Transcend ssd720 - Manual
Transcend ssd720 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Supported Operating Systems; Supported on; Before Use; back up your data before proceeding.; Preparation for Mac OS; A USB stick with minimum 256MB free space.; Getting Started; Connect the Transcend SSD to your PC or laptop.
- Page 3 – Check the box next to the desired drive(s) and click “Update Firmware...”
- Page 6 – Partition and format USB stick
- Page 9 – Restore image to USB stick; Launch Disk Utility
- Page 10 – Click Image and select the source image file to restore.
- Page 11 – Click Restore to perform the image burning process.
- Page 12 – After restore is complete, the volume should now be named USB_LINUX.
- Page 13 – Boot from USB stick; Long press the option key until the boot menu is shown.; Update Firmware
- Page 15 – Open; firmware file is located under; Proceed; to continue the update process. Click; Cancel; to
- Page 16 – Rescan For Drives; to confirm that the SSD firmware has been updated successfully.
User’s Manual
SSD Firmware Update Utility
Version 1.5
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Supported Operating Systems Supported on Windows XP/Vista/7 and Fedora Core 14 32-bit. Mac OS: Mac OS X Lion (10.7) or later, and Mac is produced after 2010 Note: 1. Microsoft AHCI driver is required and Microsoft AHCI mode must be enabled on your computer. 2. You must have Administrator privileges ...
4. Select one or more desired drives to update. If two or more drives need to be updated at the same time, please ensure that the last five digits of each selected drive in the Signature column are identical to each other or the update will fail. 5. Check the box next to the desired drive(s) and cli...
Getting Started There are four steps to perform firmware upgrade on Mac OS. 1. Partition and format USB stick 2. Restore image to USB stick 3. Boot from USB 4. Firmware upgrade Partition and format USB stick 1. Launch Disk Utility 2. Select your USB disk then click the Partition tab.
