Winegard MS-1006 BULK - Manual
Winegard MS-1006 BULK – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – DIMENSIONS; VHF
- Page 3 – RECOMMENDATIONS FOR INSTALLING; ANTENNA MOUNTING INSTRUCTIONS
- Page 4 – TYPICAL HOME INSTALLATIONS; CONSUMER 90 DAY WARRANTY; HOW TO PROVIDE; In the case of a “ground up” antenna
WARNING!
DANGER OF ELECTROCUTION
CHECK AREA AROUND ANTENNA SITE
FOR OVERHEAD WIRES. DO NOT ALLOW
ANTENNA, MAST OR GUY WIRES TO CONTACT
OVERHEAD WIRES. (SEE INSTALLATION
SAFETY INSTRUCTIONS.)
Winegard Company
3000 Kirkwood Street • Burlington, Iowa 52601-2000
Printed in U.S.A. 2451961 Rev. 1/09
© WINEGARD COMPANY 1998, 2006
WINEGARD
®
METROSTAR
®
VHF/UHF
OMNIDIRECTIONAL TV ANTENNA
AMPLIFIED MODEL MS-2000 (MS-2006 BULK), MS-2002
NON-AMPLIFIED MODEL MS-1000 (MS-1006 BULK), MS-1002
(MAST NOT INCLUDED)
Made in U.S.A.
INSTRUCTIONS
Many do-it-yourself and professional antenna installers
are injured or killed each year by electrocution. While
anyone can see the obvious danger of falling, the most
resourceful sometimes fails to recognize overhead wires
as being potentially lethal. To touch any part of the
antenna mast or guy wires to these overhead wires is
the same as touching them with your bare hand. A very
serious shock is almost sure to result when contacting
an electrical wire, and in the case of primary wires on
the top of poles, the shock is like being struck by a bolt
of lightning. Many power wires are within 20' to 25' of the
ground and could easily be touched by an assembled
antenna and mast.
WARNING!
TO PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE POWER SUPPLY SECTION OF
THIS APPLIANCE TO RAIN OR MOISTURE.
Please read and follow these suggestions, if
applicable:
1. Try to have two people available for help, if
needed.
2. Try to select antenna site well away from all
overhead wires. Check distances.
3. If possible, do all assembly work on ground
and then raise the antenna.
4. Don’t try to install antenna when it is windy.
5. If anything should come in contact with the
overhead wires, call the power company.
They will remove it safely.
6. Don’t try to guess which overhead wires carry
high voltage. Check with power company.
7. Make the installation secure. Use plenty of
guy wires and good hardware.
8. Make sure antenna mast and downlead cable
are connected to suitable lightning arrestors.
Use at least No. 8 ground wire between mast
and ground.
9. Do not run downlead over power wires.
10. Get professional help when removing the old
antenna if there is any doubt of clearing over-
head wires.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
DIMENSIONS PARTS LIST MS-2000 Amplified Antenna Head ............................................. Mounting Bracket.......................................... 3720317 1 Mast Clamp ............................................... 3640051 2" U-Bolt ......................................................
STEP 3. Attach “F” connector on cable from analog TV/ DTV receivers to power injector jack marked “TV”. See figure 2. STEP 4. Connect one “F” connector on supplied black RG-6 cable to power injector jack marked “PWR IN”. Connect the other “F” connector on supplied RG-6 cable to jack on supplied AC (...
TYPICAL HOME INSTALLATIONS CONSUMER 90 DAY WARRANTY The Winegard Company warrants this Winegard product against any defects in materials or workmanship within 90 (ninety) days from date of purchase. No warranty claim will be honored unless at the time the claim is made, you present proof of purchase...
