Page 2 - C o n t e n t s; PDF created with FinePrint pdfFactory trial version
C o n t e n t s What You Get ............................................................................................................................................... 1 Product Layout .................................................................................................................
Page 3 - What You Get; Receiver; lis; Camera
What You Get • One Camera • One Monitor • Two Power Adapters • One Quick Installation Guide • This User's Manual Note: The AC adapters CANNOT be interchanged. Use only the adapter labeled OUTPUT: 9V DCwith the camera. Use only the adapter labeled OUTPUT: 13.5V DC with the monitor Receiver En g lis h...
Page 4 - Pr od uct La yo ut
Pr od uct La yo ut 8 7 6 5 9 4 3 1 2 Front View of Camera Rear View of Camera Bottom View of Camera 10 2 11 PDF created with FinePrint pdfFactory trial version www.pdffactory.com
Page 5 - Infrared LEDs; Lens; Lens Body; Channel Selection Switch
Pr od uct La yo ut Infrared LEDs Eight LEDs to provide infrared light for night vision. Lens Focuses image automatically without any adjustment. Lens Body Rotates up to 180 degrees. Microphone2.4 GHz Audio/Video Antenna (Front ) Transmits audio/video signals. Caution: Antenna does not rotate freely ...
Page 7 - Battery Compartment
Pr od uct La yo ut Volume/Power ControlScreen ON/OFF Screen can be turned off for audio monitoring only. Power Indicator LED13.5V Power Adapter PlugChannel Selection Dipswitches Select the channel by setting the channel dipswitch to the ON position. The number 5dipswitch sets the timer for the auto-...
Page 8 - Se tti ng Up
6 Se tti ng Up Before you make the connection: • Always make sure the unit ON/OFF switch is in the OFF position. • Set the channel switches on the back of the camera and monitor to the same channel. • If you wish to wall mount the camera, it is recommended that the receiver reception betested before...
Page 9 - Set ting U p-Cam era; P ow e r Su p pl y; Using AC Power
Set ting U p-Cam era P ow e r Su p pl y 1 The camera uses either batteries (AA-size) or household AC current. To Load Batteries Open the battery compartment cover. Slide the POWER Switch to the ON position. The LED on the back of the camera shouldlight. Never mix old batteries with new ones.Remove b...
Page 10 - C han g in g th e Le n s Or i en t ati o n
Set ting U p-Cam era 2 C han g in g th e Le n s Or i en t ati o n Place the camera in a convenient location, point the lens towards the observation area and adjustthe angle by rotating the lens body. The camera's auto focus feature automatically focuses theimage.The camera's head rotates horizontall...
Page 11 - S et ti ng U p- Mo ni to r
S et ti ng U p- Mo ni to r 1 P ow e r Su p pl y 9 The monitor uses either batteries (C-size) or household AC current. To Load Batteries Open the battery compartment cover in the direction of the arrow. Never mix old batteries with new ones.Remove batteries from the camera if you do not plan to use i...
Page 13 - Se tti ng Up -Ot her Ap pli ca tio ns; R ec or d in g on a VC R; N i gh t Vi si o n
Se tti ng Up -Ot her Ap pli ca tio ns 11 R ec or d in g on a VC R The monitor comes with Audio/Video output jacks forconnecting to a VCR for recording.Connect the audio/video cable ’ s white and yellow plugs to the white and yellow audio/aideo jacks of the monitorand to the white and yellow input ja...
Page 14 - Or ie nt ing U nit s fo r O pt im al Pe rfo rm an ce; A dj us t in g t he A u di o /Vid e o An t en nas
Or ie nt ing U nit s fo r O pt im al Pe rfo rm an ce P l ac i n g : Place the camera and monitor on a flat, stable surface to prevent damage from falling.For optimal performance, try to place the units as high as possible to avoid any possible interferencefrom people walking between the camera and m...
Page 15 - Auto-Sequence Function for Multiple Location Monitoring
The monitor's built in auto-sequence function is ideal for security use. The monitor can be used withup to four cameras on four different channels and display them in sequence on a single monitor. Themonitor's various operating modes are set via dipswitches as shown in the following diagram: Dipswit...
Page 17 - T r o u b l e s h o o t i n g
15 If you are not getting any signal at all • Check the power on the camera and monitor • Make sure power plugs are pushed all the way in • Check the CHANNEL switches on both camera and monitor are set to the same number • If the camera/monitor is powered by batteries, replace all batteries with new...
Page 18 - Ca re a nd M aint enan ce
Ca re a nd M aint enan ce • For best performance, don't touch the antennas unnecessarily • Keep all its parts and accessories out of young children's reach • Camera performances can be adversely affected by fingerprints or dirt on the lens surface. Avoidtouching the lens surface with your fingers. •...
Page 19 - S p e c i f ic a t i o n s
S p e c i f ic a t i o n s 17 Specifications are subject to change without notice. Frequency 2.4~2.4835 GHz Range 300 feet (100 meters) clear line of sight Antennas Directional circular-polarized antenna Channel 4 selectable channels AV mod/demod. method FM Image Sensor 1/4 ” CMOS image sensor Lens ...
Page 20 - S o m ma i r e; an
C o n t e n u d e l ’ e m b a ll a g e • Une Cam é ra • Un moniteur • Deux adaptateurs • Un guide d ’ installation rapide • Manuel de l ’ utilisateur Note: Les adaptateurs AC ne sont pas interchangeables. Vous ne pouvez utiliser l ’ adaptateur libell é SORTIE: 9V DC qu ’ avec la cam é ra. Vous ne po...
Page 21 - Il l u s t r a t i o n s
Il l u s t r a t i o n s 8 7 6 5 9 4 3 1 2 10 2 Vue de face de la cam é ra Vue arri è re de la cam é ra Vue de dessous de la cam é ra 11 PDF created with FinePrint pdfFactory trial version www.pdffactory.com
Page 25 - C o n f i g u r a t i o n; A l i m e nt at i o n
1 Ins é rer les piles Ouvrez le portillon du compartiment des piles dans le sens de la fl è che. Ne m é langez j amais des piles usag é es et des piles neuves. Retirez les piles de la cam é ra si vous ne comptez pas vous en servir pendant une longue p é riode. Utilisation de l ’ alimentation AC Bran...
Page 26 - C han g er l
C o n f i g u r a t i o n Placez le bouton d ’ ALIMENTATION sur la position Allum é . Le LED à l ’ arri è re de la cam é ra doit alors s ’ allumer. 2 C han g er l ’ o r i en t at i o n d e l ’ o bj e c ti f Placez la cam é ra dans un emplacement ad é quat, pointez l ’ objectif vers l ’ endroit à obs...
Page 28 - Utilisation de l
C o n f i g u r a t i o n 9 Branchez l ’ une des extr é mit é s de l ’ adaptateur de courant fourni dans une prise murale, et l ’ autre extr é mit é à l ’ arri è re du moniteur. Remarque: Les adaptateurs AC ne sont pas interchangeables, utilisez seulement l ’ adaptateur libell é SORTIE: 13.5V DC ave...
Page 30 - Vis io n d e N ui t
C o n f i g u r a t i o n Vis io n d e N ui t La cam é ra est é quip é e de huit LED de haute intensit é pour recueillir des images claires d ’ endroits non- é clair é s.Afin d ’ activer la fonction Vision de nuit, placez le bouton comme il est indiqu é dans l ’ illustration de droite. Note: En d é ...
Page 31 - A j us t e r l e s an t en n e s au d io / v id
Orientation des unit é s pour une performance optimale 12 E m pl ac e m en t : Placez la cam é ra et le moniteur sur une surface plate et stable pour é viter qu ’ ils ne tombent et qu ’ ils soient endommag é s. Pour une meilleure performance, efforcez-vous de placer les unit é s le plus haut possibl...
Page 32 - quence pour la surveillance de multiple e nd r o it s; Mode Configuration d
Fonction Auto-S é quence pour la surveillance de multiple e nd r o it s Note: Le moniteur d é tecte automatiquement les canaux de r é ception, et les affichera en s é quence. Lorsque seulement un seul bouton est sur la position Allum é , le moniteur re ç oit ce canal en continu, quelle que soit la p...
Page 33 - p a n na g e
D é p a n na g e 14 Si vous n ’ avez aucun signal • V é rifiez que la cam é ra et le moniteur sont sous tension. • Assurez-vous que les prises de courant sont enfonc é es jusqu ’ au bout. • V é rifiez que les s é lecteurs de canaux de la cam é ra et du moniteur sont configur é s sur le m ê me chiffr...
