TOA WM-370 - Manual

TOA WM-370

TOA WM-370 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
Page: / 4

Table of Contents:

  • Page 2 – Plug the microphone cable into the transmitter
  • Page 3 – Squelch circuit; PART NAME
  • Page 4 – TYPICAL FREQUENCY RESPONSE; FCC license requirement; SPECIFICATIONS; * S p e c i f i c a t i o n s are subject to change without notice.; TOA Corporation; Printed in Japan
Loading the manual

[Operating Instructions]

WIRELESS

MICROPHONE

WM-370

Please follow the instructions in this manual to obtain

the optimum results from this unit. We

also recom-

mend you keep this manual handy for future refer-

ence.

GENERAL DESCRIPTION

Compact and light weight, the TOA WM-370 is a

lavalier type wireless microphone for speech. It
incorporates a uni-directional electret condenser
microphone to minimize feedback, and a com-

pressor/expander system noise reduction circuit

to minimize the influence of high-frequency noise

generated f r o m digital equipment such as
personal computers and word processors.

FEATURES

Internal loop antenna.

Small size, light weight and high reliability.
Continuous operation for 12 hours or more on one
alkaline battery (LR6/1.5V).

Two battery indicators (green and red).

Internal I.D. signal generator for tone squelch.
Compressor/expander system noise reduction cir-

cuit.

USER PRECAUTIONS

Take care not to drop the unit on to a hard floor.

Do not flip nor blow into the microphone head.

Avoid placing the unit in areas of extremely high

humidity and temperature.
Never open the unit nor touch its internal compo-
nents.
Clean the unit's exterior periodically with a soft dry

cloth. If it gets very dirty, wipe first with a soft damp
cloth lightly soaked in a neutral detergent, and then
dry with a soft cloth.

Never use thinner, benzine, or other solvents, which
may damage plastic part of the unit.

Remove the battery if the unit is to be stored for two

weeks or more.

MICROPHONE GAIN CONTROL
Remove a battery to expose the control. Use

a

Philips screwdriver to adjust it. The sensitivity
increases as the control is rotated clockwise, and

decreases as rotated counterclockwise.

Usually

leave the control intact.

Gain control

TOA Corporation

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Plug the microphone cable into the transmitter

BATTERY LOADING Use LR6 type alkaline battery. 1. Remove the battery cover by sliding in the direction indicated by the arrow on the unit surface. (Fig. 1) Fig. 1 2. Observing correct polarity instructed inside the battery compartment, insert a battery. (Fig. 2) Fig. 2 3. Replace the cover. BATTERY ...

Page 3 - Squelch circuit; PART NAME

TIPS FOR CONVENIENT USE 1. To avoid feedback, use the microphone with your mouth put as close to the microphone top aspossible. 2. Adjust the tuner volume control to an appropriate volume level that prevents feedback. The system is prone to feedback if the microphone comes too close to the speaker. ...

Page 4 - TYPICAL FREQUENCY RESPONSE; FCC license requirement; SPECIFICATIONS; * S p e c i f i c a t i o n s are subject to change without notice.; TOA Corporation; Printed in Japan

TYPICAL FREQUENCY RESPONSE RELATIVE RESPONSE IN dB FREQUENCY IN HERTZ FCC license requirement The operation of the TOA wireless microphone sys-tems must conform with the rules and regulations contained in the code of Federal Regulations, 47, Telecommunications, Part 74 and Part 90. These regulations...

Other TOA Models

All TOA Other