Ultra Start 2250M - Manual
Ultra Start 2250M – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – To Enter Diagnostic Mode:; Clear Diagnostic Memory.; DIAGNOSTICS; PARK LIGHTS STATUS LED DIAGNOSTIC CODE; NSTALLATION; WIRING DIAGRAM
- Page 3 – Blue; SIDE VIEW; ACTIVE RF ANTENNA; Jumpers; Note: The default setting is second ignition.; Status Led’s; **The antenna must be connected before the system will operate
- Page 4 – . Check for obstructions on both; Components; INSTALLATION GUIDE; INSTALLATION TIPS
- Page 5 – 4 Pin Connector; Pin Power Connector
- Page 6 – PROGRAMMING
- Page 7 – QUICK START INSTALL; Programming Overview; as listed on pages 8 -; SYSTEM RESET; - Press and release the Program Button.; The system is now re-set to factory defaults.
- Page 8 – Note: See Setting 7 to adjust the door lock pulse duration to 125ms.
- Page 11 – Press button; times; During countdown; on; After full alarm; ENSURE THAT USER IS FULLY TRAINED ON THIS FEATURE!
- Page 12 – OPERATIONS
- Page 13 – ACTIVATING SERVICE MODE; locks and trunk release are still operational.; DEACTIVATING SERVICE MODE; Remote start functions will return to normal operation.; System Service Mode; SERVICE MODE ACTIVATED; ) for 6 seconds until Status LED comes on Steady; SERVICE MODE DEACTIVATED; ) for 6 seconds until Status LED turns off.; LIMITED LIFETIME WARRANTY
- Page 14 – PANIC MODE DISABLE; Times if programmed for safety start
- Page 15 – Remote Stop; To Cancel Timer Mode:; Press and release the; Note: Opening a door after this point will cancel Reservation Mode.; Press and release the
- Page 16 – Starter Kill with Bypass Units (Transponder or Passlock); Ignition
FCC/ID Notice
This device complies with Part 15 of the FCC rules. Operation is
subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the
part responsible for compliance void the user’s authority to operate
this devise.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2250 Wiring Diagram Page 3Pre-Installation Page 4 Components Recommended Pre-Installation ProceduresRecommended Install Procedures Wire Connectors Page 5 6 Pin Connector14 Pin Connector3 Pin Red Connector4 Pin Blue Connector Jumper Selections Installation Page 6 Basic Installation - Quick startPlugg...
YELLOW WHITE/BLUE BLACK BROWN RED/WHITE PURPLE BLUE/WHITE PINK BLACK/WHITE BLUE WHITE GREEN/WHITE GREEN ORANGE 4 PIN Blue SIDE VIEW ACTIVE RF ANTENNA Jumpers The jumpers control the output on the white wire from the six pin harness. Place the jumpers in the above order to change the output. Note: Th...
Recommended Pre-Installation Procedures - Control module - Remote transmitter(s) - Antenna with built in program button and LED’s - 6 pin main harness with dual 30amp power inputs - 14 pin harness - 3 pin - 2 wire keyless entry harness - Multi-tone siren - Hood pin safety switch - Hood and window st...
