Page 2 - IN THE EVENT OF A POWER FAILURE, DO NOT
IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS ...
Page 4 - LOCATION; INSTALLATION CODES AND STANDARDS
- 4 - LOCATION The equipment area must be kept free and clear of combustible substances. Installation clearances: COMBUSTIBLE NON-COMBUSTIBLE CONSTRUCTION CONSTRUCTION Back: 6" (152 mm) 0" Right Side: 10" (254 mm) 0" Left Side: 10" (254 mm) 0" The installation location must a...
Page 6 - GAS PRESSURE REGULATOR; water solution. Do not use an open flame.
If disconnection of the restraint is necessary, turn off the gas supply before disconnection. Reconnect this restraint prior to turning the gas supply on and returning the range to its installation position. If the range is installed on casters and is moved for any reason, it is recommended that the...
Page 7 - ELECTRICAL CONNECTIONS; OPERATION; servicing the appliance.
FLUE CONNECTIONS DO NOT obstruct the flow of flue gases from the flue located on the rear of the range. Proper venting of flue gas is vital to the safe and efficient operation of the range. Problems arising from the intentional obstruction of the flue will result in voiding of warranty. It is recomm...
Page 9 - Thermostatic Griddle; DO NOT
- 9 - 4. Turn the burner valve ON to the desired heat. 5. If burners fail to light, turn off all valves, and then call an authorized installation or service person. 6. To shut down, turn the burner valve to the OFF position. 7. For complete shut down, turn all burner valves to the OFF position. Turn...
Page 10 - Manual Griddle
- 10 - 11. Standard Oven – If ignition fails, turn the oven control knob to OFF. Wait 5 minutes and repeat the above procedure. Convection Oven – If ignition fails, turn the fan switch and oven control knob to OFF. Wait 5 minutes and repeat the above procedure. DO NOT attempt to relight pilot withou...
Page 11 - CLEANING; Shut off the gas before cleaning the appliance.; DAILY CLEANING
Provide adequate space for product unloading. Rapid unloading will conserve heat and ensure proper reheating conditions for the next load, if applicable. CLEANING Disconnect the electrical power to the machine and follow Lockout / Tagout procedures. Shut off the gas before cleaning the appliance. Th...
Page 12 - MAINTENANCE & ADJUSTMENTS
C l e a n t h e g r i d d l e r e g u l a r l y . A c l e a n g r i d d l e a l w a y s l o o k s b e t t e r , l a s t s l o n g e r a n d p e r f o r m s b e t t e r . T o p r o d u c e e v e n l y c o o k e d , p e r f e c t l y b r o w n e d g r i d d l e p r o d u c t s k e e p t h e g r i d d ...
Page 13 - TROUBLESHOOTING
- 13 - SERVICE AND PARTS INFORMATION To obtain service and parts information, contact an authorized service agency in your area (refer to our website, www.wolfrange.com for a complete listing of authorized service and parts depots). When calling for service, the following information must be availab...
Page 14 - NOTES
- 14 - NOTES FORM F35696 Rev. E (07-08) PRINTED IN THE U.S.A.
Page 15 - MODE D’INSTALLATION ET MODE D’EMPLOI; CUISINIÈRES AU GAZ POUR RESTAURANT
MODE D’INSTALLATION ET MODE D’EMPLOI CUISINIÈRES AU GAZ POUR RESTAURANT DE LA SÉRIE CHALLENGER XL MODÈLES: C24S C36(S,C) C48(S,C) C48SS C60(S,C)(S,C) C72(S,C)(S,C) www.wolfrange.com Une division de Groupe ITW Équipement alimentaire, LLC 10405 Westlake Drive Charlotte, NC 28273 DOCUMENT À CONSERVER E...
Page 16 - EN CAS DE PANNE DE COURANT, NE PAS FAIRE
MESURES DE SÉCURITÉ IMPORTANTES CE MANUEL A ÉTÉ PRÉPARÉ À L’INTENTION D’UN PERSONNEL QUALIFIÉ ET AUTORISÉ À INSTALLER DES APPAREILS FONCTIONNANT AU GAZ ET À EFFECTUER LE DÉMARRAGE INITIAL CHEZ LE CLIENT DE MÊME QUE LE RÉGLAGE DES APPAREILS CONCERNÉS DANS CE MANUEL. AFFICHER À UN ENDROIT VISIBLE LES ...
Page 17 - ACCESSOIRES POUR INSTALLATION SUR PLACE EN OPTION; DESCRIPTION ACCESSOIRES; INSTALLATION; DÉBALLAGE
- 3 - Installation, fonctionnement et entretien CUISINIÈRES AU GAZ POUR RESTAURANTS DE LA SÉRIE CHALLENGER XL GÉNÉRALITÊS Les cuisinières et fours Wolf sont fabriqués avec le plus grand soin et à partir des meilleurs matériaux. Ils sont conçus en vue d’obtenir des résultats de cuisson satisfaisants,...
Page 18 - EMPLACEMENT; CODES D’INSTALLATION ET NORMES
- 4 - EMPLACEMENT Aucune substance combustible ne doit se trouver à proximité de cet appareil. Dégagement requis lors de l’installation : CONSTRUCTION CONSTRUCTION COMBUSTIBLE INCOMBUSTIBLE Arrière : 152 mm (6 po) 0" Côté droit : 254 mm (10 po) 0" Côté gauche : 254 mm (10 po) 0" Les cuis...
Page 21 - RACCORDEMENT ÉLECTRIQUE; FONCTIONNEMENT; Permet d’acheminer le gaz vers les brûleurs de la
RACCORDEMENT ÉLECTRIQUE Le raccordement électrique et la mise à la terre doivent être conformes aux normes concernées du code canadien de l’électricité ou tout autre code d’électricité en vigueur. Couper l’alimentation électrique de l’appareil et suivre les procédures de verrouillage et d’étiquetage...
Page 23 - d’une veilleuse permanente.; NE PAS
- 9 - 3. Appuyer sur le bouton rouge de la soupape de sûreté et le maintenir enfoncé, puis allumer la veilleuse à travers l’ouverture en fente dans le couvercle de la tubulure d’alimentation près du bouton du robinet du brûleur. 4. Maintenir le bouton rouge enfoncé pendant au moins 30 secondes. 5. L...
Page 24 - NETTOYAGE
SUGGESTIONS DE FONCTIONNEMENT Brûleurs découverts Les cuisinières à brûleurs découverts s’allument rapidement et ne nécessitent aucun temps de réchauffage. Les brûleurs découverts possèdent une grande variété de réglages de la flamme du brûleur allant de basse à élevée. Ceci permet un rendement supé...
Page 25 - NETTOYAGE QUOTIDIEN; Brûleur découvert
- 11 - Les surfaces extérieures se nettoient au moyen d’un chiffon et d’un détergent doux. Ne pas utiliser du détergent à vaisselle Dawn md pour nettoyer les composants extérieurs et intérieurs de la cuisinière. Ne pas utiliser de la poudre à récurer. Elle s’enlève très difficilement et peut s’accum...
Page 26 - ENTRETIEN ET RÉGLAGES
NETTOYAGE DU REVÊTEMENT EXTÉRIEUR Nettoyage quotidien Nettoyer le revêtement extérieur de l’appareil à l’aide d’une solution savonneuse douce ou de dissolvant à graisse. Pour réduire la décoloration, utiliser un nettoyant non abrasif. Toujours frotter dans le sens du grain du métal. Polir les surfac...
Page 27 - PRÉCAUTIONS; DÉPANNAGE
- 13 - PRÉCAUTIONS Ne jamais utiliser une racle ordinaire en acier inoxydable pour enlever les dépôts tenaces de graisse ou d’huile sur une surface en acier inoxydable. Des particules ou de l’acier ordinaire risquent de s’incruster ou de se loger dans la surface en acier inoxydable, provoquant une l...
Page 28 - REMARQUES
- 14 - REMARQUES F35696 Rev. E (07-08) IMPRIMÉ AUX É.-U.