Winegard MODEL CC-10HV - Manual
Winegard MODEL CC-10HV – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Top View; Front of RV; Front of RV; NOTE
- Page 3 – Installing the Mounting Bracket; TIP; Travel Position
- Page 4 – Installing the Power Supply; Front of Power Supply
- Page 5 – Maintenance; Rotating Antenna for Best Picture; Checking the Operation of the Power Supply
- Page 6 – Installing Connector on Coax Cable; Notes; Parts; Mount; ORDERING REPAIR PARTS
- Page 7 – Antenna Head
- Page 8 – Do not drill through ceiling!
Please register your Winegard product by
completing the online registration form at
http://
www.winegard.com/registration
.
Coast to Coast RV Services
20 George Young Street, Auburn NSW 2144
Postal Address: PO Box 415, Regents Park NSW 2143
Phone: 02 9645 7600
Fax: 02 9645 7688
Email Technical: [email protected]
Email Warranty: [email protected]
2452246
•
For VHF
&
UHF channels
•
Bidirectional antenna
•
Operating dimensions: 43.2 cm wide x 116 cm tall
•
Length when stowed: 125.3 cm
•
Height when stowed: 11.2 cm
•
Storage (survival) temperature: -40° C to +80° C
•
For outdoor use only
•
Model CC-10HV (Aftermarket)
Specifications
Product Registration
VHF
&
UHF Antenna
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Choosing a Location for the Antenna Clearance Requirements Front of Antenna Mounting Bracket Other Hardware Top View Side View Install in dry conditions only! Before choosing a location for the antenna, contact your RV dealer or manufacturer. Your RV may be pre-wired or have a reinforced area for th...
Making Cable Entry Holes Assembling the Antenna The ceiling plate will be mounted inside the vehicle directly underneath the mounting bracket . Make sure the ceiling area is clear underneath the chosen location for the mounting bracket. Use the template on the last page of this manual, and drill a 4...
Cutting the Directional Handle to fit Roof Thickness Carefully align the keys inside the directional handle with the keyways on the bottom of the gear housing. (The keys only line up one way—do not force.) Pull the handle down, and transfer this dimension to the shaft end of the directional handle. ...
