WEN 20121 - User Manual

GENERAL SAFETY RULES 7. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. POWER TOOL USE AND CARE 1. Do not force the power tool. Use the correct power tool fo...

HAMMER DRILL SAFETY 1.Work Environment. Do not operate the tool in wet or damp conditions; doing so significantly increases the risk of electrical shock. Do not operate the tool in the presence of flammable liquids or gases. 2. Personal Safety . Always wear ANSI Z87.1-approved glasses, hearing prote...

ELECTRICAL INFORMATION (CHARGER) AMPERAGE REQUIRED GAUGE FOR EXTENSION CORDS 25 ft. 50 ft. 100 ft. 150 ft. 2A 18 gauge 16 gauge 16 gauge 14 gauge IMPORTANT: Servicing a double-insulated product requires extreme care and knowledge of the system, and should be done only by qualified service personnel ...

• Avoid dangerous environments – Do not charge the battery pack in rain, snow or in damp or wet locations. Do not use the battery pack or charger in the presence of explosive atmospheres (gaseous fumes, dust or flam- mable materials) because sparks may be generated when inserting or removing the bat...

BATTERY & CHARGER SAFETY WARNINGS ABOUT THE BATTERY 1. The battery pack has to be charged completely before you use the tool for the first time.2. For optimum battery performance, avoid low discharge cycles by charging the battery pack frequently.3. Lithium-ion batteries are subject to a natural...

Accessories Components UNPACKING & PACKING LIST UNPACKING Carefully remove the hammer drill from the packaging and place it on a sturdy, flat surface. Make sure to take out all contents and accessories. Do not discard the packaging until everything is removed. Check the packing list below to mak...

KNOW YOUR HAMMER DRILL TOOL PURPOSE From driving fasteners to drilling holes in wood, metal, masonry, and more, your WEN Hammer Drill has your back. Refer. Refer to the following diagrams to become familiarized with all the parts and controls of your hammer drill. The components will be referred to ...

1 OPERATION POWER TRIGGER ACTION 1. Turn the drill on by pressing the power trigger (Fig. 1 - 1). The trigger is pressure sensitive, meaning that pushing the trigger down farther pro- duces a higher torque and speed in comparison to pushing it lightly.2. Use the direction of rotation switch (Fig. 2A...

OPERATION CHUCK Your drill is equipped with a single sleeve keyless chuck (Fig. 5 - 1), so you can quickly change bits with no extra tools required. To install bits, place the direction of rotation switch in the OFF position and unplug the battery from the tool. Rotate the chuck’s body counterclockw...

MAINTENANCE ROUTINE INSPECTION 1. Before each use, inspect the general condition of the tool. Check for: • Loose hardware, • Misalignment or binding of moving parts, • Damaged cord/electrical wiring, • Cracked or broken parts, and • Any other condition that may affect its safe operation.2. After eve...

EXPLODED VIEW & PARTS LIST NOTE: Not all parts may be available for purchase. Parts and accessories that wear down over the course of normal use are not covered under the warranty. 15

EXPLODED VIEW & PARTS LIST No. Part No. Description Qty. 1 Right Battery Housing 1 2 20202 Battery 1 3 20200C Charger 1 4 Battery Terminal 1 5 Hex Nut, M4 2 6 Directional Adjustment Switch 1 7 Right Housing 1 8 Screw, ST3x13 8 9 Label 2 10 Chuck Screw, M5x20 (LH) 1 11 Chuck 1 12 Gearbox Assembly...

WARRANTY STATEMENT WEN Products is committed to building tools that are dependable for years. Our warranties are consistent with this commitment and our dedication to quality. LIMITED WARRANTY OF WEN PRODUCTS FOR HOME USE GREAT LAKES TECHNOLOGIES, LLC (“Seller”) warrants to the original purchaser on...