Tannoy I9 - Manual
Tannoy I9 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – CONTENTS
- Page 5 – ‘8 ohm’; Figure 4a; The i9 is fitted with 4-pole Neutrik Speakon
- Page 6 – Connectors should be wired with a minimum of 2.5 mm
- Page 7 – Figure 5b
- Page 10 – i9Y - Wall mount Bracket
- Page 11 – i9 MAB- Multiple Angle Bracket; for safety reasons that two threaded and correctly rated
- Page 12 – Description; DO NOT SHIP ANY PRODUCT TO TANNOY WITHOUT PREVIOUS AUTHORISATION
- Page 13 – Declaration of Conformity
B
i9
USER MANUAL
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
CONTENTS 1. Introduction 2. Unpacking 3. Low Impedance or 70.7/100V distributed line operation. 4. Amplification and Power Selection (Low Impedance Mode) 4.1 Connectors & Cabling for Low Impedance Operation 5. Voltage and Power Selection (Distributed Line Operation) 5.1 Connectors and Cabling fo...
Figure 4d : Series Parallel Combination: 8 Ω When operating in low impedance mode the rotary switch on the back of the cabinet as shown in Figure 4a , below should be set to ‘8 ohm’ Figure 4a 100V A 70V B D C 8ohm OFF Transformer Tappings AB D C 7.5W 15W30W60W 15W 60W 30W 4.1. Connectors & Cabli...
Cable choice consists mainly of selecting the correct cross sectional area in relation to the cable length and the load impedance. A small cross sectional area would increase the cables’ series resistance, inducing power loss and response variations (damping factor). Connectors should be wired with ...
