Whirlpool WFE505W0HB - User Manual

30" (76.2 cm) Freestanding Electric Range

PRODUCT MODEL NUMBERS

WFC110
WFC120
WFC130
WFC150
WFC310
WFC315
WFC340
WFE320

WFE330
WFE505
WFE510
WFE515
WFE520
WFE524
WFE525
WFE530

WFE540
WFE550
WFE710
WFE714
WFE720
WFE745
WFE770
WFE905
WFI910

Because Whirlpool Corporation includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

Ref. W10403811C

04/17/2017

PRODUCT DIMENSIONS

Electrical:

To properly install your range, you must determine the type

of electrical connection you will be using and follow the instructions

provided for it here.

■

Range must be connected to the proper electrical voltage and

frequency as specified on the model/serial number rating plate. The

model/serial number rating plate is located on the left-side frame

behind the storage drawer panel or behind the top right side of the

oven door. Refer to the figures in the “Product Dimensions” section of

the “Location Requirements” section.

■

This range is manufactured with the neutral terminal connected to

the cabinet. Use a 3-wire, UL Listed. 40- or 50-amp power supply

cord (pigtail) (see following Range Rating chart). If local codes do not

permit ground through the neutral, use a 4-wire power supply cord

rated at 250 volts, 40 or 50 amps and investigated for use with ranges.

Range Rating*

Specified Rating

of Power Supply

Cord Kit and

Circuit Protection

120/240 Volts

120/208 Volts

Amps

8.8 – 16.5 KW

7.8 – 12.5 KW

40 or 50 **

16.6 – 22.5 KW

12.6 – 18.5 KW

50

* The NEC calculated load is less than the total connected load listed on

the model/serial rating plate.

** If connecting to a 50-amp circuit, use a 50-amp rated cord with a kit.

For 50-amp rated cord kits, use kits that specify use with a nominal

1

3

/

8

" (34.9 mm) diameter connection opening.

■

A circuit breaker is recommended.

A

B

C

D

E

F

A. 27

3

/

4

" (70.5 cm) max. depth with handle

B. 46

7

/

8

" (119.1 cm) overall height (max.) with leveling legs screwed all

the way in*

C. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed all the

way in*

D. 29

7

/

8

" (75.9 cm) width

E. 25

5

/

16

" (64.3 cm) depth – back of range to front of cooktop**

F. Model/serial rating plate (located on the left-side frame behind

storage drawer or right side of frame behind the oven door)

IMPORTANT:

Range must be level after installation. Follow the

instructions in the “Level Range” section. Using the cooktop as a

reference for leveling the range is not recommended.
* Range can be raised approximately 1" (2.5 cm) by adjusting the

leveling legs.

** Front of door and drawer may extend further forward depending on

styling.

CABINET OPENING DIMENSIONS

Cabinet opening dimensions shown are for 25" (64.0 cm) countertop

depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop

height.

IMPORTANT:

If installing a range hood or microwave hood combination

above the range, following the range hood or microwave hoods

combination instructions for dimensional clearances above the cooktop

surface.
A freestanding range may be installed next to combustible walls with

zero clearance.
*

NOTE:

24" (61.0 cm) minimum when bottom of wood or metal cabinet

is covered by not less than 1/4" (6.4 mm) flame retardant millboard

covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)

stainless steel, 0.024" (0.6 mm) aluminum or 0.020” (0.5 mm) copper.

A

B

D

F

E

C

A. 13" (33.0 cm) max.

upper cabinet depth

B. 30" (76.2 cm) min.

opening width

C. For minimum clearance

to top of cooktop, see

NOTE*

D. 30

1

/

8

" (76.5 cm) min

opening width

E. Outlet – 8" (20.3 cm)

to 22" (55.9 cm) from

either cabinet, 5

1

/

2

"

(14.0 cm) max. to floor

F. Cabinet door or hinges

should not extend into

the cutout