Whirlpool WVU17UC0JW - Manual
Whirlpool WVU17UC0JW Range Hood – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION INSTRUCTIONS; WARNING
- Page 3 – INSTRUCTIONS D'INSTALLATION DE LA HOTTE; EXIGENCES D’INSTALLATION; Outils et pièces
- Page 4 – INSTRUCTIONS D’INSTALLATION; AVERTISSEMENT
RANGE HOOD INSTALLATION INSTRUCTIONS
For questions about features, operation/performance, parts, accessories, or service, call:
1-800-253-1301
.
In Canada, for assistance, installation, and service, call:
1-800-607-6777
.
Residential range hoods can be installed to comply with Sections 308 and 309 of ADA Guidelines when used with appropriately
mounted contr
ols installed at 15" (38.1 cm) to 40" (101.6 cm) above the floo
r, and control access should not require reaching over
a cooking appliance.
The following range hoods can work in an ADA-compliant situation when the range hood is wired to operate from a dedicated
standard electrical wall switch. To facilitate this application, share the information on the following pages with your electrician
when preparing for the installation.
NOTE:
All the models can be controlled only by one remote switch. The switch activates or deactivates the motor and the light
of the hood.
INSTALLATION REQUIREMENTS
Tools and Parts
Tools Needed
Wire stripper
#2 Phillips
screwdriver
Flat-blade
screwdriver
Parts Needed
UL Listed/CSA
Approved wire
connectors
UL Listed/CSA
Approved
1/2" (13 mm)
strain relief
UL Listed #14
(minimum)
3 wire cable
UL Listed single pole
toggle light switch
UL Listed deep
single-gang
switch box
Electrical Requirements
Observe all governing codes and ordinances.
Ensure that the electrical installation is adequate and in
conformance with National Electrical Code, ANSI/NFPA 70
(latest edition), or CSA Standards C22.1-94, Canadian Electrical
Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all local
codes and ordinances.
If codes permit and a separate ground wire is used, it is
r
ecommended that a qualified electrician determine that the
ground path is adequate.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
A 120-volt, 60 Hz., AC-only, 15-amp fused electrical circuit
is required.
Two-Speed Range Hoods
(with rocker switch)
Intermediate Range Hoods
(with rotary switch)
Three-Speed Range Hoods
(with push buttons)
UXT20
UXT30
UXT40
UXT41
WVU17U
UXT42
UXT52
WVU37U
W11108368B
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Whirlpool WVU17UC0JW
Summary
INSTALLATION INSTRUCTIONS WARNING Electrical Shock Hazard Disconnect power before installing light switch.Electrically ground range hood and light switch by connecting ground wire to the ground screw in the switch box.Replace all parts and panels before operating.Failure to do so can result in death...
INSTRUCTIONS D'INSTALLATION DE LA HOTTE Pour des questions à propos des caractéristiques, du fonctionnement/rendement, des pièces, accessoires ou service, composer le : 1-800-253-1301 Au Canada, pour assistance, installation ou service, composer le : 1-800-607-6777 Les hottes de cuisine résidentiell...
INSTRUCTIONS D’INSTALLATION AVERTISSEMENT Risque de choc électrique Déconnecter la source de courant électrique avant l’installation de l’interrupteur d’éclairage.Effectuer la mise à la terre de la hotte de cuisine et de l’interrupteur d’éclairage en reliant le fil de terre à la vise de mise à la te...
