Page 2 - IMPORTANT SAFETY INSTRUCTIONS
1 IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followedto reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on...
Page 3 - SAVE THESE INSTRUCTIONS; The RBRC; Seal
2 13. Do not use the telephone in the vicinity of a gas leak. CAUTION: TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS BY THE BATTERY, READ AND FOLLOW THESE INSTRUCTIONS. 1. Use only the appropriate type and size battery pack specified in the instruction manual provided for this product. 2. Do not d...
Page 5 - INTRODUCTION; FEATURES
4 INTRODUCTION Toshiba America Consumer Products, Inc. takes pride in presentingyour phone, one of the finest cordless telephones available. Intelligentdesign, superb craftsmanship, and the latest technological advanceshave been combined to provide you with a telephone that is easy tooperate and wil...
Page 6 - INSTALLATION; SETTING UP THE BASE UNIT; For use on a desk or counter top follow the instructions below.
5 INSTALLATION 1. SETTING UP THE BASE UNIT For use on a desk or counter top follow the instructions below. DESKTOP MOUNTING: • USE ONLY WITH Supplied AC ADAPTOR (TAC-8001); power source AC 120V, 60Hz/DC 9V). • The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel w...
Page 7 - CHARGE THE BATTERY PACK; Note
6 Red Black 2. CHARGE THE BATTERY PACK Note Use only the supplied battery pack (TRB-8000 power source600 mAh, 3.6V). q Remove the battery compartment coveron the back of the handset by sliding itdown. w P l u g t h e b a t t e r y p a c k c o r d i n t o t h econnector in the battery compartment byo...
Page 8 - After the battery pack is fully charged; Operation; up to 7 hours; WALL MOUNTING; MOUNTING ON A STANDARD WALL PLATE
7 After the battery pack is fully charged; Operation Approx. battery life While in use (Talk mode) up to 7 hours While not in use (Standby mode) up to 14 days When TALK/BATT LOW LED blinks, all handset buttons are disabledand the battery needs to be charged. If this occurs during a call, youhear sho...
Page 9 - Wall mount template; CUT; • Route the cords through the guides.; Notes
8 Wall mount template IMPORTANT: Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone.Avoid electrical cables, pipes, or other items behind the mounting location that could cau...
Page 10 - LOCATIONS OF CONTROLS; HANDSET CONTROLS
9 LOCATIONS OF CONTROLS HANDSET CONTROLS BASE UNIT CONTROLS Antenna Charging Contacts RDL/P (Redial/Pause) button DC IN 9V jack LINE Modular jack Antenna PAGE button Charging Contacts IN USE/CHARGE LED Speed Dial Index Card (back)Write down numbers stored inmemory. RechargeableBattery Pack (back) TA...
Page 11 - SETTING THE DIAL MODE; FLASH
10 Please see “LOCATION OF CONTROLS” for the location ofeach button used for the following operations. SETTING THE DIAL MODE Most phone systems use tone dialing. But, to use tone dialing, youmust have a tone service dialing system supplied by your telephonecompany. Then you must set your telephone d...
Page 12 - MAKING A CALL; Press; Listen for the dialtone.; again or place the; or place the handset
11 MAKING A CALL 1. MAKING A CALL q Press TALK . The TALK/BATT LOW LED will light. w Listen for the dialtone. e Key in the phone number you are calling. r To hang up, press TALK again or place the handset on the base unit. The TALK/BATTLOW LED turns off. 2. ANSWERING A CALL q Simply pick up the hand...
Page 13 - INTERFERENCE OR STATIC; CH; CHANGING THE RINGER VOLUME
12 3. INTERFERENCE OR STATIC If you hear noise during a call, press CH to select another channel. The TALK/BATT LOW LED blinks while changing a channel. 4. CHANGING THE RINGER VOLUME Press VOL/RING to select one of four ringer tone and volume combinations during standby mode.Each time you press VOL/...
Page 14 - PAGE
13 8. SENDING TONE SIGNAL (for Pulse service user) Even if you have Pulse service (the dial mode is set to Pulse), you canuse this phone with banking and other phone services requiring touchtone signals. q Dial the service number and wait for the connection. w Press TONE/ , then enter the numbers re...
Page 15 - MEMORY DIALING
14 MEMORY DIALING You can store up to 10 telephone numbers in memory. Notes In memory dialing operation,• If more than 20 seconds elapse between pressing buttons, the operation will be cancelled and you must start over again. • If you press a wrong button, an error tone sounds and the handset return...
Page 16 - Replacing a telephone number; DIALING A STORED NUMBER; INSERTING A PAUSE IN MEMORY
15 Replacing a telephone number Just store the new number following the same steps in “1. STORINGNUMBERS.”The new number will replace the previously stored one. 2. DIALING A STORED NUMBER q Pick up the handset and press TALK . The TALK/BATT LOW LED lights. w Press MEM . e Enter the memory address (0...
Page 17 - ACCESSORIES; Telephone Cord
16 ACCESSORIES Rechargeable Battery pack (1) TRB-8000 Part # RC004931AC Adaptor (1) TAC-8001 Part # RC009790 for FT-8001TAC-8001 Part # RC009791 forFT-8001W Telephone Cord (1) Part # RC008231 Wall Mount Bracket (1) Part # RC009245 for FT-8001 Part # RC009246 for FT-8001W Owner’s Manual (1) Part # RC...
Page 18 - TROUBLESHOOTING GUIDE; PROBLEM
17 TROUBLESHOOTING GUIDE Should any problem occur with the set, make the following simple teststo determine whether or not servicing is required. PROBLEM The handset batterydoes not charge. Battery becomes lowquickly. Can not make orreceive calls.Can not hear the dialtone. TALK/BATT LOWLED blinks in...
Page 20 - Owner’s Manual; TELEPHONE/TELEPHONE ANSWER MACHINE LIMITED WARRANTY; How to Obtain Warranty Service
UCZZ01337BZ RC012151 Printed in China © 2001 TOSHIBA AMERICA CONSUMER PRODUCTS. INC. All warranties implied by state law, including the implied warranties of merchantability and fitness for a particular purpose,are expressly limited to the duration of the limited warranties set forth above. With the...
