Winegard RD-4610 - Manual
Winegard RD-4610 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Choose a location for antenna that will allow it to rest in travel
- Page 3 – FIGURE 2; Attach reflector to backup assembly as shown in Figure 2.
- Page 4 – tional
- Page 5 – Feed downleads through roof using Winegard Model CE-2000; Weatherproof cable entry; by; If coax connections are made; Assemble ceiling plate, directional handle and crank handle as; INSIDE RV
- Page 6 – FIGURE 4; INITIAL; Tighten screw snugly; POINT TO
- Page 7 – FIGURE 5; LOCK; ELEVATION; NONE; OPERATION
- Page 8 – Do
- Page 10 – FIGURE 9; WAVE WASHER; MAINTENANCE
- Page 11 – ANTENNA/LIFT/LNBF TWO YEAR LIMITED WARRANTY
- Page 12 – PARTS LIST; REAR VIEW
- Page 15 – SPECIFICATIONS; MODEL RP-4200 THICK ROOF KIT AVAILABLE
®
OWNER’S MANUAL
INSTALLATION INSTRUCTIONS
RV Digital Satellite System
with RS-1000 Antenna
Model RD-4610
U.S. PATENTS 5,532,710
and 5,554,998
Made in U.S.A.
WINEGARD
Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000
319/754-0600 • FAX 319/754-0787
Printed in U.S.A. © Winegard Company 2001 2451142 Rev. 6/05/01
IMPORTANT:
INSTALL POINT
OF BASE
TOWARD FRONT
OF VEHICLE!
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
FIGURE 1 INSTALLATION & ASSEMBLY STEP 1. Choose a location for antenna that will allow it to rest in travel position with antenna pointing toward rear of vehicle and raise and rotatewithout interfering with other roof-mounted equipment. Make sure insideceiling area is clear where ceiling plate w...
FIGURE 2 (4) 5/16-18 x 5/8"Flat Head Bolt (4) 5/16" Flat Washer (4) 5/16-18 Hex Nut Backup Assembly RS-1000 Antenna Reflector STEP 3. Attach reflector to backup assembly as shown in Figure 2. STEP 4. Attach RS-1000 antenna to elevating tubes, see Figure 2, using the two Eclips and pins provi...
ROOF ELEVATING SHAFT W/RW-1000 DIRECTIONAL THICKNESS LENGTH HANDLE LENGTH 4 3/4" 6 1/4" RP-4200 req. 5 3/8" 4 1/2" 6" RP-4200 req. 5" 4 1/4" 5 3/4" 6 1/4" 4 3/4" 4" 5 1/2" 6" 4 1/2" 3 3/4" 5 1/4" 5 3/4" 4 1/4" 3 1/2" 5" ...
