Ultra Start 1150 Series - Manual
Ultra Start 1150 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION MANUAL; REMOTE VEHICLE STARTER; Diagnostics
- Page 4 – Pin Power Connector; Second Ignition; WIRING CONNECTIONS
- Page 5 – Your Basic Install Is Complete!; Step 1 - Connect All Of the Following Wires; QUICK START INSTALL
- Page 6 – Programming Overview; Leave in the “ON” position.; It will not be possible to enter the Program Modes.; Program Mode; Press & release the; Program Button; the correct number of times to select the desired; Bold Text; preformed when the tach setting is to be re-learned.; The System is now re-set to the factory default settings.
- Page 7 – Flashes; Setting 1- Special Door Lock/ Unlock Operations; Programming Menu
- Page 8 – Tach Detection Mode; Pulse Once; Flashes; to select setting 9 (This will be confirmed by 9 LED flashes); change selection; Setting 6- Tach Selection; - Enter Program Mode; to select setting 5 (This will be confirmed by 5 LED flashes); Press and hold the Program Button
1150 Series Remote Starters
-The system must be placed into Service Mode before any service work is started on
the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done.
The manufacturer accepts no liability or responsibility for accidental starting of the
vehicle.
- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)
REMOTE STARTERS
ü
CAR ALARMS
INSTALL GUIDE
WWW.ULTRASTARTERS.COM
U.S.A. Model
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
INSTALLATION MANUAL REMOTE VEHICLE STARTER Page 2 If the remote starter has a failed start attempt or if a safety input is activated the Diagnostic Memory will storeup to four shutdowns in memory. This information can then be accessed to determine the source of theshutdown. To Enter Diagnostic Mode:...
Page 4 INSTALLATION MANUAL REMOTE VEHICLE STARTER Yellow Starter 30amp output 12volts during crank only. Green Heater 30amp output 12volts in accessory off during start. Red 12 power 30amp input Constant 12volt power at ignition harness. Red 12 power 30amp input Constant 12volt power at ignition har...
REMOTE VEHICLE STARTER INSTALLATION MANUAL Page 5 Yellow Starter Output Connect To The Vehicles Starter Wire. Green Heater Output Connect To The Vehicles Accessory Wire. Red 12 power Input Connect to Constant 12 Volt Power Source - High Current. Red 12 power Input Connect to Constant 12 Volt Power S...
