Vintec V40BVCBK - User Manual

Page 2 - small quantity of

1 WARNING The information in this document is subject to modification without any prior notice . VINTEC offers no guarantee for our Beverage Center if it is being used for any purpose other than that for which it was specifically designed. VINTEC cannot be held responsible for any error in this manu...

Page 4 - Grounding instructions; Beverage Center must be leveled BEFORE loading; VINTEC

3 The Beverage Center should be placed where the ambient temperature is between 5ºC to 35ºC. If the ambient temperature is above or below this range, the performance of the unit may be affected. Placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The ide...

Page 5 - TURNING ON YOUR BEVERAGE CENTER; Plug in and switch on the unit by pressing on the power button

4 IMPORTANT - THIS SPACER MUST BE ATTACHED TO THE UNIT BEFORE INSTALLATION FOR VENTILATION PURPOSE. FAILURE TO DO SO VOIDS THE WARRANTY TURNING ON YOUR BEVERAGE CENTER Plug in and switch on the unit by pressing on the power button for a few seconds. When you use the Beverage Center for the first tim...

Page 6 - Operating Noises; To reach the desired temperature settings,; Beverage Center, like all Beverage; LOADING YOUR BEVERAGE CENTER; Center to tilt forward.

5 Operating Noises To reach the desired temperature settings, VINTEC Beverage Center, like all Beverage Center operating with compressors and fans, may produce the following types of noises. These noises are normal and occur as follows: - Gurgling sound, caused by the refrigerant flowing through the...

Page 7 - TYPES OF REGULATION; Beverage Center

6 TYPES OF REGULATION Please note that depending on the loading and settings chosen it takes 24hours for the Beverage Center to see the temperature stabilizing. During this time LED seems to move erratically. It is a normal process. This process occurs whenever the setting is modified and/or wheneve...

Page 9 - REVERSIBILITY OF THE DOOR; Lock screws; While holding the door firmly,; remove the three lock screws (2) from the lower

8 REVERSIBILITY OF THE DOOR Warning: To avoid accident during the process of changing the door, we recommend that you get assistance. Door is heavy and may cause injury if dropped. According the model and the type of handle your beverage cabinet is equipped with, such as long strait bar handle , the...

Page 10 - INSTALLATION INSTRUCTIONS AND DRAWINGS

9 INSTALLATION INSTRUCTIONS AND DRAWINGS 1. Wine Cabinet dimensions : Height 820mm – 860mm (40mm adjustable feet) Width 595mm Depth 571mm 2. This wine cabinet is not designed to be fully integrated behind a joinery door. 3. Please note that a minimum cut out of 615mm is required to facilitate instal...

Page 11 - VINTEC’s; considered as null and void.

10 Dimensional drawings: OPERATION ANOMALIES Ensure that there is power to the electrical supply plug by connecting another electrical appliance to it. Check fuse, if any. Make sure that the door is closed properly. If your beverage center appears to be malfunctioning, unplug it and contact your VIN...

Page 13 - Models; Gas charge quantity

12 Technical data Models 40BVC （（（（ R134a ）））） AL-V40BVC （（（（ R600a ）））） Capacity355ml 126 126 Net capacity 137L 137L Gas charge quantity 55grams 35 grams Pre-set temp in degrees 5 5 Adjustable temp in degrees 2-10 2-10 Power Input 140W 100 W Heater -- -- Freestanding or Built-in Built-i...

Vintec V40BVCBK - User Manual

Table of Contents:

Summary

Other Vintec Refrigerators Models