Vulcan 1048C ML-103839 - Manual

Vulcan 1048C ML-103839 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – COOLING FANS; PARTS REPLACEMENT
Page 3 – COMPONENT REPLACEMENT
Page 4 – COMPONENT LOCATION DRAWING; COMPONENT LOCATION (VIEW OF LEFT SIDE WITH COVER REMOVED)
Page 5 – TROUBLESHOOTING; DISCONNECT THE ELECTRICAL POWER TO THE MACHINE AND; IF THE UNIT BLOWS A FUSE OR TRIPS A CIRCUIT BREAKER; an open circuit breaker.; IF THE COOLING FAN DOES NOT RUN
Page 6 – HEATERS
Page 9 – RECOMMENDED SPARE PARTS LIST

Loading the manual

– 1 –

1024, 1036, 1048 CHEESEMELTER

MODELS

1024C

ML-103833

1024W

ML-103834

1024P

ML-103835

1036C

ML-103836

1036W

ML-103837

1036P

ML-103838

1048C

ML-103839

1048W

ML-103840

1048P

ML-103841

SERVICE &

PARTS MANUAL

FORM 31087 Rev. B (June 2006)

Model 1036W

For additional information on Vulcan-Hart or to locate an authorized parts

and service provider in your area, visit our website at www.vulcanhart.com

VULCAN-HART
DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC
WWW.VULCANHART.COM

P.O. BOX 696, LOUISVILLE, KY 40201-0696

TEL. (800) 814-2028

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - COOLING FANS; PARTS REPLACEMENT

– 2 – HEATER (Fig. 1) 1. Push one end of the heater into one socket as far as it will go. 2. Swing the other end of heater up until it lines up with the opposite socket. 3. Release heater and it will snap into place. 4. Grasp the heater and move it back and forth to ensure that it is centered correc...

Page 3 - COMPONENT REPLACEMENT

– 3 – COMPONENT REPLACEMENT 1. Remove the access panel on the left side. 2. Remove all screws holding down the cover. 3. Lift cover straight up. Replacement of the voltage regulator, actuating switch, main terminal block, or the contactor (1048only) will require removing the component mounting plate...

Page 4 - COMPONENT LOCATION DRAWING; COMPONENT LOCATION (VIEW OF LEFT SIDE WITH COVER REMOVED)

– 4 – COMPONENT LOCATION DRAWING COMPONENT LOCATION (VIEW OF LEFT SIDE WITH COVER REMOVED) PL-53527 SOCKETS CONTACTOR (1048) PILOT LIGHT ACTUATING SWITCH COOLING FAN NYLON LOOP TERMINAL BLOCK GROUND STUD VOLTAGE REGULATOR SWITCH COMPONENT MOUNTING PLATE