TOA RS-232C - Manual
TOA RS-232C – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Channel Fader Gain -
- Page 3 – SERIAL PORT SETTING
- Page 4 – command is abandoned.; TRANSMISSION DATA AFTER COMMAND RECEPTION; No response; CONTROL COMMAND AND SETTING VALUE; Note: Command cannot be received during power off.
- Page 5 – See Channel Fader Gain - Position V/S Gain Table on the next page.; CHANNEL FADER GAIN - POSITION V/S GAIN TABLE
- Page 7 – See Channel Fader Gain – Step Up / Step Down Table on the next page.
- Page 8 – CHANNEL FADER GAIN – STEP UP / STEP DOWN TABLE
- Page 10 – CROSSPOINT GAIN TABLE
- Page 14 – TONE CONTROL GAIN POSITION TABLE; Note: 19H – 20H are deemed to be reserved.
- Page 18 – 1H: Low Pass Filter; HIGH PASS FILTER; Example: Setting the Input Channel 3’s High Pass Filter to 31.5 Hz.
- Page 19 – INPUT SENSITIVITY TABLE; Channel Name Request; Example: Acquiring the Input Channel 1’s name.
- Page 20 – Example: Responding with the Input Channel 1’s name “INPUT1.”; Table below shows ASCII codes used for Names.
- Page 21 – Speaker Preset Setting; SPEAKER PRESET TABLE; Function; Channel fader gain
- Page 23 – COMMUNICATION EXAMPLES
9000 Series Mixer/Amplifiers
RS-232C Protocol Manual
Ver.3.13 2007/04/05
Page 1 of 24
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TABLE OF CONTENTS Page# 1. SUMMARY…………………………………………………………………….... 3 2. SERIAL PORT SETTING…………………………………………………….... 3 3. COMMAND CONFIGURATION………………………………………………. 4 4. TRANSMISSION DATA AFTER COMMAND RECEPTION……………….. 4 5. CONTROL COMMAND AND SETTING VALUE……………………………. 5 5.1. Channel Fader Gain………………………...
1. SUMMARY The RS-232C protocol described in this document is designed to be used to control the 9000 Series Amplifier from a PC and/or remote controller. This specification applies to the 9000 Series firmware version 3.13 or later. Settings that can be controlled are as follows: • Channel fader gai...
• If a next command received contains byte data shorter than the Data length, the previous command is abandoned. 4. TRANSMISSION DATA AFTER COMMAND RECEPTION When normal data is received, the same data as the reception data is to be transmitted. Example: 91H, 03H, 00H, 00H, 00H (Reception data) 91H,...
