Toshiba 510D- Manual
Toshiba 510D– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Network adapter setup
- Page 3 – When using Windows 2000 Server; Be sure to connect a mouse to the server.; MAGNIA
- Page 4 – manual
- Page 5 – Tape Attached to the CPU Heat Sink
- Page 7 – Components List; Unpack and check components.; Components
Toshiba MAGNIA™
510D
Read-Me-First Addendum
Thank you for purchasing the Toshiba MAGNIA 510D.
This document explains the precautions for using your
MAGNIA 510D. To ensure the best performance,
please read this document carefully before configuring
the server.
Keep the document handy for future reference.
For the latest information and updates, please visit:
www.toshiba-tro.de
When using Windows NT
Server 4.0
(1)
Be sure to connect a mouse to the server.
If you use the server without a mouse, the keyboard
may become inoperative.
(2)
Installing Windows NT Server 4.0 to the server
whose memory capacity exceeds 1,7MB
When the memory capacity exceeds 1,7MB,
Windows NT Server 4.0 cannot be installed because
of the limitations of Windows NT Server 4.0. In this
case, use the following procedure to install
Windows NT Server 4.0.
1/15
S00047-EN EH02 Rev. E
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1) If the server is in operation, shut it down, switch off the power, and unplug the power cable. 2) Remove memory modules as needed to observe the 1,7 MB limit. 3) Install Windows NT Server 4.0 and Windows NT 4.0 Service Pack with the memory capacity at less than 1,7 MB. 4) After installing Windows...
If the "530LTX" label is attached on the connector panel: Connection Type: Auto-Negotiation Network Address: (Blank) If the no label is attached on the connector panel: Connection Type: Auto-Sense Network Address: (Blank) When using Windows 2000 Server (1) Be sure to connect a mouse to the s...
When using NetWare (1) (2) 5.1 Follow the installation procedure described in the instruction manual to ensure that the installation is done properly. About expansion of optional RAID controller D When you use Server Setup Tool to setup the server with RAID controller D (MR466), the [Detailed Setup]...
