Page 2 - USE AND CARE MANUAL; HRD MODELS
PROFESSIONAL DUAL FUEL RANGES USE AND CARE MANUAL HRD MODELS HRD4803U/ULP | HRD3606U/ULP | HRD3088U/ULP
Page 3 - TABLE OF CONTENTS
1. Warnings ................................................................................................................................................... 4 2. Welcome ..................................................................................................................................
Page 5 - WARNINGS; SAFET Y WARNINGS; WARNING
WARNINGS These are the most critical warnings summarized below. • If the instructions in this manual are not followed exactly, a fire or explosion may result, causing property damage, personal injury or death. • Do not store or use gasoline or other flammable substances and liquids near this or othe...
Page 6 - WELCOME
WELCOME Thank you for purchasing your HRG dual fuel indoor range. We appreciate your business and we recommend that you read this entire User’s Manual before operating your new appliance for the first time. This manual contains instructions on how to properly install and set up your new range, as we...
Page 7 - CAUTION; SYMBOL
SAFET Y WARNINGS WARNING CAUTION CAUTION IMPORTANT SYMBOL DEFINITION SAFET Y SYMBOL S 6
Page 9 - EXPLOSION HA Z ARD
SAFET Y WARNINGS 1. Slide the range forward. 2. Install the anti-tip device as described in the instruction sheet 3. Safely tilt the front section of the range and slide the range slowly back against the wall. 4. The rear pins should slide under the bracket. 5. Do not use the appliance until it has ...
Page 11 - HOT SURFACE HA Z ARD
SAFET Y WARNINGS the directions of the cleaner manufacturer. • Never use this appliance as a space heater to heat or warm the room . Doing so may result in carbon monoxide poisoning. Failure to follow this advice may result in poisoning or death. HOT SURFACE HA Z ARD Accessible parts may become hot ...
Page 14 - DUAL R ANGE OVERVIEW; DUAL RANGE OVERVIEW; 8-inch dual range sample
DUAL R ANGE OVERVIEW DUAL RANGE OVERVIEW 48-inch dual range sample 12
Page 16 - COOK TOP EQUIPMENT; Dual fuel range cooktop burner equipment as below:
DUAL R ANGE OVERVIEW COOK TOP EQUIPMENT Dual fuel range cooktop burner equipment as below: 14
Page 17 - INSTALL ATION INSTRUCTIONS; IMPORTANT
INSTALL ATION INSTRUCTIONS Save the next two pages for the local electrical inspector’s use 1. A child or adult can tip the range and be killed. 2. Install the anti-tip device to the structure and/or the range. 3. Engage the range to the anti-tip device. 4. Re-engage the anti-tip device if the range...
Page 18 - POSITIONING OF R ANGE
INSTALL ATION INSTRUCTIONS • You may install a non-combustible material, such as tile, on the rear wall above the range and up the vent hood. • It is not necessary to install non-combustible materials behind the range below the counter top height. • DO NOT INSTALL CLOSER THAN 12 MM FROM ANY ADJACENT...
Page 19 - The range may be installed flush to the rear wall.
INSTALL ATION INSTRUCTIONS • The maximum depth of cabinets installed above cooking tops be 13 in (330mm). DIMENSIONS AND CLEAR ANCES • The depth of the range is 27 ½’’ (69.8 cm) overall. • The range may be installed flush to the rear wall. 17
Page 20 - 0” Dual Fuel Range Clearance
INSTALL ATION INSTRUCTIONS 30” Dual Fuel Range Clearance 18
Page 21 - 6” Dual Fuel Range Clearance
36” Dual Fuel Range Clearance INSTALL ATION INSTRUCTIONS 19
Page 22 - 8” Dual Fuel Range Clearance
INSTALL ATION INSTRUCTIONS 48” Dual Fuel Range Clearance 20
Page 23 - Top Hood and Cabinet Specifications
INSTALL ATION INSTRUCTIONS Top Hood and Cabinet Specifications 21
Page 29 - expose range terminal connection block.
ELECTRICAL CONNECTION Four Conductor Wire Connection to Range 1. Remove the screws at the lower end of the rear access cover and take it down to expose range terminal connection block. 2. Remove the screws to lose the cable clamp and pass through the four-conductor wire from the bottom of the range....
Page 32 - ELECTRICAL GROUNDING INSTRUCTIONS; grounded threepronged receptacle.; GAS SUPPLY REQUIREMENT; GA S SUPPLY REQUIREMENT
ELECTRICAL GROUNDING INSTRUCTIONS This indoor gas cooking appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded threepronged receptacle. Where a standard two-prong wall receptacle is encountered, it ...
Page 33 - CONNECT RANGE TO GAS SUPPLY
GA S SUPPLY REQUIREMENT The use of cabinets for storage above the appliance may result in a potential burn hazard. Combustible items may ignite; metallic items may become hot and cause burns. If a cabinet storage is to be provided, the risk can be reduced by installing a range hood that projects hor...
Page 34 - FIRST USE
FIRST USE Before you start 1. Make sure that the anti-tip of the range has been properly installed. 2. Find the model and serial numbers on the CSA label. Note these numbers down for future reference in the space provided in section “Warranty and service”. 3. Read this guide, taking special note of ...
Page 35 - oven when pulled forward.; POSITIONING THE SHELVES
FIRST USE Both the sides panel and shelves have safety stops to keep them from sliding out of the oven when pulled forward. Shelves also have a stop that prevents the shelves from hitting the back of the oven. POSITIONING THE SHELVES 32
Page 36 - Other shelves can be installed this way.; THIS IS HOW TO PROPERLY POSITION THE SHELVES:; Hold the front of both sides of the shelf
Lift the front about 15 degrees upward until the tag of the shelf clears the safety stop of the side rack. Then lower the shelf horizontally and slide all the way into the oven. Other shelves can be installed this way. THIS IS HOW TO PROPERLY POSITION THE SHELVES: Hold the front of both sides of the...
Page 37 - COOK TOP SAFET Y GUIDELINES; COOKTOP SAFETY GUIDELINES
COOK TOP SAFET Y GUIDELINES COOKTOP SAFETY GUIDELINES There are dual ring burners have the same low turn-down setting (SIM) for gentle simmering (680 BTU/hr.). Use the SIM setting for melting chocolate and butter, cooking rice and delicate sauces, simmering soups and stews, and keeping cooked food h...
Page 38 - to adjust the desired heat setting.; Simmer and Boil; other foods that need to cook over low heat for a long time.; SURFACE BURNER IGNITION
COOK TOP SAFET Y GUIDELINES To light the top burners, push and turn the appropriate control knob counter clockwise to the “HI” position. You will hear a clicking noise – the sound of the electric spark ig- niting the burner. Once burner ignition has been achieved, turn the burner control knob to adj...
Page 39 - Flame Height; minutes for any gas to dissipate. Repeat the lighting procedure.; COOKTOP; Any flame larger than the bottom of the cookware is wasted.
COOK TOP SAFET Y GUIDELINES Approximate 1 1/2” Flame Height POWER FAILURE If the gas does not ignite within four seconds, turn off the valve and allow at least five minutes for any gas to dissipate. Repeat the lighting procedure. Do not attempt to during power failure. COOKTOP The burners should be ...
Page 41 - burner control knob to adjust the desired heat setting.; BROIL BURNER USE; wise to the
COOK TOP SAFET Y GUIDELINES To light the oven burner, push and turn the appropriate control knob counter clockwise to the (150 F~500 F) position. You will hear a clicking noise, which is the sound of the electric spark igniting the burner. Once burner ignition has been achieved, turn the burner cont...
Page 42 - OVEN COOKING SAFETY GUIDELINES
OVEN COOKING SAFETY GUIDELINES • Do not block the ducts on the rear of the range when cooking in the oven. It is important that the flow of moist warm air from the oven and fresh air into the oven burner never be interrupted. Avoid touching the vent opening or nearby surfaces during oven or broiler ...
Page 43 - OVEN FUNCTION
OVEN FUNCTION OVEN FUNCTION NATURAL AIRFLOW BAKE Natural airflow bake occurs when heat is transferred into the oven from the bake burners in the bottom of the oven cavity. Heat is then circulated by natural airflow. This is a traditional bake setting. CONVECTION BAKE The oven convection fan circulat...
Page 44 - CONVECTION DEFROST; CONVECTION DEHYDRATION
The convection fan circulates heated air over and the around the food being roasted, sealing juices quickly for a moist and tender product while, at the same time, creating a rich golden brown exterior. Use the broil/roast pan and slotted grid supplied with the range when roasting to elevate the mea...
Page 45 - GRIDDLE OPER ATION; Broiler Operation; Door must be closed during broiler operation.; Preheating; from the high heat of the oven broiler.; DO NOT; use the broil pan without the insert.
GRIDDLE OPER ATION Broiler Operation Door must be closed during broiler operation. Broiling is a method of cooking tender cuts of meat directly under the infrared broiler in the oven. Broiling in the oven is accomplished with the oven door closed. It is normal and necessary for some smoke to be pres...
Page 46 - To set the oven to Broil:; Broiling guidelines; FOR THE MODELS WITH GRIDDLE; Use of the griddle
To set the oven to Broil: 1. Place the broiler pan insert on the broiler pan. Then place the food on the broiler pan insert. 2. Arrange the interior oven rack and place the broiler pan on the rack. Be sure to center the broiler pan and position directly under the broil burner. If preheating the broi...
Page 47 - CLEANING INSTRUCTIONS
GRIDDLE OPER ATION 3. When the griddle is preheated to the desired temperature, the indicator light will turn on. 4. Butter or cooking oil can may be added. • The surface of the griddle is hot after use. Please allow sufficient time for the griddle to cool prior to cleaning. • When using the applian...
Page 48 - Don’ts
Do not use aerosol cleaners until the range has completely cooled. The propellant substance in these cleaners could catch fire in the presence of heat. Do not let soiling or grease accumulate anywhere in or on the range. This will make future cleaning more difficult and may present a fire hazard. Do...
Page 51 - REPL ACING BURNER PARTS; REPLACING BURNER PARTS
REPL ACING BURNER PARTS REPLACING BURNER PARTS This diagram shows how to replace the burner parts. When replacing the burners, make sure that the two locating pins on the bottom of the brass flame spreader are properly aligned with the locating pin holes on the top of the simmer ring. Incorrect alig...
Page 52 - REMOVING OVEN DOOR; REPL ACING OVEN DOOR
Page 53 - REPLACING OVEN DOOR
Page 54 - the bulb to replace new light bulb.; REPLACING OVEN LIGHT BULB
REPL ACING OVEN DOOR When replace bulbs, release the glass cover on the lamp holder first, and then remove the bulb to replace new light bulb. REPLACING OVEN LIGHT BULB 51
Page 55 - PROCEDURE FOR CHECKING THE DUAL BURNER CLICKING PROBLEM
PROCEDURE FOR CHECKING THE DUAL BURNER CLICKING PROBLEM Step 1 Make sure the Burner Design is correct. Our current design for the burner is has the electrode on the left side (10 o’clock) and cross-over on the right side (2 o’clock). There are four parts for the dual burners. They are burner cap, fl...
Page 57 - HOW TO INSTALL KNOBS AND HANDLES FOR THOR KD MODELS
HOW TO INSTALL KNOBS AND HANDLES FOR THOR KD MODELS 54
Page 58 - Find the right knobs for each shaft on the range. Push the
HOW TO INSTALL KNOBS AND HANDLES FOR THOR KD MODELS For any parts damage or missing, please contact 877-288-809, or send email to [email protected] 3. Find the right knobs for each shaft on the range. Push the knob in to fully attach the shaft and make sure there’s no friction between knobs and beze...
Page 60 - Your Thor range might have a KD handle that needs to be
HOW TO INSTALL KNOBS AND HANDLES FOR THOR KD MODELS 4. Your Thor range might have a KD handle that needs to be installed. Please Follow up the following procedures for the oven door handle installation 4.1 Check your Installation Kits for Door Handles 2 * Handle Holders, 1 * Installation Wrench, 57
Page 61 - Connect door handle holders to each side of the handle
HOW TO INSTALL KNOBS AND HANDLES FOR THOR KD MODELS 1 * Handle (For 18”, 30” or 36” Oven) 4.2 Connect door handle holders to each side of the handle 4.3 Lay the door handle against to the oven door and fit it on the connection part, and use the wrench to get the door handle holder tight; 58
Page 62 - Use the wrench to tighten the door handle holders.; For Any installation Inquiries, please call Thor Customer
HOW TO INSTALL KNOBS AND HANDLES FOR THOR KD MODELS 4.4 Use the wrench to tighten the door handle holders. 5. Check if the oven door handle is level and stable. For Any installation Inquiries, please call Thor Customer Service Support # 877-288-8099, or email to [email protected] 59
Page 63 - TROUBLESHOOTING GUIDE
If you can’t find an answer to your problem in the chart below, or if the problem cannot be fixed, you will need technical help. Contact your Authorized Service Center or Customer Care. TROUBLESHOOTING GUIDE 60
Page 66 - Warranty and Service; For in-warranty service requests, please visit our website at
Warranty and Service This product has been manufactured by Thor Group, 4651 E Airport Drive, California 91761 For Customer Service, please call (877) 288 - 8099 For the most up to date warranty and service policy, please refer to our website WWW.THORKITCHEN.COM/WARRANTY-REGISTRATION For in-warranty ...
Page 67 - Rubber Pad Installation on Back Panel .; APPENDIX
2. Install the 2 rubber pat as showed above. To Prevent the range too close to the wall, there are 2 plastic pads offered with the user's manual, please find the accessories and follow the below steps: Rubber Pad Installation on Back Panel . APPENDIX 64
Page 68 - WARRANTY REGISTRATION; Register your product by following the steps below.; WARRANTY
WARRANTY REGISTRATION Scan theQR code or visit thorkitchen.com/warranty Input your product info and select register You’re done. Let’s get cookin’. You chose THOR Kitchen to enhance your culinary journey and we’re stoked to have you in the club. Think of it as a secret society of really savvy people...
