Troy-Bilt 12215 Manual - Free PDF Download

Page 2 - See Back Cover for; WA R NING; Table of Contents; WARNING

2 Dear Owner: Congratulations on your purchase of a Tiller/Edger with Edger Attachment. It has been designed, engineered and manufactured to give you the best possible dependability andperformance. Please carefully read this Manual which provides information on how to safely and easily set-up, opera...

Page 3 - OPERATION; Safety

TRAINING • Read this Owner’s Manual and the sep-arate Engine Owner’s Manual very care-fully before operating this equipment. Becompletely familiar with the controls andthe proper use of the equipment. Knowhow to stop the unit and disengage thecontrols quickly. A replacement Manualis available by con...

Page 5 - Assembly; DANGER

INTRODUCTION Read these instructions in their entiretybefore you attempt to assemble oroperate your new equipment. The Border/Edger Attachment (H, Figure5) does not need to be installed until youare ready to do edging projects (refer toinstructions in this Section). IMPORTANT: The correct mixture of...

Page 7 - Features and Controls; Engine Controls; KNOW YOUR EQUIPMENT

Features and Controls 3 Section Handlebar Height Adjustment Knob (B, Figure 5)Two height settings, plus a storage position are available.Refer to Assembly Steps, STEP 1 in Section 2 for adjustmentinstructions. Tilling Depth Adjustment Knob (C, Figure 5)Loosening the knob enables you to move the whee...

Page 8 - PRE-START PREPARATION; Starting the Engine; Operation

PRE-START PREPARATION Before starting the engine, perform thefollowing checks and services: 1. Disconnect the spark plug wire fromthe spark plug. 2. Move the engine On/Off switch to theOFF position. 3. Check the six plastic cable ties (J,Figure 5). Be sure that cables and ties arepositioned as shown...

Page 9 - TILLING AND CULTIVATING; Cultivating; Section 4: Operation

Allow the engine to warm up for severalseconds. If engine either fails to start orto continue running, push in primer bulbtwo (2) times. Grasp starter rope andpull with a rapid, full stroke, up to ten(10) times. TROUBLESHOOTING: Push the primerbulb in two (2) more times. Using a rapidfull stroke, pu...

Page 10 - USING THE EDGER ATTACHMENT; Tilling Patterns; ATTACHMENTS

10 USING THE EDGER ATTACHMENT The Edger Attachment makes clean, sharp edges next to walkways, driveways, paths, planted areas,patios, etc. See Assembly Steps, STEP 4: in Section 2 for instructions on attaching this attachment. Take your time when edging. Decide how far away the edge is to be from th...

Page 11 - REQUIRED MAINTENANCE SCHEDULE; Maintenance

EQUIPMENT MAINTENANCE Transmission Maintenance The transmission was lubricated at thefactory and should not require any furtherlubrication. However, you should check the lubricantlevel after the first five (5) hours of opera-tion and every twenty-five (25) operatinghours thereafter. If needed, use a...

Page 12 - Spark Plug; Arranging Tines for Narrow Tilling; Section 5: Maintenance

If the engine is running poorly or has lowpower while tilling, an adjustment to thecarburetor may solve the problem. How-ever, first inspect and service the sparkplug and the air filter before making a carburetor adjustment. If the engine con-tinues to run poorly (and the fuel mixtureis fresh), proc...

Page 13 - STORAGE; Off-Season Storage Procedure

Arranging Tines for Stony Soil Conditions 1. Prop the machine forward so it restson the front of the tubular carryinghandle. The work surface should be flatand firm. 2. Remove the ring lock pin (A, Figure 16)from both sides of the unit. Remove bothouter tine sections. Mark each section asa left or r...

Page 14 - TROUBLESHOOTING; OFF

14 TROUBLESHOOTING Before performing any of the corrections in this Troubleshooting Chart, refer to the appropriate information contained in this Manualand the Engine Owner’s Manual for the correct safety precautions and servicing procedures. Contact your local authorized EngineService Dealer for en...

Page 15 - Parts List

15 Parts List Model 12215 1 1915039 Transmission Case - left-side. (Incl. pressed-on bushing) . . . . . . . . . . . . . 1 2 1915040 Transmission Case - right-side. (Incl. pressed-on bushing) . . . . . . . . . . . . . 1 3 1983632 Oil Seal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 ...

Page 18 - Index

18 A ccessories and Attachments . . . . . . . . . . . . . . . . . . . . . . .14 Aerator Attachment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14Air Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11Assembly . . . . . . . . . . . . . . . . . . . ....

Page 19 - Notes

Page 20 - CUSTOMER SERVICE INFORMATION

1905507 Rev. A (5/00) Printed in U.S.A. © 2000 Garden Way Incorporated CUSTOMER SERVICE INFORMATION Owner Registration Card Please fill out and mail the enclosed ownerregistration card. The purpose of this card isto register each unit at the Factory so that wecan provide you with warranty benefits a...