Winegard TR-6100 - Manual
Winegard TR-6100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
This should clear
out any previously
installed devices.
Then, select Done.
Re-connect the
coaxial cable to
the “Satellite In”
port on the back
of the receiver.
DISH
®
Receiver Setup for TR-6100
DISH receivers will often not show when they are on signal if they have incorrect “Check Switch”
information. For this reason, DISH users must clear current settings before pointing. To do this for most
DISH receivers, follow these steps. The following instructions are based on a ViP
®
211 receiver.
If your receiver differs from the options shown, you may need to consult your receiver manual. The
wording and display used in your receiver may differ slightly.
Select option 1,
Point Dish.
Before starting,
disconnect coax
from “Sat in” on
back of receiver.
Press Menu on
your remote.
Select option 6,
System Setup.
2
4
1
3
5
Select option 1,
Installation.
7
Select
Check Switch.
For Help, Call 1-800-788-4417
Check that there
are no checkmarks
by SuperDISH or
Alternate. Select
Test.
The receiver will
go through a
number of steps
and then may
warn that fewer
satellites were
detected.
If so, select Save.
It may ask you to
confirm. If so,
select Save again.
6
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
