WTI Remote Power Boot Switch - Manual

WTI Remote Power Boot Switch

WTI Remote Power Boot Switch – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12

Table of Contents:

  • Page 2 – B. Customer Service; List of Figures; The Status Screen; Typographic Conventions
  • Page 3 – COURIER FONT; Indicates characters typed on the keyboard. For example,; Unit Description; As shown in
  • Page 4 – Section 4
  • Page 5 – Figure 3
  • Page 6 – Via Local PC: Start your communications program.
  • Page 7 – The unit will display a series of prompts.
  • Page 9 – Example 2: To set default plug conditions as follows:; OFF
  • Page 10 – Set Plugs to Default: To set all plugs to the Power-Up Defaults, type; Appendix A. Specifications; DB9 Connector: A 9 Pin Male connector wired in a DTE configuration.
  • Page 11 – Weight: 5 pounds shipping weight; Appendix B. Customer Service; WTI Customer Service
  • Page 12 – FCC Statement; This device may not cause harmful interference, and; Trademark and Copyright Information
Loading the manual

WTI Part No.: 12651

Rev. B

RPB+

Remote Power Boot Switch

User's Guide

5 Sterling, Irvine, California 92618-2517 USA

U.S. & Canada: (800) 854-7226

Phone: (949) 586-9950

Fax: (949) 583-9515

www.wti.com

Table of Contents

1. Introduction

2. Unit Description

2.1. Front Panel

2.2. Back Panel

3. Installation

3.1. SetUp Switches

3.2. Control Port Connection

3.2.1. Connecting to a Modem

3.3. Power Connection

4. Start-Up / Configuration

4.1. The Power-Up Default String

5. Operation

Appendices

RPB+; Remote Power Boot Switch -- User's Guide

file:///C|/WEBPAGE/guides/rpbp/build/rpbpguid.htm (1 of 12) [3/9/2000 5:08:10 PM]

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - B. Customer Service; List of Figures; The Status Screen; Typographic Conventions

A. Specifications ● B. Customer Service ● List of Figures 1. Front Panel ● 2. Back Panel ● 3. RS-232 (Control Port) Interface Schematic ● 4. RPB+ Cable Connections ● 5. The Status Screen ● 1. Introduction Network equipment sometimes "locks-up", making it impossible to communicate. TheRPB+ Re...

Page 3 - COURIER FONT; Indicates characters typed on the keyboard. For example,; Unit Description; As shown in

Throughout this manual, typefaces and characters have been used to denote the following: COURIER FONT Indicates characters typed on the keyboard. For example, /S or /3 ON. [Bold Font] Text set in bold face and enclosed in square brackets indicates aspecific key. For example, [Enter] or [Esc]. 2. Uni...

Page 4 - Section 4

Switched AC Outlets (Plugs 1 - 5): For connection to up to five AC devices. Eachoutlet is capable of switching up to 15 Amps. The total for all five outlets must notexceed 15 Amps. 1. SetUp Switches (RATE): A bank of four DIP Switches which set the Control Portbaud rate, select the Off Time duration...

Other WTI Models

All WTI Other