Back LED for IR reception and full system operation indication
•
Status LED for system On/Off indication (requires 12VDC Source @10mA)
•
7 units may be powered by one 781RG power supply (regulated 12VDC 200mA supply)
Note:
The 780-95 will not operate in 2-wire
Phantom Power
mode
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 2 Model 780-95 © 2003 Xantech Corporation +IR OUTGNDSTATUS+12V 780-95 IR RECEIVER ® IR Receiver Photo Diode Green STATUS LED Red Talkback LED Figure 1 – 780-95: Front & Rear View SPECIFICATIONS • Infrared modulation frequency bandwidth: 30 - 100 kHz • Reception range: up to 50 feet (18M), d...
Model 780-95 Page 3 © 2003 Xantech Corporation APPLICATION WIRING A typical system , with a 780-95, 781RG Power Supply and 283M Emitters plugged into a 789-44 Connecting Block, is shown in Figure 3 : 1. W ire the appropriate leads of the 3 or 4-conductor cable from the 780-95 to the +12VDC, GND, STA...
Page 4 Model 780-95 © 2003 Xantech Corporation USING THE STATUS LED INDICATOR The 780-95 Plasma Friendly IR Receiver includes a Status LED located just below the Talkback LED (See Fig. 1 ). This permits the system to have a visible power ON/OFF indicator in the remote room. W hen used with any of Xa...
