Vulcan ECO6C ML-52505 - Manual

– 5 – 3. Mount the oven on top of the stand or cabinet (Fig. 1). Assembling the Chimney and Flue Extension Remove the oven chimney and flue extension from the rear of the oven (motor compartment) and use the screwsprovided to fasten the chimney to the top rear of the oven. The flanges on the chimney...

– 6 – CASTERS If the oven is to be installed on casters, assemble the casters to the legs provided. Place the locking casters onthe front legs and non-locking casters on the rear legs. ASSEMBLING STACKED OVENS 1. Unpack the ovens and stack kit. Position one oven on its back for access to the oven bo...

– 7 – Electrical Connections WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES. WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKI...

– 8 – PL-51827 OFF ON TURN GAS VALVE "ON" PUSH MASTER SWITCH TO "ON" POSTION. IF OVEN DISCONNECT SUPPLY BEFORE CHANGING FUSES, CLEANING OR ANY OTHER SERVICE 15 AMP CLASS G FUSES WARNING ; ; ;; ;; ;; ;; ; ; ; ON ; OFF ; ON ; OFF ; OFF ; THERM OSTAT ;; PUL L TO OPEN VEN T ;; HI ; LOW ;...

– 9 – 2-SPEED MOTOR — LO / HI — Adjusts air velocity in the oven. Use the HI setting as the usual operatingspeed and the LO setting for delicate product like meringue which might beblown around in the oven. FUSE HOLDERS — Replace fuses with appropriate type described on control panel. MOISTURE VENT ...

– 10 – PL-51829 TURN GAS VALVE "ON" PUSH MASTER SWITCH TO "ON" POSTION. IF OVEN DISCONNECT SUPPLY BEFORE CHANGING FUSES, CLEANING OR ANY OTHER SERVICE 15 AMP CLASS G FUSES WARNING ; ; ;; ;; ;; ;; ; ; HEAT HOLD ROAST READY BAKE TIME HI LOW OFF ON POWER OVEN DOWN TIME TIME TIME TIME TE...

– 15 – Cooking 1. Open doors and load the product into the oven. Place pans in the center of the racks. Close doors. 2. Set Roast temperature and time. Set Hold temperature and Gentle Bake time, if desired. Gentle Bake timemay not be more than roast time. Gentle Bake will cycle the fan during the se...

– 16 – 400ºF 300ºF 200ºF 100ºF ROAST AND HOLD DIAGRAM - Time vs. Temperature SHORT BEEP.TIMER DISPLAY FLASHES 00:00.ROAST THERMOSTAT OFF.HEATERS OFF UNTIL HOLDTEMPERATURE IS REACHED. LONG BEEP (20 SEC.)HEATERS MAINTAINHOLD TEMPERATURE.TIMER DISPLAY COUNTS UPHOLD TIME AND FLASHES"HOLD." OVEN ...

– 17 – COOKING GUIDELINES — MODELS ECO4S AND ECO4D/ECO6D OVENS PRODUCT TEMPERATURE TIME NUMBER OF RACKS °F (°C) (MIN.) BREAD PRODUCTS Bread (24, 1-lb. loaves) (454 gr.) 340 (171) 30 3 (every other rack starting with bottom rack) Hamburger Rolls 300 (149) 15 5 Corn Bread 335 (168) 25 5 Yeast Rolls 32...

– 18 – TIMER SETTINGS FOR ROLLED BEEF ROASTS — MODEL ECO4C/ECO6C OVENS ROAST TEMPERATURE 200°F (93°C) 250°F (121°C) 300°F (149°C) HOLD TEMPERATURE 140°F (60°C) DONENESS RARE MEDIUM RARE MEDIUM RARE MEDIUM WEIGHT OF ROAST POUNDS HOURS:MINUTES 8 2:40 3:45 1:45 2:20 1:20 1:40 9 2:50 3:58 1:50 2:25 1:25...

– 19 – POWER OUTAGE In case of a power outage, the oven will automatically shut down. When power is restored to the lines, the ovenwill resume its normal operation. However, if the oven is to be left unattended during a power outage, push themaster switch to the OFF position. When power is restored ...

– 20 – FORM 30932 Rev. C (2-99) PRINTED IN U.S.A. MAINTENANCE WARNING: TURN OVEN OFF AND UNPLUG POWER SUPPLY CORD BEFORE PERFORMING ANY MAINTENANCE. The fan motor comes with sealed bearings and requires no lubrication. Annually check the flue, when cool, to be sure it is free of obstructions. REPLAC...