Vulcan GCO2C ML-114571 - Manual

Page 2 - I m p r o p e r i n s t a l l a t i o n , a d j u s t m e n t ,

– 2 – IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GASE Q U I P M E N T , W H O S H O U L D P E R F O R M T H E I N I T I A L F I E L D S T A R T - U P A N DADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTION...

Page 3 - KEEP THIS MANUAL FOR FUTURE REFERENCE; GENERAL; furnished with five racks additional oven racks are optional.; INSTALLATION; UNPACKING; Do not use the door or its handle to lift the oven.; LOCATION

– 3 – INSTALLATION, OPERATION AND CARE OF GCO2D & GCO2C GAS CONVECTION OVENS KEEP THIS MANUAL FOR FUTURE REFERENCE GENERAL Model GCO2D Gas Convection Oven is a single cavity oven, featuring a solid state temperature controland 1-hour dial timer. Model GCO2C features a programmable controller. Ea...

Page 4 - C O N N E C T

– 4 – INSTALLATION CODES AND STANDARDS In the United States of America: 1. State and local codes. 2. National Fuel Gas Code, ANSI/Z223.1/NFPA #54 (latest edition). Copies may be obtained from The American Gas Association, Inc., Accredited Standards Committee Z223 @ 400 N. Capital St. NW,Washington, ...

Page 6 - The 120 volt models are equipped with a cord and plug.

– 6 – LEVELING Once the oven is in its permanent position, place a carpenter's level on the oven rack. If the oven is installedon legs, turn the adjustable feet in or out to level oven front-to-back and side-to-side. If the oven is installedon casters, loosen set screws and turn casters in or out to...

Page 8 - Vapor Removal from Cooking; OPERATION

– 8 – PL-52225 ON HEAT IGNITION TIMER ON OFF GAS VALVE GAS VALVE THERMOSTAT TO SHUT OVEN OFF PLACE MASTER SWITCH IN"OFF" POSTION TURN GAS VALVE OFF ;; ;; TO SHUT OVEN OFF PLACE MASTER SWITCH IN"OFF" POSTION TURN GAS VALVE OFF ;; ; ; ;; ;; ;; MASTER SWITCH ; ; ON OFF OVENCOOL ; ; ; ON...

Page 10 - CONTROLS — MODEL GCO2C Built before October 1999; THERMOSTAT CONTROL

– 10 – CONTROLS — MODEL GCO2C Built before October 1999 (Fig. 6) Fig. 6 THERMOSTAT CONTROL Temperature Display (When not timing product). Displays set cook temperature while the light in the Roast Button is lit. Will be overridden to display actual cavity temperature for 8 seconds when Thermometer B...

Page 14 - MENU SELECT; MENU; CONTROLS — MODEL GCO2C Built after October 1999; PRIMARY; SECONDARY; SET

– 14 – 1 2 SET PRIMARY SECONDARY MENU SELECT MODE R & H READY OVEN HEATING OVEN POWER ROAST & HOLD ON ON NO IGNITION OFF OFF COOL OVEN MENU RACK 3 4 5 PL-53543 6 5 START STOP 4 3 2 1 CONTROLS — MODEL GCO2C Built after October 1999 Always displays [HR:Min] when setting the time. Displays [HR:...

Page 17 - ROAST AND HOLD OPERATION — GCO2C OVEN; PROPER UTENSILS; Turn off unused equipment.; OPERATING HINTS

– 17 – ROAST AND HOLD OPERATION — GCO2C OVEN Roast and Hold cooks the product in two stages. During First Stage Cooking, the oven temperature isregulated by the Roast thermostat for the amount of time set on the Timer. After the lapsed time countsdown to 00:00, Second Stage Cooking begins. During Se...

Page 18 - CLEANING; Clean outside of the oven daily by wiping with a clean damp cloth.; Optional Stainless Steel Oven Interior; Product; SUGGESTED COOKING GUIDELINES — MODELS GCO2D AND GCO2C; BAKED PRODUCTS

– 18 – CLEANING D i s c o n n e c t t h e e l e c t r i c a l p o w e r t o t h e m a c h i n e a n d f o l l o w l o c k o u t / t a g o u t procedures. Clean outside of the oven daily by wiping with a clean damp cloth. Clean porcelain oven interior daily with soap or detergent and water. Rinse tho...

Page 19 - FOR BEST RESULTS

– 19 – FOR BEST RESULTS Product to be cooked should be centered on the oven rack, and the racks should be spaced evenly insidethe oven. It is best not to rotate the product or open the door during the cooking cycle. Preheat the oven to 50 F° (28 C°) higher than desired cooking temperature. After the...

Page 20 - MAINTENANCE; LUBRICATION; TROUBLESHOOTING; • Turn oven off for 5 minutes before attempting to re-light.; SERVICE AND PARTS INFORMATION

– 20 – FORM 30975 Rev. D (12-07) PRINTED IN U.S.A. MAINTENANCE T h e o v e n a n d i t s p a r t s a r e h o t . U s e c a r e w h e n o p e r a t i n g , c l e a n i n g o r s e r v i c i n g t h e o v e n . D i s c o n n e c t t h e e l e c t r i c a l p o w e r t o t h e m a c h i n e a n d f o l...

Vulcan GCO2C ML-114571 - Manual

Table of Contents:

Summary

Other Vulcan Models