Page 3 - COPYRIGHT & TRADEMARKS; Specifications are subject to change without notice.; FCC STATEMENT; This device may not cause harmful interference.; CE Mark Warning
I COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used...
Page 4 - Related Document; Appendix A Troubleshooting.; Audience; This Installation Guide is for:; Conventions
II Related Document This Installation Guide is also available in PDF on our web site. To obtain the latest documentation and product information, please visit the official website:http://www.tp-link.com About this Installation Guide This Installation Guide describes the hardware characteristics, ins...
Page 6 - Product Overview
01 Gigabit Unmanaged Switch Introduction ChaCter C Product Overview C1C The Gigabit Switch provides you with a high-performance, low-cost, easy-to-use, seamless and standard upgrade to boost your old network to 1000Mbps. Increase the speed of your network server and backbone connections, making Giga...
Page 7 - ACCearance; Front Panel; The front panel of TL-SG1048 is shown as the following figure.; The front panel of TL-SG1024 is shown as the following figure.; The front panel of TL-SG1024D is shown as the following figure.; The front panel of TL-SG1016 is shown as the following figure.
02 Gigabit Unmanaged Switch ACCearance C11 Front Panel ■ The front panel of TL-SG1048 is shown as the following figure. Front Panel of Figure 1-1 TL-SG1048 The front panel of TL-SG1024 is shown as the following figure. Front Panel of Figure 1-2 TL-SG1024 The front panel of TL-SG1024D is shown as the...
Page 8 - The front panel of TL-SG1008 is shown as the following figure.
03 Gigabit Unmanaged Switch The front panel of TL-SG1016D is shown as the following figure. Front Panel of Figure 1-5 TL-SG1016D The front panel of TL-SG1008 is shown as the following figure. Front Panel of Figure 1-6 TL-SG1008 LEDs LED Status Indication Power On The Switch is powered on Off The Swi...
Page 9 - The rear panel of TL-SG1048 is shown as the following figure.; Power Socket; Caution: Please use the provided power cord.
04 Gigabit Unmanaged Switch Rear Panel The rear panel of TL-SG1048 is shown as the following figure. Rear Panel Figure 1-F of TL-SG1048 The rear panel of TL-SG1024/TL-SG1016 is shown as the following figure. Rear Panel Figure 1-8 of TL-SG1024/TL-SG1016 The rear panel of TL-SG1024D/TL-SG1016D/TL-SG10...
Page 10 - Package Contents; Safety Precautions
05 Gigabit Unmanaged Switch Installation ChaCter 1 Package Contents 11C Make sure that the package contains the following items. If any of the listed items is damaged or missing, please contact your distributor. One Switch One Power Cord This Installation Guide Two mounting brackets and the fittings ...
Page 11 - Site Requirements; Clearness; Dust the device regularly, and keep the indoor air clean.; Electromagnetic Interference; transmitting station.
06 Gigabit Unmanaged Switch Site Requirements ■ Temperature/Humidity ȭ ȭ L2 Lite Managed Switch TL-SL3428 Please keep a proper temperature and humidity in the equipment room. Too high/low humidity may lead to bad insulation, electricity leakage, mechanical property changes and corrosions. Too high t...
Page 12 - Installation Tools
07 Gigabit Unmanaged Switch Lightening Protection Extremely high voltage currents can be produced instantly when lightning occurs and the air in the electric discharge path can be instantly heated up to 20,000 ℃ . As this instant current is strong enough to damage electronic devices, more effective ...
Page 13 - Product Installation; Rack Installation
08 Gigabit Unmanaged Switch Note: These tools are not provided with our product. If needed, please self purchasethem. Product Installation 112 Desktop Installation ■ To install the device on the desktop, please follow the steps: Set the device on a flat surface strong enough to support the entire we...
Page 14 - Please set 5~10cm gaps around the device for air circulation.
09 Gigabit Unmanaged Switch After the brackets are attached to the device, use suitable screws (not provided1 to 3. secure the brackets to the rack, as illustrated in the following figure. Rack Rack Installation Figure 2-3 Caution: Please set 5~10cm gaps around the device for air circulation. ■ Plea...
Page 15 - Cabling Reasonably; Requirements for Cabling Outdoors; Aerial cabling without safeguard is not allowed.
10 Gigabit Unmanaged Switch Lightning Protection ChaCter 1 Cabling Reasonably 11C In the actual network environment, you may need cable outdoors and indoors, and the requirements for cabling outdoors and indoors are different. A reasonable cabling system can decrease the damage of induced lightning ...
Page 16 - Requirements for Cabling Indoors; devices are in following tables.
11 Gigabit Unmanaged Switch Requirements for Cabling Indoors ■ When cabling indoors, keep a certain distance away from the devices that may cause high-frequenc y inter ferences, such as down-conduc tor cable, powerline, power transformer and electromotor. The main cable should be paved in the metal ...
Page 17 - Connect to Ground
12 Gigabit Unmanaged Switch Cable Pave Way Min Parallel Length (mm1 2~5kVA powerline Parallel cabling 300 One is in the grounded metal raceway or metal pipe 150 The both are in the grounded metal raceway or metal pipe 80 >5kVA powerline Parallel cabling 600 One is in the grounded metal raceway or...
Page 18 - Connecting to the Ground via the Power Supply; EquiCotential Bonding
13 Gigabit Unmanaged Switch Note: The grounding bar and the ground cable are not provided with our product. If needed, please self purchase them. Connecting to the Ground via the Power Supply ■ If the device is installed in the normal environment, the device can be grounded via the PE (Protecting Ea...
Page 19 - at least. The shorter cable the bet ter, and use a; Use Lightning Arrester
14 Gigabit Unmanaged Switch Grounding Terminal Equipotential Bonding CableGrounding Bar Ground Cable Equipotential Bonding Figure 3-3 When equipotential bonding, please note that the cable should be copper wrapped Kelly with its area being 6mm 2 at least. The shorter cable the bet ter, and use a gro...
Page 21 - Ethernet Port; Verify Installation; the air flow is adequate.; Power On
16 Gigabit Unmanaged Switch Connection ChaCter 2 Ethernet Port 21C Connect a Ethernet port of the Switch to the computer by RJ45 cable as the following figure shown. RJ45 Port RJ45 Cable Connecting the RJ45 Port Figure 4-1 Verify Installation 211 After completing the installation, please verify the ...
Page 22 - Initialization; resetting of the system.
17 Gigabit Unmanaged Switch Note: The figure is to illustrate the application and principle. The power plug you get from the package and the socket in your situation will comply with the regulation in your country, so they may differ from the figure above. Initialization 212 After the device is powere...
Page 23 - ACCendix A Troubleshooting; The Power LED is not lit; Make sure that the power cable is connected properly, and the power; The Link/Act LED is not lit when a device is connected to the; QQQQ; corresConding Cort; Please check as follows:
18 Gigabit Unmanaged Switch ACCendix A Troubleshooting The Power LED is not lit QQQQ The Power LED should be lit up when the power system works normally. If the Power LED worked abnormally, please check as follows: Make sure that the power cable is connected properly, and the power 1. contact is nor...
Page 24 - ACCendix B SCecifications
19 Gigabit Unmanaged Switch ACCendix B SCecifications Item Content Standards IEEE 802.3 10Base-T IEEE 802.3u 100Base-TX IEEE 802.3ab 1000Base-T Transmission Medium 10Base-T: UTP/STP of Cat. 3 or above(maximum 100m1 100Base-TX: 2-pair UTP/STP of Cat. 5 or above(maximum 100m1 1000Base-T: 4-pair UTP/ST...
Page 25 - ACCendix C Technical SuCCort
20 Gigabit Unmanaged Switch ACCendix C Technical SuCCort For more help, please go to: www.tp-link.com/support/faq.asp ■ To download the latest Firmware, Driver, Utility and User Guide, please go to: ■ www.tp-link.com/support/download.aspFor all other technical support, please contact us by using the...
