Page 2 - Important Safety Instructions; Installation; ) Always connect the power plug to an; Contents; Introduction / Getting started; Welcome to Toshiba
2 Introduction / Getting started • You also can use the controls on the TV if they have the same name as those referred to on the remote control. • Please read all safety and operating instructions in this manual carefully, and keep this manual for future reference. Important Safety Instructions Be ...
Page 4 - Top view; Use
4 • To prevent injury, use the exclusive optional stand or wall-hanging bracket to install this TV on the floor or wall securely in accordance with a qualified technician. Top view Screw hole 9) Precautions for moving the TV • When moving the TV, be sure to remove the plug from the wall outlet and d...
Page 5 - Service
5 5) When the TV will not be used for a long period of time, such as during vacation or travel, remove the power plug from the wall outlet for safety. • The TV is not completely disconnected from the power supply line, as minute current is consumed even when the ! Power switch is turned off. • The M...
Page 6 - Cleaning; Important information; Exemptions
6 Cleaning 1) Remove the power plug before cleaning. Never use solvents such as benzine or thinner to clean the TV. • These solvents may distort the cabinet or damage its finish. • If rubber or vinyl products remain in contact with the TV for a long time, a stain may result. If the cabinet becomes d...
Page 7 - Connecting an aerial; Media Recorder; Exploring your new TV; Installing the remote control batteries; • Attention should be drawn to the environmental; Effective range; TV front and side panel controls
7 Connecting an aerial Optimum reception of colour requires a good signal and will generally mean that an outdoor aerial must be used. The exact type and positioning of the aerial will depend upon your particular area. Your Toshiba dealer or service personnel can best advise you on which aerial to u...
Page 8 - TV front view; pBb; MENU; TV back panel connections; TV back view; Never grasp the holder when moving the TV.; HDMI2 –
8 Introduction / Getting started TV front view 6 Right side view 12 3 4 5 Point the brightness sensor ( - page 18). 1 ! (Power on/Standby) — Press to turn the TV on/ standby ( - page 10). 2 pBb (Programme position) — When no menu is on screen, these buttons select the programme position. ( - page 12...
Page 9 - SETUP; Learning about the remote control; Location of controls; rsvw; OK
9 Introduction / Getting started 10 o PC/HDMI1 (AUDIO) (input terminal) — PC audio input terminal is shared with HDMI1 analogue audio input terminal, and their use can be configured in the SETUP menu ( - pages 25, 26). 11 A (Aerial input terminal) — Analogue aerial signal input ( - page 7). 12 o RGB...
Page 10 - Turning the TV on; Switching on the TV; Colour System mode is set to Auto, colour; Switching off the TV; Tuning the TV for the first time
10 Introduction / Getting started Turning the TV on Switching on the TV Connect the power cord to a wall outlet, the ! power indicator lights in red (standby mode). 1 Press on the remote control or ! on the TV right side panel, the ! power indicator lights in green. Note: If you watch black and whit...
Page 11 - Manual Tuning; The; Using the Quick Menu; Quick Menu; Learning about the menu system; Displaying the menu chart; PICTURE
11 Introduction / Getting started 1 Manual Tuning Pos. Label 2 3 4 5 6 7 8 7 Closing the Quick Setup menu, press EXIT . Note: The Quick Setup menu can also be display at any time from the SETUP menu. Using the Quick Menu Quick Menu helps you access some options quickly, such as Picture Mode , Pictur...
Page 12 - Watching TV programmes; Selecting the menu language; Displaying the on-screen information; Auto Tuning
12 Notes: • In the video input mode ( o 1, o 2 and HDMI), Auto Tuning and Manual Tuning are not available. Instead, Manual Settings appears in the SETUP menu ( - page 20). • If you connect external equipment via component video source to external input, Colour System selection in the Manual Settings...
Page 13 - When you preset the channel which sound; Setting the Location
13 Introduction / Getting started 3 Press Q to display the Auto Tuning menu. Auto TuningPrevious settings will be Lost!Press EXIT for no change.Press OK key to start auto tune. 4 Press Q to start the automatic search. The search will begin for all available stations. 5 When the automatic search is c...
Page 14 - Sorting positions; MNOP
14 Sorting positions • The TV is capable of receiving a number of different channels depending upon where you live. • Sorting programme position is an easy way of storing each channel on the programme position of your choice. Ex.: To swap channel ABCD (Prog.1) for channel MNOP (Prog.4): 1 From the S...
Page 15 - Using the TV’s features; Picture adjustment; Selecting the Picture Size; Picture Size
15 Using the TV’s features Picture adjustment • Most of the picture controls and functions are available. However features not available will be greyed out. Selecting the Picture Size 1 Press until the Picture Size list appears on the screen, then press s or r to select the appropriate Picture Size ...
Page 16 - Dot by Dot; Using the picture still; Resetting the Picture Position
16 Using the TV’s features Dot by Dot “Dot by Dot” is a non-scaling display. Depending on the input signal format, the picture is displayed with side panels and/or bars at the top and bottom (i.e. VGA input source). Notes: • In the PC connected via HDMI or RGB/ PC terminal ( - page 26), the picture ...
Page 17 - Activating the picture preferences; Effective signal and setup conditions:; When a DVD movie with subtitle is playing back,; Adjusting the Colour Temperature; Resetting the Picture Settings; DNR function is available for 480i and 576i
17 Using the TV’s features Picture Settings 1/2 Picture Mode BacklightContrastBrightnessColourTintSharpnessBlack/White Level Dynamic High 100 50 50 0 0 100 3 Press v or w to select the picture mode you prefer and press Q . Activating the picture preferences You can customise current picture mode set...
Page 18 - Sound adjustment; Auto mode; Auto
18 Using the TV’s features 2 Press v or w to select On or Off . Sound adjustment Setting the MTS (Multi-channel TV Sound) Auto mode The MTS Auto mode automatically recognize stereo/bilingual programmes depending on the broadcast signal. 1 Press MENU , and then press v or w to display the SOUND menu....
Page 19 - Other features settings; II
19 Using the TV’s features Using the Advanced Sound Settings Bass Boost helps to create rich bass. Voice Enhancement helps to emphasize dialogue. It will be easier to hear voices over other background audio. 1 From the SOUND menu, press s or r to select Advanced Sound Settings , and then press Q . 2...
Page 20 - approximately 2 hours if you do not operate the; Selecting the video input source to view; Inputs
20 Using the TV’s features 4 When setting the On timer, press s or r to select the On Timer Position and enter the program position number you want to watch. Press EXIT to exit the menu. Set the Standby mode by pressing on the remote control. Note: The TV will automatically turn itself off after app...
Page 21 - Teletext; Setting up the Teletext mode; To select a language for Teletext:; When you are watching the teletext programme,; Teletext general information; Only; Channel List
21 Using the TV’s features Teletext This TV has a multi-page Teletext memory, which takes a few moments to load and it offers two ways of viewing Teletext Auto and List which are explained below. Setting up the Teletext mode To select a language for Teletext: The language 1-4 option enables the disp...
Page 22 - If you press; Using Subtitles; If; Using Auto mode; Using List mode; To display a page of teletext:
22 Using the TV’s features Note: If you press while the Picture Mode is activated, this mode will be cancelled. Sub-pages: Once in this chosen page, if there are sub-pages they will automatically load into memory without changing the one you are reading. If there are many sub-pages, it will take a l...
Page 23 - It will not be possible to change programme; To select the time display:
23 To hold a wanted page: This function is included as it is part of the broadcast teletext system but you will not need it as this TV allows you to control the display of sub-pages. To enlarge the teletext display size: Press once to enlarge the top half of the page, press again to enlarge the bott...
Page 24 - Connecting your TV; Back connections; Connection example; Connecting HDMI or DVI devices; Analogue; Connecting an HDMI or a DVI device
24 Connecting your TV Back connections Connection example RGB/PC VIDEO AUDIO R L /MONO AUDIO R L /MONO Y P R /C R P B /C B 1 2 3 4 PC/ HDMI1 (AUDIO) 1 2 AUDIO(FIXED) COMPONENT VIDEO INPUT USB 3 1 RGB/PC PC/HDMI 1 (AUDIO) COMPONENT VIDEO INPUT VIDEO AUDIO R Y L/MONO P R /C R P B /C B MONITOR VCR (Nor...
Page 25 - Connecting an HDMI device; Connecting a DVI device; Standard analogue audio cables; Selecting the PC/HDMI 1 Audio mode; Setting the HDMI 1 Audio mode; This function is available only when the
25 Connecting your TV Connecting an HDMI device One HDMI cable (type A connector) 1 2 3 4 VIDEO AUDIO L R IN OUT HDMI OUT TV back view HDMI device For proper operation, it is recommended that you use a short HDMI cable. HDMI cable transfers both video and audio. Connecting a DVI device One HDMI (typ...
Page 26 - Connecting a computer; To connect a PC to the RGB/PC terminal on; Back of TV; The following signals can be displayed:; left side of the screen, or parts of the picture; To connect a PC to the HDMI terminal on the; Signal names for mini D-sub 15 pin connector; Pin assignment for RGB/PC terminal
26 Connecting your TV Connecting a computer To connect a PC to the RGB/PC terminal on the TV: An analogue RGB (15 pin) computer cable can be connected. PC/ HDMI1 (AUDIO) RGB/PC Computer Audio cable for PC-to-TV connection Conversion adapter (if necessary) RGB PC cable Mini D-sub 15 pin Back of TV Co...
Page 27 - Using the PC Settings; Adjusting the picture position; Adjusting the Clock Phase of the picture; Using the Media Player; Media Player Specifications; Device
27 Connecting your TV 7 Ground 15 NC 8 Ground Using the PC Settings • Most of the picture controls and functions are available. However features not available will be greyed out. • First press until the video input mode list appears on the screen, then press s or r and Q in order to select the PC in...
Page 28 - Basic operation; Viewing JPEG files; To view in Single View mode:; If the previous or next file is not compatible, it will; To view in Slide Show mode:; To return to Single View mode, press; To set the Slide Show mode settings:
28 Basic operation Auto Start: 1 From the FUNCTION menu, highlight Media Player and press Q . Media Player Photo Auto Start On 2 Press s or r to highlight Auto Start . 3 Press v or w to select On . 4 Insert a USB device into the USB terminal on the back of the TV. 5 A confirmation message will appea...
Page 29 - To display file status information:; The file status information will disappear after; To close the Media Player:; EXIT
29 Connecting your TV To display file status information: 1 Press . The following information will be displayed at the bottom of the screen. • File number/Total number of files (only for files stored in the same directory) • Photo title • Date and time taken • File size • Slide Show icon (if applica...
Page 30 - Troubleshooting; Symptom and solution; Broadcast system; Broadcast transmission systems of each; Country or region; Reference section
30 Troubleshooting Before calling a service technician, please check the following table for a possible cause of the symptom and some solutions. Symptom and solution TV will not turn on • Make sure the power cord is plugged in, and then press ! or 1 . • The remote control batteries may be dead. Repl...
Page 31 - Oceania; colour signal broadcast transmission systems; Specifications; LCD colour TV
31 Reference section Country or region Colour Sound Iraq, Islamic Republic of Iran, Lebanon, Saudi Arabia, etc. SECAM B/G Russian Federation, etc. SECAM D/K Myanmar, Republic of the Philippines, etc. NTSC M Oceania Country or region Colour Sound Australia, New Zealand, etc. PAL B/G Africa Country or...
Page 32 - Input/Output terminals
Reference section Input/Output terminals o (1) InputPhono jacks A/V o (2) InputComponent video Y, P B /C B , P R /C R Phono jacks Audio L/Mono +R O AUDIO (FIXED) Output Phono jacks Audio L/Mono +R o RGB/PC InputMini D-sub 15 pin Analogue RGB o PC/HDMI1 Input (AUDIO) 3.5 mm (Diameter) stereo o HDMI1 ...
