Wayne P250AF-EP - Manual

Wayne P250AF-EP – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – VISUAL INSPECTION OF THE HEATING SYSTEM; Water
Page 3 – FLUE PIPE AND CHIMNEY; company should be consulted.; INSPECTION OF HEATING APPLIANCE; and draft hood to the sizes shown in the table.; FIGURE 1
Page 5 – Draft Hood and; PREPARATION OF COMBUSTION CHAMBER
Page 7 – sizes shown. To determine the actual input of the burner:; FIGURE 5
Page 8 – ELECTRICAL WIRING; operation. Verify proper operation after servicing.; LIMIT CONTROL SWITCHES; installation and adjustment of the room thermostat.; GAS PIPING
Page 9 – Be sure to relight all the gas pilots on other appliances.; PURGING; Nominal Diameter of Pipe in Inches
Page 10 – ADJUSTMENT OF BURNER; Set thermostat below room temperature.; STANDING PILOT; FIGURE 9
Page 11 – P265DI - JUNCTION BOX ROTATED
Page 12 – IMPORTANT; fire must be maintained.; BEST LOCATIONS FOR GAS
Page 13 – GENERAL INSTRUCTION; flammable vapors and liquids.; TROUBLE CHART; PILOT DOES NOT LIGHT
Page 15 – SEQUENCE OF OPERATION; TRIAL FOR
Page 16 – START
Page 17 – ) Turn the gas valve control knob to “OFF”, wait five minutes.; P250AF DIRECT SPAR ELECTRODE LOCATION
Page 19 – Temperatures
Page 24 – Notes

Loading the manual

WAYNE COMBUSTION SYSTEMS

801 GLASGOW AVE.

FORT WAYNE, IN 46803

ELECTRIC SHOCK HAZARD

OVERHEATING HAZARD

HIGH VOLTAGES ARE PRESENT IN THIS EQUIPMENT.
FOLLOW THESE RULES TO AVOID ELECTRIC SHOCK.

Use only a properly grounded circuit. A ground fault
interrupter is recommended.

Do not spray water directly on burner.

Turn off power before servicing.

Read the owner’s manual before using.

SHOULD OVERHEATING OCCUR:

Shut off the manual gas valve to the appliance.

Do not shut off the control switch to the pump or blower.

SPECIFICATIONS

FOR YOUR SAFETY

IF YOU SMELL GAS:

1. OPEN WINDOWS
2. DON’T TOUCH ELECTRICAL SWITCHES
3. EXTINGUISH ANY OPEN FLAME
4. IMMEDIATELY CALL YOUR GAS

SUPPLIER.

THESE INSTRUCTIONS SHOULD BE AFFIXED TO THE
BURNER OR ADJACENT TO THE HEATING APPLIANCE.

MODELS

P250AF

P265

P250AF-EP

P265F

P250AF-DI

P265-EP
P265-EP

GAS BURNER

Publication Date 5/01 - Revision B - Manual 101220

NOTE: Dimensions in ( ) are informational only. English values take priority.

WARNING: If the information in these
instructions is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or death.

Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light the appliance.
• Do not touch any electrical switch; do not use any

phone in your building.

• Immediately call your gas supplier from a neighbor’s

phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire

department.

Installation and service must be performed by a qualified
installer, service agency or the gas supplier. Warranty is
voided if not installed by qualified service person.

CARBON MONOXIDE IS A COLORLESS, ODORLESS GAS
THAT CAN KILL. FOLLOW THESE RULES TO CONTROL
CARBON MONOXIDE.

Do not use this burner if in an unvented, enclosed area. Carbon
monoxide may accumulate.

Do not adjust the pressure regulator. High pressures produce
carbon monoxide.

Check flue gases for carbon monoxide. This check requires
specialized equipment.

Allow only qualified burner service persons to adjust the burner.

Special instruments and training are required.

Read the owner’s manual before using.

CARBON MONOXIDE

POISONING HAZARD

NOTICE

BURNER MODELS

MINIMUM INPUT

MAXIMUM INPUT

FUELS

P-250AF & P-250AF-EP & P250AF-DI

50,000 BTU/HR (14.65 kW/Hr)

250,000 BTU/Hr (73.27 kW/Hr)

Natural & L.P. Gas

P-265 & P-265-EP

65,000 BTU/HR (19.05 kW/Hr)

200,000 BTU/Hr (58.61 kW/Hr)

Natural & L.P. Gas

P-265-F & P-265F-EP

65,000 BTU/HR (19.05 kW/Hr)

200,000 BTU/Hr (58.61 kW/Hr)

Natural & L.P. Gas

ELECTRICAL

Power Supply - 115V/60HZ 1 Ph.

MOUNTING:

Adjustable Flange is Standard

Pedestal Mount is Optional.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - VISUAL INSPECTION OF THE HEATING SYSTEM; Water

1 These instructions were prepared for the guidance of those installing this particular gas conversion burner. While thy apply in principle to all installations, they should not be interpreted as meaning the only safe and economical way to install a conversionburner. It may be necessary to deviate f...

Page 3 - FLUE PIPE AND CHIMNEY; company should be consulted.; INSPECTION OF HEATING APPLIANCE; and draft hood to the sizes shown in the table.; FIGURE 1

2 FLUE PIPE AND CHIMNEY The flue pipe should be carefully inspected and replaced if necessary in connection with installation of a draft hood. All installations must operate with a negative draft overfire. Refer to your local gas company or codes for assistance or to thefurnace and/or boiler manufac...

Page 5 - Draft Hood and; PREPARATION OF COMBUSTION CHAMBER

4 PREPARATION OF FURNACE OR BOILER Clean combustion chamber thoroughly. Scrape and brush all heating surfaces and flue ways. Soot and fly ash are excellent insulators and unless removed the efficiency of the heating plant will be impaired. Plugged or restricted flue passages willprevent burner from ...