Whirlpool WFG320M0BW2 - Installation Manual

Page 2 - RANGE SAFETY; You; DANGER

2 RANGE SAFETY You can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don't follow All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what canhappen if the instructions are n...

Page 3 - INSTALLATION REQUIREMENTS; Tools and Parts; Tools needed; WARNING

3 INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed Parts supplied Check that all parts are included. ■ Literature bag ■ Conversion orifice spuds (inside bag c...

Page 4 - Location Requirements; Mobile Home - Additional Installation Requirements; Mobile home installations require:; Product Dimensions

4 Location Requirements IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. ■ It is the installer’s responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on...

Page 5 - Cabinet Dimensions; Electrical Requirements; Electrical Shock Hazard

5 Cabinet Dimensions Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. If the cabinet depth is greater than 24" (61.0 cm), oven frame must extend beyond cabinet fronts by ½" (13.0 mm) min...

Page 6 - Gas Supply Requirements; Type of Gas; Flexible metal appliance connector:; Gas Pressure Regulator; Explosion Hazard

6 Gas Supply Requirements Observe all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1 - latest edition or CAN/CG...

Page 7 - INSTALLATION INSTRUCTIONS; Unpack Range; Install Anti-Tip Bracket; Excessive Weight Hazard; Tip Over Hazard

7 Burner Input Requirements Input ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m). For elevations above 2,000 ft (609.6 m), ratings are reduced at a rate of 4% for each 1,000 ft (304.8 m) above sea level (not applicable for Canada). Gas Supply Pressure Test...

Page 8 - Make Gas Connection; Typical flexible connection

8 3. Determine and mark centerline of the cutout space. The mounting can be installed on either the left side or right side of the cutout. Position mounting bracket against the wall in the cutout so that the V-notch of the bracket is 9 ⁵⁄₈ " (24.6 cm) from centerline as shown. 4. Drill two ¹⁄₈ &...

Page 9 - Complete Connection; Verify Anti-Tip Bracket Is Installed and

9 Complete Connection 1. Locate gas pressure regulator in the back of the range. IMPORTANT: Do not remove the gas pressure regulator. 2. Check that the gas pressure regulator shutoff valve is in the “ON” position. IMPORTANT: The factory default setting is the “ON” position. If the range does not wor...

Page 10 - Initial lighting and gas flame adjustments

10 3. If the rear of the range lifts more than ½" (1.3 cm) off the floor without resistance, stop tilting the range and lower it gently back to the floor. The range foot is not engaged in the anti-tip bracket. IMPORTANT: If there is a snapping or popping sound when lifting the range, the range m...

Page 12 - Complete Installation; If range does not operate, check the following:; If you need Assistance or Service:; GAS CONVERSIONS; LP Gas Conversion

12 Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. Check that the range is level. See the “Level Range” sec...

Page 13 - To Convert Gas Pressure Regulator; To Convert Surface Burners

13 To Convert Gas Pressure Regulator 1. Open broiler door and remove broiler rack. The gas pressure regulator is located in the back right hand corner of the broiler compartment. IMPORTANT: Do not remove the gas pressure regulator. NOTE: Do not remove the spring beneath the cap. 2. Remove the cap fr...

Page 14 - To Convert Oven Burner; Complete Conversion

14 NOTE: The range cooktop is equipped with 4 burners: 2 burners are power (front), 1 burner is standard (left rear), and 1 is simmer (right rear). 5. Place the Natural gas orifice spuds in the parts bag for future use and keep with the bag containing literature. 6. Reinstall burners, burner caps an...

Whirlpool WFG320M0BW2 - Installation Manual

Table of Contents:

Other Manuals for Whirlpool WFG320M0BW2

Summary

Other Whirlpool Models