Weber 675 - Manual
Weber 675 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALL GAS SUPPLY; Gas line piping; Test connections; DANGER; Do not use an open flame to ch e ck for gas; READ CAREFULLY BEFORE INSTALLATION
- Page 3 – BUILT-IN CONSTRUCTION GENERAL INFORMATION; WARNING
- Page 5 – BUILT-IN SLEEVE GAS LINE
- Page 6 – SUPPLIES NEEDED
- Page 7 – ADD COOKING MODULE
- Page 9 – ADD COOKING GRATES
- Page 10 – BASKET
- Page 11 – INSTALL BOTTOM TRAY
- Page 12 – CHECK FOR GAS LEAKS; The gas connections of your Weber Gas
- Page 14 – R E I N S TALL FRONT PA N E L
- Page 15 – INSTALL TOOL HOLDERS
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
WARNING: F o l l ow all leak ch e ck pro c e d u r e s
carefully in this manual prior to barbecue
operation. Do this even if barbecue was
dealer assembled.
WARNING: Do not try to light this
appliance without reading "Lighting"
instructions section of this manual.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
FOR YOUR SAFETY
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame .
3. Open lid.
4. If odor continues, immediately call your
gas supplier or your fire department.
FOR YOUR SAFETY: Do not store or use
gasoline or other flammable vapors and
liquids in the vicinity of this or any other
appliance.
S U M M I T
™
475 & 675
Step-By-Step Guide
Natural Gas Barbecues
Summit 475 NG
Summit 675 NG
97822
3/97
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INSTALL GAS SUPPLY Gas line piping ■ If the length of line required does not exceed 50 feet,use a 5/8" O.D. tube. One size larger should be usedfor lengths greater than 50 feet. ■ Gas piping may be copper tubing, type K or L;polyethylene plastic tube, with a minimum wallthickness of .062 inch; o...
3 3 BUILT-IN CONSTRUCTION GENERAL INFORMATION WARNING A Weber-Stephen Products Co. insulated s l e eve must be used for any bu i l t - i ninstallation. CLEARANCE FROM COMBUSTIBLE SURFACES ORSTRUCTURES Warning: Clearance from the outside walls of thesides and back of the insulated sleeve must be amin...
5 BUILT-IN SLEEVE GASLINE LOCATIONS 475 675 Tolerances A 5.0” 5.0” B 10.1” 10.1” C 2.5” 2.5” + 1 ⁄ 16 - 1 ⁄ 16 + 1 ⁄ 16 - 1 ⁄ 16 + 1 ⁄ 32 - 1 ⁄ 32 BUILT-IN SLEEVE GAS LINE LOCATIONS The dimensions shown indicate the location of the gasline inlet flange in the insulated sleeve. The supportmembers of ...
