Winegard SK-7002 - Manual - manualsarea.com

Page 2 - DO NOT install in a location where a; Alert; product use, product specifications or procedures.; Important tip

Congratulations! You have selected the Winegard ® TRAV’LER Automatic Multi-Satellite TV Antenna. The TRAV’LER antenna will deliver the ability to view both SHAW DIRECT satellites at the same time with unmatched signal strength, the lowest travel height on the market, maximum HD capabilities and easy...

Page 3 - The TRAV’LER antenna may only be mounted parallel to; FIGURE 2; age to the TRAV’LER antenna or the coach.; FIGURE 1; FRONT OF R

Once you have checked for this: 1. Choose a location on the roof of the RV that will allow the dish to raise and rotate without interfer- ence from other roof mounted equipment. The TRAV’LER antenna may only be mounted parallel to the centerline of the coach. 2. The minimum roof space required for t...

Page 4 - TRAV’LER Mount Installation; manual for specifics in the diagram.; FIGURE 3; TRANSITION; SCREW

NOTE: Anything in the striped area will interfere with the operation of the TRAV’LER antenna and may cause damage to the object or the TRAV’LER antenna. TRAV’LER Mount Installation Verify that the “FRONT” of the transition plate is facing the front of the vehicle, then place the TRAV’LER antenna mou...

Page 5 - Cable Entry Plate Installation:; You will need to run:; FIGURE 4; LIP OF; WARNING: DO NOT cut any; FIGURE 5; The SK-7002 will support up to; Secure any excess cable.

Run a solid bead of sealant around the transition plate, making sure to cover each screw head. Be careful not to get any sealant above the lip of the transition plate. See diagram of transition plate. Cable Entry Plate Installation: Decide the best location for the cables to enter the vehicle. You w...

Page 6 - Reflector Installation:; Interface Box finishes “connecting to antenna”.; FIGURE 5A

Cable installation: Connect the control cable and power cable to the back of the TRAV’LER Interface box as shown below. Note: For cable runs longer than 25’ an extension may be purchased. Do not exceed 50’ of cable. Attach the TRAV’LER control cable to the TRAV’LER Interface Box, as shown in Figure ...

Page 7 - OR

A. Press [ENTER] the TRAV’LER will return to the “Installation Menu” OR B. Press [POWER] the TRAV’LER will stow and turn “OFF” (Restart at Step 1). Refer to the SKA-722 Manual for instructions on how to install the Reflector and Bracket. Manual: 1. Press [POWER] and hold for 2 seconds to turn “ON” t...

Page 8 - WARNING: Pay attention to these Pinch Points as the antenna raises!; POWER; FIGURE 6; Pinch Points; manual Pages 3-4 for proper cable attachment.; Ensure that your Shaw Direct receiver is connected to power.

WARNING: Pay attention to these Pinch Points as the antenna raises! Using the (4) bolts and nuts provided, attach the reflector to the mounting bracket. Press [ POWER ] to lower the antenna to the travel position. Note: The nuts securing the dish should be tightened to 6-8 lb.ft. 8 FIGURE 6 FIGURE 7...

Page 9 - Remove the black plastic bolt from the back of the; FIGURE 8; AUXILIARY; EMERGENCY MANUAL STOW; EMERGENCY MANUAL STOW IS; LAST RESORT; AND; To Lower

Appendix: Making the Right Connection with Hex Connectors Making a coaxial cable connection is critical. If you have the basic technique right you can modify it to your own personal taste. Whether you use a knife, stripping tool or diagonal cutter, the important thing is to make a good clean cut. A ...

Page 10 - DO NOT paint this antenna!; WINEGARD MOBILE PRODUCTS LIMITED WARRANTY; RETURN AUTHORIZATION POLICY; SATELLITE RECEIVER WARRANTY

10 INSTALLATION ! DO NOT paint this antenna! Painting the TRAV’LER antenna will void your warranty. WINEGARD MOBILE PRODUCTS LIMITED WARRANTY (2 YEARS PARTS; 1 YEAR LABOR) Winegard Company warrants this product against defects in materials or workmanship for a period of two (2) years from the date o...

Winegard SK-7002 - Manual

Table of Contents:

Summary

Other Winegard Models