Page 2 - Contents
Introduction Welcome to Toshiba .................................................................................................. 3Important Safety Instructions .................................................................................... 3Important information .................................
Page 3 - Introduction; Welcome to Toshiba; Installation; ) Always connect the power plug to an
3 Introduction Welcome to Toshiba • Thank you for purchasing this Toshiba LCD Colour Television. This manual will help you use the exciting features of your new TV. • Instructions in this manual are based on using the remote control. • You also can use the controls on the TV if they have the same na...
Page 4 - Top view; Side view
4 4) Never block or cover the slots and openings in the cabinet. • Never place the TV so that it is facing upward or on its side. • Never place the TV in a closet, bookcase or other similar area where the ventilation is poor. • Never drape a newspaper, tablecloth or curtain on the TV. • Never stand ...
Page 5 - 0) Precautions for installing on outdoor aerial; Use; ) Never place hot objects or open fl ame; • Educate children about the dangers of; ) When the TV will not be used for a long; • The TV is not completely disconnected from
5 10) Precautions for installing on outdoor aerial An outside aerial system should not be located in the vicinity of overhead power lines, or other electric light or power circuits.If the aerial falls down or drops, it may cause an injury or an electric shock. Use 1) Never place hot objects or open ...
Page 6 - You may suffer an electric shock.; Service
6 6) Never pull on the power cord when removing the plug from the wall outlet. Always hold the plug fi rmly when removing it. If the power cord is yanked, the cord may become damaged and a fi re or an electric shock may occur. 7) Never cut, break, modify, twist, bunch up or bent the cord or apply ex...
Page 7 - Cleaning; Important information; Exemptions
7 Cleaning 1) Remove the power plug before cleaning. Never use solvents such as benzine or thinner to clean the TV.• These solvents may distort the cabinet or damage its fi nish. • If rubber or vinyl products remain in contact with the TV for a long time, a stain may result. If the cabinet becomes d...
Page 8 - Connecting an aerial; Media Recorder; Exploring your new TV; Installing the remote control batteries; Getting started; Effective range
8 Connecting an aerial Optimum reception of colour requires a good signal and will generally mean that an outdoor aerial must be used.The exact type and positioning of the aerial will depend upon your particular area.Your Toshiba dealer or service personnel can best advise you on which aerial to use...
Page 9 - TV front and side panel controls; p Bb; MENU
9 Getting started TV front and side panel controls • You can operate your TV using the buttons on the bottom of the panel or the remote control. The back and side of the panel provide the terminal connections to connect other equipment to your TV ( - “Connecting your TV” pages 26-31). • For the use ...
Page 10 - — Analogue aerial; SETUP; — Optional; TV back panel connections; TV back view
10 Getting started 9 A (Aerial input terminal) — Analogue aerial signal input ( - page 8). 10 o RGB/PC (input terminal) — For use when connecting a personal computer (PC) ( - page 29). 11 o HDMI1 (input terminal) — High- Defi nition Multimedia Interface input receives digital audio and uncompressed ...
Page 11 - Learning about the remote control; Location of controls; CALL
11 Getting started Learning about the remote control Location of controls 2 1 3 5 4 6 8 7 9 0 CALL TEXT MENU EXIT P P OK CT-90323 • CALL ( - page 13) • Initial/index function for Teletext ( - page 25) Picture still ( - page 17) Sound mute (This button turns off/on the sound.) To return to the previo...
Page 12 - Turning the TV on; Switching on the TV; Learning about the menu system; Displaying the menu chart
12 Getting started Turning the TV on Switching on the TV Connect the power cord to a wall outlet, the ! power indicator lights in red (standby mode). 1 Press 1 on the remote control or ! on the TV bottom of the panel, the ! power indicator lights in green. Note: If you watch black and white programm...
Page 13 - Watching TV programmes; Selecting the menu language
13 Getting started • If you want to close the menu display instantly, press EXIT . • To return to the previous menu, press MENU . • The U / u function as the Programme position P B / P b when there is no menu display on the screen. • The I / i function as the Volume 2 +/ 2 – when there is no menu di...
Page 14 - Programming channels automatically; Manual tuning
14 Getting started Manually setting channels in the channel memory 1 From the SETUP menu, press u or U to select Manual tuning . 2 Press Q to display the Manual tuning menu. Press u or U to select the programme position you want to arrange. 5 4 3 2 1 MENU Back Watch TV EXIT 6 OK Manual tuning P r o ...
Page 15 - Sorting programme position
15 E. Channel search operation Press U to search up the band or u to search down the band. Press u or U repeatedly until your desired channel is displayed. When a station/satellite is found, it will be displayed. NEVER PRESS ANY OTHER BUTTONS WHILE THE SET IS TUNING. F. MFT (Manual Fine Tuning) Pres...
Page 16 - Using the TV’s features; Picture adjustment; Selecting the picture size; Press , the picture size appears on the; Use this setting when watching a 14:9 broadcast.
16 Using the TV’s features Picture adjustment Selecting the picture size 1 Press , the picture size appears on the screen. 2 Press repeatedly to select required picture size directly. Wide Use this setting when watching a wide-screen DVD, widescreen video tape or a 16:9 broadcast (when available). D...
Page 17 - Native; Using the picture still; Resetting the picture position; Picture Position
17 Using the TV’s features Native Use this setting for PC connected via HDMI. When receiving video signal source via HDMI input, this setting will display the image correctly without distortion or picture clipping. Notes: • In the aerial input signal mode, the picture size selections are Wide , Supe...
Page 18 - Selecting the picture mode; Adjusting the basic picture quality; Colour; Activating the black/white level
18 Using the TV’s features Selecting the picture mode You can select the picture quality instantly among three preset modes and one user-set mode.• Press q to select the desired picture quality. D y n a m i c Mode Picture quality q Dynamic bright and dynamic picture q Standard standard picture q Mil...
Page 19 - • If you select colour management; Resetting the base colour adjustment; Effective signal and setup conditions:; Selecting the colour temperature; Adjusting the colour management
19 Using the TV’s features 5 Press i , then press I or i to select Hue , Saturation or Brightness . Red Brightness 0 H u e Saturation 0 MENU Back Watch TV EXIT 0 6 Press u or U to adjust the settings as required. Notes: • If you select colour management Off mode, this mode is not available. • In the...
Page 20 - Selecting the stereo programmes; Selecting the bilingual programmes; II; Adjusting the sound quality; Sound adjustment; Auto mode; Mono mode; Auto; Selecting the dual 1 or dual 2 mode; Mono
20 Using the TV’s features Selecting the stereo programmes 1 When a stereo programme is received, d Stereo appears. 2 Press s to select the stereo/monaural mode. d Stereo and e Mono appear cyclically on the screen. S t e r e o Selecting the bilingual programmes 1 When a bilingual programme is receiv...
Page 21 - Selecting the surround sound
21 Using the TV’s features Selection I Pressing i Bass weaker stronger Treble weaker stronger Balance decreases the right channel decreases the left channel Selecting the surround sound 1 From the SOUND menu, press u or U to select Surround . 2 Press I or i to select On or Off . Note: When Surround ...
Page 22 - Using the auto format; Activating the 4:3 stretch; Other features settings; Selecting the timer menu
22 Using the TV’s features Using the auto format When the TV receives a true HDMI signal picture and the auto format is On, it will automatically be displayed in HDMI signal format, irrespective of the TV’s previous setting. 1 Press MENU , then press I or i to display the FUNCTION menu. FUNCTION MEN...
Page 23 - PC VGA mode; MONITOR OUT; Setting the manual setting menu; Teletext; Setting up the teletext mode; To select a language for teletext:
23 Using the TV’s features Selecting the video input source to view 1 Press o or press Q on the remote control until the video input mode list appears on the screen, then press u , U or o to select appropriate input source (or press o on the TV bottom of the panel to select required input source dir...
Page 24 - To select teletext mode:; When you are watching the teletext programme,; Teletext general information; If you press; Using Auto mode
24 2 Press u or U to select Teletext language , then press I or i to select the required language. • Language 1: English, German, Dutch, Flemish, Russian, Byelorussian, Bulgarian, Ukranian, Lettish, Lithuanian, Czech, Slovak, Estonian • Language 2: Polish, German, Dutch, Flemish, Estonian, Lettish, ...
Page 25 - Using LIST mode; Teletext buttons on the remote control; TEXT; TEXT
25 Using the TV’s features Using LIST mode 1 Press TEXT to access teletext. Red Green Yellow Blue 1 0 0 T E X T M 0 0 1 4 : 5 8 : 5 5 1 0 0 2 0 0 3 0 0 4 0 0 The four choices at the bottom of the screen are now number – 100 , 200 , 300 and 400 , which have been programmed into the TV’s memory. 2 To ...
Page 26 - Connecting your TV; Back connections; Connection example; Connecting an HDMI and a DVI device
26 Connecting your TV Back connections You can connect a wide variety of auxiliary equipment via the terminals located on the back of the panel o (2) . Please always refer to the owner’s manual of the equipment to be connected for full details. Connection example TV back view Video Games Camcorder C...
Page 27 - Analogue; Connecting an HDMI device; HDMI device; Connecting a DVI device; DVI device; Standard analogue audio cables
27 Connecting your TV • This TV is only operable with L-PCM on 32/44.1/48 kHz and 16/20/24 bits. If there is no sound when using HDMI, use the analogue audio cables to connect the TV and the HDMI device, and select Analogue in HDMI audio of the AV connection menu ( - page 28). • This TV is able to c...
Page 28 - Selecting the PC/HDMI1 audio mode; Setting the HDMI1 audio mode; Selecting the Lip Sync; Disconnect the HDMI cable before changing the
28 Connecting your TV Selecting the PC/HDMI1 audio mode You can select PC audio ( - page 29) or HDMI1 audio when using this function. 1 Press MENU , then press I or i to display the SETUP menu. AV c o n n e c t i o n M a n u a l t u n i n g OK OK Au t o t u n i n g OK L a n g u a g e SETUP MENU Back...
Page 29 - Connecting a computer; The following signals can be displayed:; • There is no need to use an adapter for; Signal names for mini D-sub 15 pin connector; Pin assignment for RGB/PC terminal; Signal name
29 Connecting your TV Connecting a computer To connect a PC to the RGB/PC terminal on the TV: An analogue RGB (15 pin) computer cable can be connected. TV back view Computer Audio cable for PC-to-TV connection Conversion adapter (if necessary) RGB PC cable Mini D-sub 15 pin TV back view Connect a PC...
Page 30 - page; Using the PC setting; Adjusting the picture size/position
30 Connecting your TV To connect a PC to the HDMI terminal on the TV: When connecting a PC to the HDMI terminal on the TV, use an HDMI-to DVI adapter cable and analogue audio cables.If connecting a PC with an HDMI terminal, use an HDMI cable (type A connector). Separate analogue cables are not neces...
Page 31 - Adjusting the clock phase of the picture; Adjusting the sampling clock; Resetting the PC setting
31 Connecting your TV 4 Press u or U to select an option you want to adjust. Press I or i to adjust the settings as required. Horizontal Position 0 Note: When you set the Vertical Position, the screen may not be changed even if changing the cursor position. Adjusting the clock phase of the picture I...
Page 32 - Troubleshooting; Symptom and solution; PICTURE; Reference section
32 Troubleshooting Before calling a service technician, please check the following table for a possible cause of the symptom and some solutions. Symptom and solution TV will not turn on • Make sure the power cord is plugged in, then press ! or 1 . • The remote control batteries may be dead. Replace ...
Page 33 - Broadcast system; Broadcast transmission systems of each country or region; Oceania
33 Reference section Broadcast system Broadcast transmission systems of each country or region Asia M.E. Country or region Colour Sound Bahrain, Kuwait, Israel, Oman, Qatar, United Arab Emirates, Yemen, etc. Indonesia, Malaysia, Singapore, Thailand, etc. PAL B/G China PAL D/K China Hong Kong PAL I I...
Page 34 - Specifi cations; LCD colour television
34 Reference section Specifi cations LCD colour television Model 32AV600E, 32AV600T, 32AV600Y, 32AV601E, 32AV601T, 37AV600E, 37AV600T, 37AV600Y Power source 32/37AV600/601E: 220V-240V AC, 50/60Hz32/37AV600/601T: 110V-240V AC, 50/60Hz32/37AV600/601Y: 220V-240V AC, 50Hz Power consumption 32AV600/601E/...
