Tannoy I9 - Manuals - manualsarea.com

Page 2 - CONTENTS

CONTENTS 1. Introduction 2. Unpacking 3. Low Impedance or 70.7/100V distributed line operation. 4. Amplification and Power Selection (Low Impedance Mode) 4.1 Connectors & Cabling for Low Impedance Operation 5. Voltage and Power Selection (Distributed Line Operation) 5.1 Connectors and Cabling fo...

Page 5 - ‘8 ohm’; Figure 4a; The i9 is fitted with 4-pole Neutrik Speakon

Figure 4d : Series Parallel Combination: 8 Ω When operating in low impedance mode the rotary switch on the back of the cabinet as shown in Figure 4a , below should be set to ‘8 ohm’ Figure 4a 100V A 70V B D C 8ohm OFF Transformer Tappings AB D C 7.5W 15W30W60W 15W 60W 30W 4.1. Connectors & Cabli...

Page 6 - Connectors should be wired with a minimum of 2.5 mm

Cable choice consists mainly of selecting the correct cross sectional area in relation to the cable length and the load impedance. A small cross sectional area would increase the cables’ series resistance, inducing power loss and response variations (damping factor). Connectors should be wired with ...

Page 7 - Figure 5b

5.1 Connectors and Cabling for Distributed Line Operation Connections are identical to those used in low impedance mode, via the4-pole Neutrik Speakon  connectors (see section 4.1): Pin 1+ is Positive Pin 1- is Negative Distributed line systems are much more efficient in power transfer and do not r...

Page 10 - i9Y - Wall mount Bracket

11.2 i9Y - Wall mount Bracket Fig 3. Ï Ð Í Î The i9’s proximity to the wall can be adjusted to allow aiming of the loudspeaker in the horizontal plane (fig 4 & 5). Fig 5. Fig 4. The Main body of the bracket (1) should be fixed first to the wall in the desired location using all six fixing points...

Page 11 - i9 MAB- Multiple Angle Bracket; for safety reasons that two threaded and correctly rated

11.3 i9 MAB- Multiple Angle Bracket The i9 MAB is designed to provide a number of flexible mounting angles when the i9 is suspended from overhead cables. The i9 MAB is attached to the cabinet as shown with the supplied hex socket screws and washers supplied. Remove the original M10 counter sunk scre...

Page 12 - Description; DO NOT SHIP ANY PRODUCT TO TANNOY WITHOUT PREVIOUS AUTHORISATION

12. i9 Service Parts & Accessories Part Number Description 7900 0657 LF Driver Type 1277 7900 0674 High frequency Unit 7300 0853 Crossover Kit 8001 3020 i9Y - Wall mount Bracket (Black) 8001 3030 i9Y - Wall mount Bracket (White) 8001 3070 i9 MAB- Multiple Angle Bracket (Black) 8001 3080 i9 MAB- ...

Page 13 - Declaration of Conformity

14. Declaration of Conformity The following apparatus is/are manufactured in the United Kingdom by Tannoy Ltd of Rosehall Industrial estate, Coatbridge, Scotland, ML5 4TF and conform(s) to the protection requirements of the European Electromagnetic Compatibility Standards and Directives relevant to ...