Toro LTC PLUS - Installation Manual

Toro LTC PLUS

Toro LTC PLUS – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
Page: / 5

Table of Contents:

  • Page 2 – Install new radio; not
  • Page 3 – On the FIU, the jumpers must also be set to the ‘VP’ position; jumpers in the VP position
  • Page 4 – Figure 1
  • Page 5 – Required Items; Steps; ATFX; Figure 5; FCC Part 22 and Part 90 of the FCC Rules
Loading the manual

A

The Old Radio

LTC Plus / Early VP Raveon Radio Kit

Installation Instructions

Disconnect power from

radio interface board.

Disconnect wireline

connection from modem.

Disconnect antenna cable.

Remove radio assembly

mounting bolt.

Remove radio assembly.

Disconnect modem

from timing mechanism.

1

4

2

5

3

6

RISK OF ELECTRIC SHOCK.

Before replacing the radio, be sure to disconnect power to the pedestal.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for Toro LTC PLUS

Summary

Page 2 - Install new radio; not

B Install new radio standard modem connection New Radio Overview power connection jumpers Secure with mounting bolt. Connect to timing mechanism. Connect power to radio interface board. Connect antenna cable. Insert radio assembly. For LTC controller, all 4 jumpers should be to the right. (optional)...

Page 3 - On the FIU, the jumpers must also be set to the ‘VP’ position; jumpers in the VP position

Configuration Specific Settings An “early” VP system is one with the power distribution board in the horizontal position. There are four possible configurations of LTC Plus and early VP models. Please review this section to find instructions particular to your system configuration. Possible Configur...

Page 4 - Figure 1

To put the Raveon radio into “bell202” mode: Required Items: • Radio Manager software from Raveon• USB to Serial (DB9) cable with included drivers• 12V Phoenix power connector (from authorized Toro distributor)• 12V power supply for radio (from authorized Toro distributor) Steps 1. Disconnect all po...

Other Toro Models

All Toro Other