Supermicro SSE-X24SR - Manual

Release: 1.0c 10 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   2.3 Management IP Address Note : The default management IP address for all Supermicro switch products is: 192.168.100.102 . Switch Management IP Interface SSE-G24-TG4 SSE-G48-TG4 The management IP address is conf...

Release: 1.0c 13 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   2.5 Interface MTU and Jumbo Frames The interface MTU can be changed in Layer2 Mgmt  Port Manager  Basic Settings page. The default MTU is 1500 bytes. The maximum MTU supported is 9202. The Supermicro switch MTU...

Release: 1.0c 16 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   Note: 1. Do not use the same switch ID for multiple switches on the stack. 2. All switches in the stack can only be configured through the master switch. 3. Make sure all stacked switches run the same version of ...

Release: 1.0c 18 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   2.9 Saving Configurations Switch configurations can be saved on the System Mgmt  File Management page. You can save a currently running switch configuration in one of three ways.  Save Startup Config – This opt...

Release: 1.0c 19 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   2.10 Upgrading Firmware Switch firmware can be upgraded in the System Mgmt  Firmware Upgrade page. Flash Area – The default selection is Normal to upgrade firmware in normal flash area. To upgrade firmware in th...

Release: 1.0c 20 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   2.11 Resetting to Factory Defaults Supermicro switches can be reset to factory defaults in the System Mgmt  System Settings page. This page has a button that you can press to allow a “Reset To Factory Defaults”....

Release: 1.0c 21 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   3 VLAN Configurations The SSE-G24-TG4, SSE-G48-TG4, SBM-GEM-X2C, SBM-GEM-X2C+ and SBM-GEM-X3S+ switches support 1024 static VLANs. The SSE-X24S, SSE-X24SR, SSE-X3348S, SSE-X3348SR, SSE-X3348T, SSE-X3348TR and SBM...

Release: 1.0c 23 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   4 Link Aggregation (LA) Link Aggregation (LA) is a method of combining multiple parallel physical connections into a single logical connection(trunk), thus allowing increased bandwidth for a particular network pa...

Release: 1.0c 26 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   4.3 Associating a Port Channel with Ports Once a port channel is created in the port channel page, it can be associated with the required physical ports. This can be done in the Layer2 Mgmt  LA  Port Settings p...

Release: 1.0c 27 / 27 Supermicro   Switch   Web   GUI   Quick   Configuration   Guide   4.4 Configuring Port Channel Parameters Once a port channel is created and associated with the required ports, you can configure the port channel parameters. If necessary configure the MTU of the port channel in ...